Skip to content
worldfires
TR · Türkiye · →

Uludere fire, 8 August 2020 Uludere

Out · last detection 9 Aug 2020, 09:39 UTC

The fire started on 8 August 2020 in Uludere, Türkiye, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 201 hectares from satellite imagery, spread across a single municipality.

It is the 118th largest in Şırnak since 2016 (of 192 with a page). Number 115 in Türkiye in 2020, of 212.

The power measured by the satellite is low (9.6 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
201ha
Copernicus perimeter
Duration
2days
8 Aug 2020 – 9 Aug 2020
Municipalities hit
1
districts
Started on
8 Aug
2020
Heat detections
7
in a single hotspot: 10 MW
Danger at start
44
Very high · FWI index
Average daily power
18MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 8 Aug9 Aug
9 Aug 2020

How it evolved, day by day

8 Aug 2020 · 32 MW · 6 9 Aug 2020 · 5 MW · 1
8 Aug 9 Aug

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

36°high
37km/h · peak gust
17%lowest humidity

It had gone 37 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Uludere 46,040 inhabitants · 15.8 km from the centre where it started
    201 ha reached on 8 Aug
    0.2 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Scrub and transitional woodland56 %
  • Broadleaved forest43 %
  • Other natural land1.0 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
8 Aug 36.2 °C 17 % 36 km/h 0.0 mm Very high 44
9 Aug 35.9 °C 18 % 37 km/h 0.0 mm Very high 45
10 Aug after 34.5 °C 25 % 51 km/h 0.0 mm Very high 46
11 Aug after 33.7 °C 25 % 39 km/h 0.0 mm Very high 42
12 Aug after 35.3 °C 24 % 37 km/h 0.0 mm Very high 42
13 Aug after 35.4 °C 23 % 40 km/h 0.0 mm Very high 42
14 Aug after 35.0 °C 20 % 41 km/h 0.0 mm Very high 44
15 Aug after 35.1 °C 25 % 31 km/h 0.0 mm Very high 41
16 Aug after 35.1 °C 23 % 45 km/h 0.1 mm Very high 45
17 Aug after 34.5 °C 17 % 42 km/h 0.0 mm Very high 45
18 Aug after 34.9 °C 19 % 38 km/h 0.0 mm Very high 43
19 Aug after 34.9 °C 16 % 38 km/h 0.0 mm Very high 43

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 1 Aug 2020
After · 16 Aug 2020

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 6 August 2020 the air beside the fire reached 23 µg/m³ of PM2.5. That day averaged 17: 1.1 times the WHO daily guideline (15).

PM2.5 peak23 µg/m³
Days over the guideline3 days
PM1042 µg/m³
6789101112
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 7Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Türkiye ›

Frequently asked questions

How long did the Uludere fire last?
Copernicus dates it between 8 August 2020 and 9 August 2020: 2 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 201 hectares (2.0 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Uludere (201 ha, 0.2 %).
Did the fire reach a town?
The fire started in Uludere and came within 15.8 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 36.2 °C, humidity dropped to 17 % and gusts hit 37 km/h. The fire danger index (FWI) reached 45, class Very high.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Türkiye (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 7 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.