Skip to content
worldfires
JP · Japan · →

Ubuyama fire, 19 March 2017 産山村 · Ubuyama, Taketa, Minami Oguni

Out · last detection 19 Mar 2017, 05:04 UTC

The fire started on 19 March 2017 in Ubuyama, Japan, and satellites saw it burning for 1 day. Copernicus’s global GWIS system rebuilt a burnt perimeter of 264 hectares from heat detections, spread across 3 municipalities.

It is the 61th largest in Kumamoto since 2016 (of 92 with a page). Number 9 in Japan in 2017, of 13.

The power measured by the satellite is low (22.7 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
264ha
GWIS perimeter (Copernicus)
Duration
1day
19 Mar 2017 – 19 Mar 2017
Municipalities hit
3
municipalities
Started on
19 Mar
2017
Heat detections
6
in a single hotspot: 23 MW
Danger at start
3
Very low · FWI index
Average daily power
83MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 19 Mar19 Mar

How it evolved, day by day

19 Mar 2017 · 83 MW · 6

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

14°high
35km/h · peak gust
28%lowest humidity

It had gone 4 days without rain (1 mm or more) when it started. Rain came after the fire: 21.4 mm on 20 Mar.

This area had burned before

50% of the perimeter overlaps earlier fires recorded since 2016: 132 ha in 2016.

What happened to each town

  1. Ubuyama 産山村 where it started
    237 ha
    3.9 %
  2. Taketa 竹田市
    23 ha
    0.0 %
  3. Minami Oguni 南小国町
    5 ha
    0.0 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2015
Built-up area0.63 ha
Residents≈ 20

Inside the perimeter there were about 0.63 hectares of built-up land and about 20 residents (GHSL 2015, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
19 Mar 13.7 °C 28 % 35 km/h 0.0 mm Very low 3
20 Mar after 8.9 °C 44 % 44 km/h 21.4 mm Very low 0

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 12 Mar 2017
After · 26 Mar 2017

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 6Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Japan ›

Frequently asked questions

How long did the Ubuyama fire last?
GWIS (Copernicus) dates it between 19 March 2017 and 19 March 2017: 1 day between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 264 hectares (2.6 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 3 municipalities: Ubuyama (237 ha, 3.9 %); Taketa (23 ha, 0.0 %); Minami Oguni (5 ha, 0.0 %).
What was the weather like?
During the fire the temperature reached 13.7 °C, humidity dropped to 28 % and gusts hit 35 km/h. The fire danger index (FWI) reached 3, class Very low.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Japan (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 119 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 119.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 6 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2015, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology ›

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution-ShareAlike 2.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.