Skip to content
worldfires
ZA · South Africa · –

uMuziwabantu fire, July 2020 uMuziwabantu, Greater Kokstad

Out · last detection 25 Jul 2020, 23:40 UTC

The fire started on 23 July 2020 in uMuziwabantu, South Africa, and satellites saw it burning for 3 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 2,711 hectares from heat detections, spread across 2 municipalities.

It is the 74th largest in KwaZulu-Natal since 2016 (of 140 with a page). Number 49 in South Africa in 2020, of 95.

The power measured by the satellite is low (15.2 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
2,711ha
GWIS perimeter (Copernicus)
Duration
3days
23 Jul 2020 – 25 Jul 2020
Municipalities hit
2
municipalities
Started on
23 Jul
2020
Heat detections
102
in a single hotspot: 15 MW
Danger at start
39
Very high · FWI index
Average daily power
129MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 23 Jul25 Jul
25 Jul 2020

How it evolved, day by day

23 Jul 2020 · 77 MW · 23 24 Jul 2020 · 230 MW · 66 25 Jul 2020 · 79 MW · 13
23 Jul 24 Jul 25 Jul

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

22°high
27km/h · peak gust
10%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started. Rain came after the fire: 1.8 mm on 4 Aug.

This area had burned before

65% of the perimeter overlaps earlier fires recorded since 2016: 847 ha in 2017, 1,397 ha in 2019. Part of it burned more than once, so the yearly figures add up to more than the 1,774 ha that had burned before.

How big is it?

10 km
It burned the equivalent of 1.7% of the area of London (27 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. uMuziwabantu where it started
    2,701 ha reached on 23 Jul
    2.5 %
  2. 18 ha reached on 24 Jul
    0.0 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area0.10 ha
Residents< 20

Inside the perimeter there were about 0.10 hectares of built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with Very dry air: 37 % of the area in South Africa 60 days without rain: 10.0 % of the area in South Africa

Day High Min. humidity Peak gust Rain Danger (FWI)
23 Jul 20.3 °C 10 % 25 km/h 0.0 mm Very high 39
24 Jul 20.9 °C 12 % 27 km/h 0.0 mm Very high 43
25 Jul 21.5 °C 10 % 20 km/h 0.0 mm Very high 42
26 Jul after 20.3 °C 12 % 44 km/h 0.8 mm Very high 44
27 Jul after 14.1 °C 39 % 36 km/h 0.0 mm Moderate 16
28 Jul after 20.9 °C 17 % 31 km/h 0.0 mm High 38
29 Jul after 20.1 °C 19 % 35 km/h 0.0 mm High 37
30 Jul after 19.1 °C 18 % 38 km/h 0.0 mm Very high 42
31 Jul after 21.0 °C 14 % 25 km/h 0.0 mm Very high 38
1 Aug after 24.1 °C 4 % 27 km/h 0.0 mm Very high 48
2 Aug after 26.0 °C 7 % 24 km/h 0.0 mm Very high 44
3 Aug after 26.3 °C 4 % 34 km/h 0.0 mm Extreme 58
4 Aug after 24.5 °C 8 % 46 km/h 1.8 mm Extreme 61

Its twins: fires that started in the same weather

It started with an FWI of 38.9, a minimum humidity of 10% and more than two months without rain. Fires in the area that started in weather like this since 2016: 6.

FWI at the start 38.9
Minimum humidity 10 %
Days without rain 60+
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Dr Nkosazana Dlamini Zuma fire, August 2019
7,255 ha 3 days FWI 43.8 Min. humidity 7 % 110 km away, in 2019

First rain (1 mm or more) after it ended: none in the following ten days.

What happened to them

Fires in the area that started in similar weather: 6. With fewer than 15 we give no figures: they would be more noise than signal.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

1.8 mmfirst rain
4 Aug10 days after it ended
27km/h · max. gust

It was considered over on 25 Jul, and on 4 Aug 1.8 mm fell. We do not know whether the rain or the firefighters put it out.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 16 Jul 2020
After · 1 Aug 2020

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 102Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in South Africa

Frequently asked questions

How long did the uMuziwabantu fire last?
GWIS (Copernicus) dates it between 23 July 2020 and 25 July 2020: 3 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 2,711 hectares (27.1 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: uMuziwabantu (2,701 ha, 2.5 %); Greater Kokstad (18 ha, 0.0 %).
What was the weather like?
During the fire the temperature reached 21.5 °C, humidity dropped to 10 % and gusts hit 27 km/h. The fire danger index (FWI) reached 43, class Very high.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of South Africa (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 10177 · 112 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 10177 · 112.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 102 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.