Skip to content
worldfires
VE · Venezuela · →

Tinaco fire, February 2025 Tinaco

Out · last detection 7 Feb 2025, 17:53 UTC

The fire started on 2 February 2025 in Tinaco, Venezuela, and satellites saw it burning for 6 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 2,184 hectares from heat detections, spread across a single municipality.

It is the 105th largest in Cojedes since 2016 (of 219 with a page). Number 59 in Venezuela in 2025, of 139.

The power measured by the satellite is low (21.4 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
2,184ha
GWIS perimeter (Copernicus)
Duration
6days
2 Feb 2025 – 7 Feb 2025
Municipalities hit
1
municipalities
Started on
2 Feb
2025
Heat detections
57
in a single hotspot: 21 MW
Danger at start
39
Very high · FWI index
Average daily power
66MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 2 Feb7 Feb
7 Feb 2025

How it evolved, day by day

2 Feb 2025 · 16 MW · 3 3 Feb 2025 · 43 MW · 9 4 Feb 2025 · 25 MW · 6 5 Feb 2025 · 183 MW · 18 6 Feb 2025 · 106 MW · 18 7 Feb 2025 · 24 MW · 3
2 Feb 3 Feb 4 Feb 5 Feb 6 Feb 7 Feb

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

38°high
34km/h · peak gust
23%lowest humidity

It had gone 3 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

How big is it?

10 km
It burned the equivalent of 1.4% of the area of London (22 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Tinaco 32,564 inhabitants where it started
    2,199 ha reached on 2 Feb
    2.0 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2025
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2025, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned. The GHSL 2025 epoch is a projection made from 2020 and earlier data.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
3 Feb 36.6 °C 24 % 34 km/h 0.0 mm Very high 39
4 Feb 37.2 °C 28 % 31 km/h 0.0 mm Very high 40
5 Feb 37.7 °C 27 % 32 km/h 0.0 mm Very high 40
6 Feb 37.0 °C 27 % 34 km/h 0.0 mm Very high 41
7 Feb 38.1 °C 23 % 34 km/h 0.0 mm Very high 42
8 Feb after 37.9 °C 26 % 32 km/h 0.0 mm Very high 40
9 Feb after 38.0 °C 24 % 40 km/h 0.0 mm Very high 46
10 Feb after 37.6 °C 25 % 36 km/h 0.0 mm Very high 45
11 Feb after 37.1 °C 25 % 47 km/h 0.0 mm Very high 43
12 Feb after 36.7 °C 23 % 37 km/h 0.0 mm Very high 42
13 Feb after 37.2 °C 22 % 34 km/h 0.0 mm Very high 46
14 Feb after 38.3 °C 25 % 42 km/h 0.0 mm Very high 48
15 Feb after 37.2 °C 21 % 40 km/h 0.0 mm Very high 47
16 Feb after 37.6 °C 25 % 31 km/h 0.0 mm Very high 43
17 Feb after 38.3 °C 25 % 37 km/h 0.0 mm Very high 48

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 26 Jan 2025
After · 14 Feb 2025

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 2 February 2025 the air beside the fire reached 19 µg/m³ of PM2.5. That day averaged 16: 1.1 times the WHO daily guideline (15).

PM2.5 peak19 µg/m³
Days over the guideline1 day
PM1030 µg/m³
Optical depth0.34
3112345678910
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 57Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Venezuela ›

Frequently asked questions

How long did the Tinaco fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 2 February 2025 to 7 February 2025 (6 days). The perimeter dates it from 3 February 2025 to 7 February 2025.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 2,184 hectares (21.8 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Tinaco (2,199 ha, 2.0 %).
What was the weather like?
During the fire the temperature reached 38.1 °C, humidity dropped to 23 % and gusts hit 34 km/h. The fire danger index (FWI) reached 42, class Very high.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Venezuela (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 911 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 911.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 3 February 2025 to 7 February 2025. 57 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2025, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology ›

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.