Skip to content
worldfires
RO · Romania · →

Topleț fire, September 2026 Topleț

Out · last detection 10 Oct 2026, 00:30 UTC

The fire started on 29 September 2026 in Topleț, Romania, and satellites saw it burning for 12 days. Copernicus mapped a burnt perimeter of 477 hectares from satellite imagery, spread across a single municipality.

It is the 31th largest in Caraș-Severin since 2016 (of 196 with a page). Number 7 in Romania in 2026, of 59.

The power measured by the satellite is low (10.0 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
477ha
Copernicus perimeter
Duration
≈ 12days
29 Sept 2026 – 10 Oct 2026
Municipalities hit
1
municipalities
Started on
29 Sept
2026
Heat detections
33
in a single hotspot: 10 MW
Danger at start
20
Moderate · FWI index
Average daily power
15MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 29 Sept10 Oct
10 Oct 2026

How it evolved, day by day

29 Sept 2026 · 0 MW · 0 3 Oct 2026 · 0 MW · 0 4 Oct 2026 · 2 MW · 1 5 Oct 2026 · 9 MW · 7 6 Oct 2026 · 14 MW · 10 7 Oct 2026 · 21 MW · 9 8 Oct 2026 · 28 MW · 6 10 Oct 2026 · 0 MW · 0
29 Sept 4 Oct 6 Oct 8 Oct

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

23°high
37km/h · peak gust
15%lowest humidity

It had gone 5 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Topleț 2,246 inhabitants · 1.9 km from the centre where it started
    477 ha reached on 29 Sept
    5.1 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Broadleaved forest100 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

People and buildings inside the perimeter

GHSL 2025
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2025, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned. The GHSL 2025 epoch is a projection made from 2020 and earlier data.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
29 Sept 20.6 °C 38 % 27 km/h 0.0 mm Moderate 20
30 Sept 18.9 °C 34 % 37 km/h 0.0 mm High 23
1 Oct 17.7 °C 33 % 35 km/h 0.0 mm High 22
2 Oct 18.6 °C 30 % 26 km/h 0.0 mm Moderate 20
3 Oct 18.5 °C 30 % 25 km/h 0.0 mm Moderate 20
4 Oct 21.4 °C 16 % 24 km/h 0.0 mm High 25
5 Oct 23.4 °C 15 % 26 km/h 0.0 mm High 29
6 Oct 23.1 °C 18 % 21 km/h 0.0 mm High 28
7 Oct 22.0 °C 17 % 30 km/h 0.0 mm High 32
8 Oct 21.5 °C 25 % 30 km/h 0.0 mm High 30
9 Oct 21.4 °C 40 % 43 km/h 0.3 mm High 28

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 22 Sept 2026
After · 17 Oct 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 8 October 2026 the air beside the fire reached 96 µg/m³ of PM2.5. That day averaged 45: 3.0 times the WHO daily guideline (15).

PM2.5 peak96 µg/m³
Days over the guideline2 days
PM10122 µg/m³
Optical depth0.28
2728293012345678
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 33Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Romania ›

Frequently asked questions

How long did the Topleț fire last?
The official perimeter only gives the start date (4 October 2026). The end comes from the heat detections inside the perimeter: it burned until 10 October 2026 (12 days from 29 September 2026), the last day with detections before more than 10 days in a row without any, so it is approximate.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 477 hectares (4.8 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Topleț (477 ha, 5.1 %).
Is the Topleț fire still active?
No fire detections since 10 Oct 2026, 00:30 UTC. A lack of detections is not an official extinction.
Did the fire reach a town?
The fire started in Topleț and came within 1.9 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 23.4 °C, humidity dropped to 15 % and gusts hit 37 km/h. The fire danger index (FWI) reached 32, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Romania (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • The official perimeter has no end date: the end is the last day with VIIRS detections inside the perimeter before a gap of more than 10 days (150 days at most), so it is approximate. 33 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2025, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.