The fire started on 8 June 2023 in Tomatlán, Mexico, and satellites saw it burning for 15 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 2,455 hectares from heat detections, spread across a single municipality.
It is the 123th largest in Jalisco since 2016 (of 267 with a page). Number 134 in Mexico in 2023, of 285.
matches the official recordwith caveatssatellite onlymodel
When copying, the sentence is
Tick the figures you want: they make up the lede and the CSV.
Burned area
with caveats
2,455ha
Perimeter published by GWIS (Copernicus).
This page2,455CONAFOR1,417
Source
GWIS (Copernicus)
Date
8 Jun 2023 – 22 Jun 2023
+− cross-check
CONAFOR: 1,417 ha (matched records: 1). Difference between the page and the official record: +73.3%. Matched on 15 November 2026. The two figures differ a lot, so these may not be exactly the same fire: take them as nearby records.
Duration by satellite
satellite only
15days
8 Jun 2023 to 22 Jun 2023: first and last day with fire on the page.
Source
GWIS (Copernicus) · NASA FIRMS · VIIRS
Date
last detection: 22 Jun 2023, 08:02 UTC
+− cross-check
Satellites pass a few times a day and cloud or smoke can hide the fire: a lack of detections is not an official extinction. Each country’s emergency service declares a fire contained or out.
Start
satellite only
8 Jun 2023
First day with fire seen by the satellites or the perimeter.
Source
GWIS (Copernicus) · NASA FIRMS · VIIRS
Date
8 Jun 2023
+− cross-check
The two figures differ a lot, so these may not be exactly the same fire: take them as nearby records.
Hotspots
satellite only
157
VIIRS detections at 375 m. Most intense hotspot: 60 MW.
Source
NASA FIRMS · VIIRS (Suomi NPP)
Date
8 Jun 2023 – 22 Jun 2023
+− cross-check
There is no official record to compare with. Each hotspot is a pixel detected in one satellite pass, not a separate fire.
The worst day
satellite only
92MW
Total radiative power on 11 June 2023; hotspots that day: 10.
Source
NASA FIRMS · VIIRS (FRP)
Date
11 Jun 2023
+− cross-check
Fire radiative power (FRP) measures the energy the fire gives off when the satellite passes. Added up by day, it compares intensity, not area.
Danger at the start
model
20.4FWI · moderate
Fire Weather Index (Canadian system) computed by WorldFires for the day the fire started. Consecutive days without rain before: 60.
This is an index computed from weather model data, not a measurement of the fire nor an official warning. Danger warnings are issued by each country’s authority. Emergency number and official warnings ›
Weather during the fire
model
30.1°C · 55% RH
High of 30.1 °C and minimum humidity of 55% on 20 June 2023; gusts of 42 km/h on 15 June 2023.
These are model values for a cell of about 25 km, not from a weather station: they may differ from what was measured on the ground.
ⓘThis page’s change log has been kept since 24 October 2026: every night what it publishes is compared and the difference is logged. Anything earlier is reconstructed from each source’s date and marked as reconstructed.
Show
· reconstructedofficial
Matched with the official CONAFOR record
Nearby records with very different figures: 1,417 ha (records: 1).
A version keeps the area, dates, name and official record; the area as it was logged (changes under 2% are not logged). The map, hotspots and weather always show today’s data.
Citation
A lede of about 60 words figures only, no adjectives
Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.
The weather it burned in
30°high
42km/h · peak gust
44%lowest humidity
It had gone more than two months without rain (1 mm or more) when it started. Rain came after the fire: 7.2 mm on 26 Jun.
This area had burned before
32% of the perimeter overlaps earlier fires recorded since 2016: 421 ha in 2016, 206 ha in 2019, 493 ha in 2021. Part of it burned more than once, so the yearly figures add up to more than the 793 ha that had burned before.
How big is it?
It burned the equivalent of 1.6% of the area of London (25 km² against 1,583 km²).
London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).
It burned the equivalent of 23% of the area of Paris (25 km² against 105 km²).
Paris boundary: geoBoundaries · Institut national de l'information géographique et forestière (IGN-F) (Etalab Open License 2.0).
It burned the equivalent of 4.1% of the area of Madrid (25 km² against 604 km²).
Madrid boundary: geoBoundaries · Open Data ESRI, IGN Central Registry of Cartography Area (CC BY 4.0).
It burned the equivalent of 2.8% of the area of Berlin (25 km² against 892 km²).
Berlin boundary: geoBoundaries · Federal Agency for Cartography and Geodesy (dl-de/by-2-0).
Fire perimeterLondon
This compares size, not location: both shapes are at the same scale, north up, centred on each other.
Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.
People and buildings inside the perimeter
GHSL 2025
Built-up area0.23ha
Residents< 20
Inside the perimeter there were about 0.23 hectares of built-up land and almost nobody lived there (GHSL 2025, satellite-based estimate).
This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned. The GHSL 2025 epoch is a projection made from 2020 and earlier data.
According to CONAFOR, this fire started on 10 June 2023 and burned 1,417 ha (the satellite measured 2,455 ha). The two figures differ a lot, so these may not be exactly the same fire: take them as nearby records.
TomatlánPuerta Del Carrizalillo10 June 20231,417 ha· extinguished on 18 June 2023· cause: unknown
ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.
Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
It started with an FWI of 20.4, a minimum humidity of 59% and more than two months without rain. Fires in the area that started in weather like this since 2016: 17.
FWI at the start20.4
Minimum humidity59 %
Days without rain60+
this firechosen twinsrest of the area
Almost identicalSimilar
Outlines of the closest twins
This fire · Tomatlán fire, 8 June 2023
2,455 ha15 daysFWI 20.4Min. humidity 59 %
Cuautitlán de García Barragán fire, May 2024
4,357 ha25 daysFWI 19.5Min. humidity 59 %108 km away, in 2024
First rain (1 mm or more) after it ended: none in the following ten days.
It burned an area similar to its twins (2,455 ha against a median of 1,913 ha) and lasted 15 days, against 13 days.
In 12 of 17, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.0 mm.
This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it
How it ended
7.2 mmfirst rain
26 Jun4 days after it ended
42km/h · max. gust
It was considered over on 22 Jun, and on 26 Jun 7.2 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 5 of 17, with a median of 3.0 mm.
Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
How a twin is chosen
Same area: fires that have already ended, less than 250 km from this one, since 2016.
Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
They are sorted by similarity, and the outlines of the first five are drawn.
Drag the line to compare the same ground before the fire and after it.
↔
Before · 1 Jun 2023
After · 29 Jun 2023
Sentinel-2 did not pass over on that day. Try another date, or use false colour, which is daily.
If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.
The smoke
CAMS · Copernicus
On 22 June 2023 the air beside the fire reached 72 µg/m³ of PM2.5. That day averaged 39: 2.6 times the WHO daily guideline (15).
PM2.5 peak72µg/m³
Days over the guideline19days
PM10103µg/m³
Optical depth1.23
WHO 15
6 Jun10 Jun14 Jun18 Jun22 Jun
GoodFairModeratePoorVery poorExtremely poor
Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.
Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)
Detections table· 157Every satellite heat detection, one by one, with time, satellite, power and coordinates.›
⬇ Download CSVTimes in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
GWIS (Copernicus) dates it between 8 June 2023 and 22 June 2023: 15 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 2,455 hectares (24.6 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Tomatlán (2,468 ha, 0.8 %).
What was the weather like?
During the fire the temperature reached 30.1 °C, humidity dropped to 44 % and gusts hit 42 km/h. The fire danger index (FWI) reached 30, class High.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Mexico (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 17. Their median duration was 13 days and their median area 1,913 ha; 100 % went past 1,000 ha. In 12 of 17, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.0 mm.
Where to verify it
A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.
This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.
⚑Report an errorHow we know this›
Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
Dates from the perimeter: the VIIRS detections inside it did not change them. 157 Suomi-NPP VIIRS detections on those dates.
Compared with CONAFOR: 1,417 official ha against 2,455 ha of perimeter; similar, but with reservations.
Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2025, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.
The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.