Skip to content
worldfires
US · United States · →

Top Fire, June 2024 Gila

Out · last detection 9 Jun 2024, 20:37 UTC

The fire started on 8 June 2024 in Gila, United States, and satellites saw it burning for 1 day. United States agencies (MTBS / NIFC) mapped an official burnt perimeter of 1,364 hectares, spread across a single county.

It is the 172th largest in Arizona since 2016 (of 380 with a page). Number 180 in United States in 2024, of 371.

The power measured by the satellite is low (9.8 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
1,364ha
official perimeter (MTBS / NIFC)
Duration
1day
8 Jun 2024 – 8 Jun 2024
Municipalities hit
1
counties
Started on
8 Jun
2024
Heat detections
13
in a single hotspot: 10 MW
Danger at start
65
Extreme · FWI index
Energy released
54MW
sum of detected power

Where it burned

9 Jun 2024
HOTSPOTS BY DAY 8 Jun8 Jun

How it evolved, day by day

89

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

37°high
48km/h · peak gust
8%lowest humidity

It had gone 22 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Gila where it started
    1,359 ha reached on 8 Jun
    0.1 %

Burnt area inside each county, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
8 Jun 36.9 °C 8 % 48 km/h 0.0 mm Extreme 65
9 Jun after 35.2 °C 9 % 32 km/h 0.0 mm Extreme 52
10 Jun after 36.6 °C 10 % 33 km/h 0.0 mm Extreme 55
11 Jun after 40.0 °C 6 % 34 km/h 0.0 mm Extreme 57
12 Jun after 40.6 °C 7 % 42 km/h 0.0 mm Extreme 64
13 Jun after 38.8 °C 8 % 52 km/h 0.0 mm Extreme 68
14 Jun after 36.8 °C 7 % 40 km/h 0.0 mm Extreme 64
15 Jun after 39.3 °C 7 % 42 km/h 0.0 mm Extreme 63
16 Jun after 38.7 °C 7 % 48 km/h 0.0 mm Extreme 68
17 Jun after 37.0 °C 7 % 57 km/h 0.0 mm Very extreme 76
18 Jun after 35.3 °C 11 % 42 km/h 0.0 mm Extreme 60
19 Jun after 36.7 °C 15 % 43 km/h 0.0 mm Extreme 58
20 Jun after 37.8 °C 25 % 71 km/h 0.7 mm Extreme 60

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 1 Jun 2024
After · 15 Jun 2024

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 10 June 2024 the air beside the fire reached 10 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak10 µg/m³
Days over the guideline0 days
PM1045 µg/m³
Optical depth0.27
67891011
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 13Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in United States ›

Frequently asked questions

How long did the Top fire last?
It burned between 8 June 2024 and 8 June 2024: 1 day, according to the start date recorded by United States agencies (MTBS / NIFC) and the heat detections seen by satellite.
How much area did it burn?
The official perimeter published by United States agencies (MTBS / NIFC) is 1,364 hectares (13.6 km²). Other tallies, such as daily incident reports, may give slightly different figures.
Which counties burned?
The fire only entered Gila (1,359 ha, 0.1 %).
What was the weather like?
During the fire the temperature reached 36.9 °C, humidity dropped to 8 % and gusts hit 48 km/h. The fire danger index (FWI) reached 65, class Extreme.
Where does this data come from?
From the official burnt perimeter of United States agencies (MTBS / NIFC, public domain), NASA FIRMS VIIRS hotspots and the administrative boundaries of United States. It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 911

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 911.

Where this data comes from

The perimeter is official and in the public domain. For past years it comes from MTBS (Monitoring Trends in Burn Severity), run by the U.S. Geological Survey and the USDA Forest Service, which map it on Landsat and Sentinel-2 imagery. For the current and last year it comes from WFIGS at the National Interagency Fire Center (NIFC): incident perimeters mapped by fire crews, aircraft and imagery. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. County boundaries come from geoBoundaries ADM2 (Public Domain). The area per county is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from official figures.