Skip to content
worldfires
RO · Romania · →

Ticvaniu Mare fire, November 2018 Ticvaniu Mare, Forotic

Out · last detection 5 Nov 2018, 12:20 UTC

The fire started on 3 November 2018 in Ticvaniu Mare, Romania, and satellites saw it burning for 3 days. Copernicus mapped a burnt perimeter of 313 hectares from satellite imagery, spread across 2 municipalities.

It is the 59th largest in Caraș-Severin since 2016 (of 196 with a page). Number 2 in Romania in 2018, of 8.

The power measured by the satellite is low (11.9 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
313ha
Copernicus perimeter
Duration
3days
3 Nov 2018 – 5 Nov 2018
Municipalities hit
2
municipalities
Started on
3 Nov
2018
Heat detections
13
in a single hotspot: 12 MW
Danger at start
16
Moderate · FWI index
Average daily power
17MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 3 Nov5 Nov
5 Nov 2018

How it evolved, day by day

3 Nov 2018 · 22 MW · 7 4 Nov 2018 · 16 MW · 4 5 Nov 2018 · 12 MW · 2
3 Nov 4 Nov 5 Nov

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

20°high
38km/h · peak gust
37%lowest humidity

It had gone 3 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Ticvaniu Mare 1,844 inhabitants · 2.2 km from the centre where it started
    283 ha reached on 3 Nov
    2.4 %
  2. Forotic 1,488 inhabitants · 2.7 km from the centre
    30 ha reached on 3 Nov
    0.3 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Agricultural areas70 %
  • Broadleaved forest30 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
5 Nov 19.9 °C 37 % 38 km/h 0.0 mm Moderate 16
6 Nov after 18.2 °C 44 % 34 km/h 0.0 mm Moderate 15
7 Nov after 17.5 °C 54 % 36 km/h 0.0 mm Moderate 13
8 Nov after 16.0 °C 50 % 18 km/h 0.0 mm Low 11
9 Nov after 16.2 °C 45 % 20 km/h 0.0 mm Low 11
10 Nov after 17.1 °C 46 % 27 km/h 0.0 mm Moderate 12
11 Nov after 18.6 °C 44 % 26 km/h 0.0 mm Moderate 12
12 Nov after 19.5 °C 44 % 19 km/h 0.0 mm Moderate 12
13 Nov after 16.3 °C 50 % 38 km/h 0.0 mm Moderate 15
14 Nov after 13.2 °C 70 % 23 km/h 0.0 mm Low 9
15 Nov after 13.0 °C 50 % 32 km/h 0.0 mm Low 10

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 27 Oct 2018
After · 12 Nov 2018

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 2 November 2018 the air beside the fire reached 23 µg/m³ of PM2.5. That day averaged 19: 1.3 times the WHO daily guideline (15).

PM2.5 peak23 µg/m³
Days over the guideline3 days
PM1038 µg/m³
12345678
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 13Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Romania ›

Frequently asked questions

How long did the Ticvaniu Mare fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 3 November 2018 to 5 November 2018 (3 days). The perimeter dates it from 5 November 2018 to 5 November 2018.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 313 hectares (3.1 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Ticvaniu Mare (283 ha, 2.4 %); Forotic (30 ha, 0.3 %).
Did the fire reach a town?
The fire started in Ticvaniu Mare and came within 2.2 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 19.9 °C, humidity dropped to 37 % and gusts hit 38 km/h. The fire danger index (FWI) reached 16, class Moderate.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Romania (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 5 November 2018 to 5 November 2018. 13 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.