Skip to content
worldfires
US · United States · →

Twelve Fire, August 2025 Moffat

Out · last detection 7 Aug 2025, 10:09 UTC

The fire started on 6 August 2025 in Moffat, United States, and satellites saw it burning for 1 day. United States agencies (MTBS / NIFC) mapped an official burnt perimeter of 1,735 hectares, spread across a single county.

It is the 71th largest in Colorado since 2016 (of 167 with a page). Number 149 in United States in 2025, of 327.

The power measured by the satellite is low (3.3 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
1,735ha
official perimeter (MTBS / NIFC)
Duration
1day
6 Aug 2025 – 6 Aug 2025
Municipalities hit
1
counties
Started on
6 Aug
2025
Heat detections
20
in a single hotspot: 3 MW
Danger at start
75
Very extreme · FWI index
Energy released
37MW
sum of detected power

Where it burned

HOTSPOTS BY DAY 6 Aug6 Aug

How it evolved, day by day

7

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

33°high
63km/h · peak gust
6%lowest humidity

It had gone 32 days without rain (1 mm or more) when it started.

This area had burned before

38% of the perimeter overlaps earlier fires recorded since 2016: 659 ha in 2017.

What happened to each town

  1. Moffat where it started
    1,733 ha reached on 7 Aug
    0.1 %

Burnt area inside each county, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
6 Aug 32.8 °C 6 % 52 km/h 0.0 mm Very extreme 75
7 Aug after 32.9 °C 7 % 63 km/h 0.0 mm Very extreme 85
8 Aug after 29.7 °C 9 % 59 km/h 0.0 mm Very extreme 71
9 Aug after 26.2 °C 4 % 35 km/h 0.0 mm Extreme 59
10 Aug after 26.7 °C 6 % 37 km/h 0.0 mm Extreme 63
11 Aug after 29.0 °C 14 % 37 km/h 0.0 mm Extreme 55
12 Aug after 31.8 °C 10 % 25 km/h 0.0 mm Very high 48
13 Aug after 34.0 °C 6 % 37 km/h 0.0 mm Extreme 58
14 Aug after 32.0 °C 9 % 35 km/h 0.0 mm Extreme 60
15 Aug after 29.2 °C 18 % 45 km/h 0.0 mm Extreme 57
16 Aug after 27.7 °C 19 % 43 km/h 0.5 mm Extreme 52
17 Aug after 29.0 °C 13 % 41 km/h 0.0 mm Very high 48

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 30 Jul 2025
After · 13 Aug 2025

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 6 August 2025 the air beside the fire reached 64 µg/m³ of PM2.5. That day averaged 24: 1.6 times the WHO daily guideline (15).

PM2.5 peak64 µg/m³
Days over the guideline1 day
PM1070 µg/m³
Optical depth0.32
456789
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 20Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in United States ›

Frequently asked questions

How long did the Twelve fire last?
It burned between 6 August 2025 and 6 August 2025: 1 day, according to the start date recorded by United States agencies (MTBS / NIFC) and the heat detections seen by satellite.
How much area did it burn?
The official perimeter published by United States agencies (MTBS / NIFC) is 1,735 hectares (17.4 km²). Other tallies, such as daily incident reports, may give slightly different figures.
Which counties burned?
The fire only entered Moffat (1,733 ha, 0.1 %).
What was the weather like?
During the fire the temperature reached 32.9 °C, humidity dropped to 6 % and gusts hit 63 km/h. The fire danger index (FWI) reached 85, class Very extreme.
Where does this data come from?
From the official burnt perimeter of United States agencies (MTBS / NIFC, public domain), NASA FIRMS VIIRS hotspots and the administrative boundaries of United States. It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 911

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 911.

Where this data comes from

The perimeter is official and in the public domain. For past years it comes from MTBS (Monitoring Trends in Burn Severity), run by the U.S. Geological Survey and the USDA Forest Service, which map it on Landsat and Sentinel-2 imagery. For the current and last year it comes from WFIGS at the National Interagency Fire Center (NIFC): incident perimeters mapped by fire crews, aircraft and imagery. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. County boundaries come from geoBoundaries ADM2 (Public Domain). The area per county is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from official figures.