Ubuyama fire, 25 March 2018 産山村 · Ubuyama, Aso
The fire started on 25 March 2018 in Ubuyama, Japan, and satellites saw it burning for 1 day. Copernicus’s global GWIS system rebuilt a burnt perimeter of 328 hectares from heat detections, spread across 2 municipalities.
It is the 50th largest in Kumamoto since 2016 (of 92 with a page). Number 10 in Japan in 2018, of 23.
The power measured by the satellite is low (5.4 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.
Compare with…
Suggestions: Aso · 2022Aso · 2026Aso · 2018Aso · 2025
- Burnt area
- 328ha
- GWIS perimeter (Copernicus)
- Duration
- 1day
- 25 Mar 2018 – 25 Mar 2018
- Municipalities hit
- 2
- municipalities
- Started on
- 25 Mar
- 2018
- Heat detections
- 6
- in a single hotspot: 5 MW
- Danger at start
- 1
- Very low · FWI index
- Average daily power
- 28MW
- detected power per day, on average
Where it burned
How it evolved, day by day
25 Mar 2018 · 28 MW · 6
Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.
The weather it burned in
It had gone 2 days without rain (1 mm or more) when it started.
This area had burned before
No earlier perimeters overlap this fire since 2016, when the satellite record begins.
What happened to each town
-
258 ha4.3 %
-
Aso 阿蘇市70 ha0.2 %
Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.
People and buildings inside the perimeter
GHSL 2020Inside the perimeter there were about 0.19 hectares of built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).
This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.
Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu
The weather day by day
ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.
Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
| Day | High | Min. humidity | Peak gust | Rain | Danger (FWI) |
|---|---|---|---|---|---|
| 25 Mar | 16.9 °C | 31 % | 35 km/h | 0.0 mm | Very low 1 |
| 26 Mar after | 18.0 °C | 26 % | 30 km/h | 0.0 mm | Very low 3 |
| 27 Mar after | 19.9 °C | 24 % | 27 km/h | 0.0 mm | Very low 5 |
| 28 Mar after | 20.9 °C | 29 % | 30 km/h | 0.0 mm | Low 6 |
| 29 Mar after | 21.3 °C | 29 % | 30 km/h | 0.0 mm | Low 6 |
| 30 Mar after | 18.6 °C | 30 % | 37 km/h | 0.0 mm | Low 7 |
| 31 Mar after | 20.3 °C | 38 % | 27 km/h | 0.0 mm | Low 6 |
| 1 Apr after | 22.0 °C | 40 % | 19 km/h | 0.0 mm | Low 7 |
| 2 Apr after | 22.8 °C | 41 % | 23 km/h | 0.2 mm | Low 8 |
| 3 Apr after | 23.7 °C | 35 % | 27 km/h | 0.0 mm | Low 8 |
| 4 Apr after | 20.9 °C | 48 % | 44 km/h | 0.0 mm | Low 8 |
Before and after, from space
Drag the line to compare the same ground before the fire and after it.
If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.
Detections table · 6Every satellite heat detection, one by one, with time, satellite, power and coordinates.
| Date and time | Satellite | FRP (MW) | Lat | Lon |
|---|
Other fires nearby
Frequently asked questions
- How long did the Ubuyama fire last?
- GWIS (Copernicus) dates it between 25 March 2018 and 25 March 2018: 1 day between the first and last heat detection of the perimeter.
- How much area did it burn?
- The perimeter GWIS (Copernicus) rebuilt from heat detections is 328 hectares (3.3 km²). It is an estimate: official national figures may differ.
- Which municipalities burned?
- The fire entered 2 municipalities: Ubuyama (258 ha, 4.3 %); Aso (70 ha, 0.2 %).
- What was the weather like?
- During the fire the temperature reached 16.9 °C, humidity dropped to 31 % and gusts hit 35 km/h. The fire danger index (FWI) reached 1, class Very low.
- Where does this data come from?
- From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Japan (geoBoundaries). It is not an official report.
Where to verify it
A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.
Emergency number: 119 · Emergency number and official warnings ›
Satellite cross-check
History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
No changes since 24 October 2026.
Does something look wrong on this page?
This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.
Report an error
How we know this
- Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
- Dates from the perimeter: the VIIRS detections inside it did not change them. 6 Suomi-NPP VIIRS detections on those dates.
- We have not matched this page with any official record.
- Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
- Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.
Where this data comes from
The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution-ShareAlike 2.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.