Skip to content
worldfires
SD · Sudan · –

Um Dafoug fire, 18 December 2021 Um Dafoug

Out · last detection 27 Dec 2021, 11:45 UTC

The fire started on 18 December 2021 in Um Dafoug, Sudan, and satellites saw it burning for 10 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 2,460 hectares from heat detections, spread across a single municipality.

It is the 135th largest in South Darfur since 2016 (of 217 with a page). Number 94 in Sudan in 2021, of 149.

The power measured by the satellite is low (18.9 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
2,460ha
GWIS perimeter (Copernicus)
Duration
10days
18 Dec 2021 – 27 Dec 2021
Municipalities hit
1
localities
Started on
18 Dec
2021
Heat detections
59
in a single hotspot: 19 MW
Danger at start
66
Extreme · FWI index
Average daily power
29MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 18 Dec27 Dec
27 Dec 2021

How it evolved, day by day

18 Dec 2021 · 5 MW · 1 19 Dec 2021 · 31 MW · 3 20 Dec 2021 · 4 MW · 1 21 Dec 2021 · 15 MW · 4 22 Dec 2021 · 29 MW · 8 23 Dec 2021 · 141 MW · 24 24 Dec 2021 · 9 MW · 3 25 Dec 2021 · 23 MW · 6 26 Dec 2021 · 31 MW · 7 27 Dec 2021 · 6 MW · 2
18 Dec 20 Dec 23 Dec 26 Dec

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

34°high
49km/h · peak gust
8%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

How big is it?

10 km
It burned the equivalent of 1.6% of the area of London (25 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Um Dafoug where it started
    2,474 ha reached on 18 Dec
    0.5 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with Very dry air: 55 % of the area in Sudan 60 days without rain: 27 % of the area in Sudan

Day High Min. humidity Peak gust Rain Danger (FWI)
18 Dec 32.7 °C 12 % 44 km/h 0.0 mm Extreme 66
19 Dec 32.5 °C 13 % 41 km/h 0.0 mm Extreme 62
20 Dec 32.8 °C 11 % 44 km/h 0.0 mm Extreme 65
21 Dec 31.8 °C 11 % 49 km/h 0.0 mm Extreme 69
22 Dec 32.5 °C 10 % 46 km/h 0.0 mm Extreme 67
23 Dec 33.5 °C 8 % 42 km/h 0.0 mm Extreme 65
24 Dec 34.3 °C 11 % 41 km/h 0.0 mm Extreme 62
25 Dec 33.1 °C 11 % 44 km/h 0.0 mm Extreme 65
26 Dec 34.0 °C 11 % 38 km/h 0.0 mm Extreme 63
27 Dec 34.0 °C 11 % 41 km/h 0.0 mm Extreme 64
28 Dec after 34.6 °C 12 % 42 km/h 0.0 mm Extreme 65
29 Dec after 34.1 °C 13 % 42 km/h 0.0 mm Extreme 64
30 Dec after 34.3 °C 15 % 40 km/h 0.0 mm Extreme 60
31 Dec after 35.4 °C 13 % 34 km/h 0.0 mm Extreme 57
1 Jan after 35.9 °C 13 % 29 km/h 0.0 mm Extreme 52
2 Jan after 32.7 °C 14 % 42 km/h 0.0 mm Extreme 63
3 Jan after 30.8 °C 15 % 48 km/h 0.0 mm Extreme 65
4 Jan after 29.7 °C 12 % 44 km/h 0.0 mm Extreme 62
5 Jan after 31.7 °C 11 % 41 km/h 0.0 mm Extreme 59
6 Jan after 34.3 °C 11 % 39 km/h 0.0 mm Extreme 57

Its twins: fires that started in the same weather

It started with an FWI of 66.3, a minimum humidity of 12% and more than two months without rain. Fires in the area that started in weather like this since 2016: 19.

FWI at the start 66.3
Minimum humidity 12 %
Days without rain 60+
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Al Radoum fire, February 2025
2,575 ha 6 days FWI 65.8 Min. humidity 11 % 30 km away, in 2025

First rain (1 mm or more) after it ended: none in the following ten days.

What happened to them

7 days
median duration
2,575 ha
median area
100 %
went past 1,000 ha
—
rain at the end (median; 0 of 19 had it)

It burned an area similar to its twins (2,460 ha against a median of 2,575 ha) and lasted 10 days, against 7 days.

In none of them did 1 mm fall in the ten days after the end: they all went out without rain.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
49km/h · max. gust

It was considered over on 27 Dec, and not even 1 mm fell in the following ten days: it went out without rain. None of its 19 twins had rain when they ended.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 11 Dec 2021
After · 3 Jan 2022

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 59Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Sudan

Frequently asked questions

How long did the Um Dafoug fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 18 December 2021 to 27 December 2021 (10 days). The perimeter dates it from 21 December 2021 to 27 December 2021.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 2,460 hectares (24.6 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Um Dafoug (2,474 ha, 0.5 %).
What was the weather like?
During the fire the temperature reached 34.3 °C, humidity dropped to 8 % and gusts hit 49 km/h. The fire danger index (FWI) reached 69, class Extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Sudan (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 19. Their median duration was 7 days and their median area 2,575 ha; 100 % went past 1,000 ha. In none of them did 1 mm fall in the ten days after the end: they all went out without rain.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

History of this page · 1 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Start date: 21 December 2021 → 18 December 2021.

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 21 December 2021 to 27 December 2021. 59 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.