Skip to content
worldfires
AR · Argentina · –

Valle Fértil fire, 15 November 2017 Valle Fértil, Jáchal

Out · last detection 30 Nov 2017, 18:19 UTC

The fire started on 15 November 2017 in Valle Fértil, Argentina, and satellites saw it burning for 16 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 9,469 hectares from heat detections, spread across 2 municipalities.

It is the largest fire in San Juan since 2016 (of 15 with a page). Number 20 in Argentina in 2017, of 256.

Burnt area
9,469ha
GWIS perimeter (Copernicus)
Duration
16days
15 Nov 2017 – 30 Nov 2017
Municipalities hit
2
departments
Started on
15 Nov
2017
Heat detections
544
in a single hotspot: 132 MW
Danger at start
51
Extreme · FWI index
Average daily power
306MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 15 Nov30 Nov
30 Nov 2017

How it evolved, day by day

15 Nov 2017 · 42 MW · 5 16 Nov 2017 · 255 MW · 27 17 Nov 2017 · 350 MW · 57 18 Nov 2017 · 162 MW · 20 19 Nov 2017 · 262 MW · 43 20 Nov 2017 · 324 MW · 41 21 Nov 2017 · 152 MW · 35 22 Nov 2017 · 885 MW · 86 23 Nov 2017 · 1,190 MW · 67 24 Nov 2017 · 467 MW · 49 25 Nov 2017 · 209 MW · 28 26 Nov 2017 · 253 MW · 32 27 Nov 2017 · 169 MW · 26 28 Nov 2017 · 56 MW · 15 29 Nov 2017 · 110 MW · 11 30 Nov 2017 · 7 MW · 2
15 Nov 19 Nov 23 Nov 27 Nov

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

31°high
61km/h · peak gust
7%lowest humidity

It had gone 7 days without rain (1 mm or more) when it started. Rain came after the fire: 6.0 mm on 1 Dec.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

How big is it?

10 km
It burned the equivalent of 6% of the area of London (95 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Valle Fértil where it started
    8,662 ha reached on 15 Nov
    1.6 %
  2. 844 ha reached on 22 Nov
    0.1 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2015
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2015, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with Extreme FWI: 19 % of the area in Argentina Strong wind: 26 % of the area in Argentina Very dry air: 14 % of the area in Argentina

Day High Min. humidity Peak gust Rain Danger (FWI)
15 Nov 30.9 °C 10 % 61 km/h 0.0 mm Extreme 51
16 Nov 22.8 °C 13 % 44 km/h 0.0 mm High 35
17 Nov 26.9 °C 9 % 37 km/h 0.0 mm Very high 47
18 Nov 21.3 °C 14 % 38 km/h 0.2 mm High 29
19 Nov 26.3 °C 10 % 49 km/h 0.0 mm High 30
20 Nov 27.2 °C 10 % 51 km/h 0.3 mm Very high 44
21 Nov 23.3 °C 19 % 33 km/h 0.0 mm High 30
22 Nov 27.0 °C 15 % 43 km/h 0.0 mm High 35
23 Nov 31.3 °C 7 % 31 km/h 0.0 mm High 33
24 Nov 24.5 °C 17 % 29 km/h 0.1 mm Very high 42
25 Nov 26.0 °C 17 % 48 km/h 0.0 mm High 35
26 Nov 28.7 °C 14 % 48 km/h 0.0 mm Very high 42
27 Nov 23.6 °C 18 % 41 km/h 0.0 mm Very high 49
28 Nov 25.5 °C 27 % 60 km/h 0.0 mm Very high 41
29 Nov 29.2 °C 16 % 53 km/h 0.0 mm High 27
30 Nov 28.5 °C 19 % 53 km/h 0.0 mm High 29
1 Dec after 22.0 °C 33 % 43 km/h 6.0 mm Very low 3

Its twins: fires that started in the same weather

It started with an FWI of 51.3, a minimum humidity of 10% and 7 days without rain. Fires in the area that started in weather like this since 2016: 10.

FWI at the start 51.3
Minimum humidity 10 %
Days without rain 7
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Ayacucho fire, October 2017
1,553 ha 5 days FWI 50.0 Min. humidity 8 % 247 km away, in 2017

First rain (1 mm or more) after it ended: 1.7 mm on 11 Oct.

What happened to them

Fires in the area that started in similar weather: 10. With fewer than 15 we give no figures: they would be more noise than signal.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

6.0 mmfirst rain
1 Decthe day after it ended
61km/h · max. gust

It was considered over on 30 Nov, and on 1 Dec 6.0 mm fell. We do not know whether the rain or the firefighters put it out.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 8 Nov 2017
After · 7 Dec 2017

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 544Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Argentina

Frequently asked questions

How long did the Valle Fértil fire last?
GWIS (Copernicus) dates it between 15 November 2017 and 30 November 2017: 16 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 9,469 hectares (94.7 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Valle Fértil (8,662 ha, 1.6 %); Jáchal (844 ha, 0.1 %).
What was the weather like?
During the fire the temperature reached 31.3 °C, humidity dropped to 7 % and gusts hit 61 km/h. The fire danger index (FWI) reached 51, class Extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Argentina (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 911 · 100 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 911 · 100.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 544 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2015, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.