Skip to content
worldfires
KH · Cambodia · –

Thala Barivat fire, 3 February 2019 Thala Barivat

Out · last detection 22 Feb 2019, 06:22 UTC

The fire started on 3 February 2019 in Thala Barivat, Cambodia, and satellites saw it burning for 20 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 2,208 hectares from heat detections, spread across a single municipality.

It is the 90th largest in Stung Treng since 2016 (of 102 with a page). Number 57 in Cambodia in 2019, of 65.

The power measured by the satellite is low (13.3 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
2,208ha
GWIS perimeter (Copernicus)
Duration
20days
3 Feb 2019 – 22 Feb 2019
Municipalities hit
1
districts
Started on
3 Feb
2019
Heat detections
96
in a single hotspot: 13 MW
Danger at start
36
High · FWI index
Average daily power
49MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 3 Feb22 Feb
22 Feb 2019

How it evolved, day by day

10 Feb 2019 · 9 MW · 2 11 Feb 2019 · 145 MW · 21 12 Feb 2019 · 185 MW · 43 13 Feb 2019 · 59 MW · 18 14 Feb 2019 · 1 MW · 1 15 Feb 2019 · 26 MW · 7 16 Feb 2019 · 11 MW · 2 21 Feb 2019 · 3 MW · 1 22 Feb 2019 · 5 MW · 1
10 Feb 12 Feb 14 Feb 16 Feb 22 Feb

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

39°high
40km/h · peak gust
15%lowest humidity

It had gone 37 days without rain (1 mm or more) when it started.

This area had burned before

82% of the perimeter overlaps earlier fires recorded since 2016: 2,028 ha in 2016. Part of it burned more than once, so the yearly figures add up to more than the 1,804 ha that had burned before.

How big is it?

10 km
It burned the equivalent of 1.4% of the area of London (22 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Thala Barivat where it started
    2,219 ha reached on 10 Feb
    0.8 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area< 0.1 ha
Residents≈ 20

Inside the perimeter there were about 0.09 hectares of built-up land and about 20 residents (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
3 Feb 37.4 °C 29 % 30 km/h 0.0 mm High 36
4 Feb 37.2 °C 34 % 25 km/h 0.0 mm High 36
5 Feb 36.9 °C 36 % 24 km/h 0.0 mm High 31
6 Feb 36.8 °C 33 % 28 km/h 0.0 mm High 34
7 Feb 38.0 °C 31 % 28 km/h 0.0 mm High 31
8 Feb 38.9 °C 31 % 26 km/h 0.0 mm High 31
9 Feb 38.9 °C 29 % 28 km/h 0.0 mm High 31
10 Feb 38.0 °C 30 % 26 km/h 0.0 mm High 36
11 Feb 38.4 °C 15 % 35 km/h 0.0 mm Very high 49
12 Feb 36.1 °C 31 % 40 km/h 0.0 mm Very high 48
13 Feb 37.4 °C 20 % 39 km/h 0.0 mm Very high 47
14 Feb 36.9 °C 26 % 31 km/h 0.0 mm Very high 40
15 Feb 37.5 °C 19 % 34 km/h 0.0 mm Very high 45
16 Feb 37.0 °C 27 % 20 km/h 0.0 mm High 36
17 Feb 36.3 °C 31 % 32 km/h 0.0 mm Very high 41
18 Feb 36.1 °C 33 % 32 km/h 0.0 mm Very high 43
19 Feb 38.0 °C 30 % 28 km/h 0.0 mm High 38
20 Feb 36.1 °C 41 % 24 km/h 0.0 mm High 29
21 Feb 38.0 °C 34 % 22 km/h 0.0 mm High 29
22 Feb 37.9 °C 35 % 28 km/h 0.3 mm High 30
23 Feb after 35.8 °C 41 % 26 km/h 0.2 mm High 29
24 Feb after 37.2 °C 35 % 27 km/h 0.0 mm High 28
25 Feb after 37.9 °C 28 % 26 km/h 0.0 mm High 35
26 Feb after 39.1 °C 22 % 29 km/h 0.0 mm Very high 38
27 Feb after 38.3 °C 25 % 31 km/h 0.0 mm Very high 39
28 Feb after 37.6 °C 28 % 28 km/h 0.0 mm High 36
1 Mar after 38.0 °C 31 % 27 km/h 0.0 mm High 35
2 Mar after 37.9 °C 29 % 28 km/h 0.0 mm High 36
3 Mar after 37.5 °C 30 % 31 km/h 0.0 mm High 35
4 Mar after 36.9 °C 31 % 33 km/h 0.0 mm Very high 41

Its twins: fires that started in the same weather

It started with an FWI of 36.2, a minimum humidity of 29% and 37 days without rain. Fires in the area that started in weather like this since 2016: 45.

FWI at the start 36.2
Minimum humidity 29 %
Days without rain 37
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Koun Mom fire, January 2021
2,572 ha 12 days FWI 35.7 Min. humidity 31 % 116 km away, in 2021

First rain (1 mm or more) after it ended: 1.4 mm on 10 Feb.

What happened to them

21 days
median duration
3,049 ha
median area
100 %
went past 1,000 ha
3.0 mm
rain at the end (median; 19 of 45 had it)

It burned an area similar to its twins (2,208 ha against a median of 3,049 ha) and lasted 20 days, against 21 days.

In 26 of 45, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.0 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
40km/h · max. gust

It was considered over on 22 Feb, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 19 of 45, with a median of 3.0 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 27 Jan 2019
After · 1 Mar 2019

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 96Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Cambodia

Frequently asked questions

How long did the Thala Barivat fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 3 February 2019 to 22 February 2019 (20 days). The perimeter dates it from 10 February 2019 to 15 February 2019.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 2,208 hectares (22.1 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Thala Barivat (2,219 ha, 0.8 %).
What was the weather like?
During the fire the temperature reached 38.9 °C, humidity dropped to 15 % and gusts hit 40 km/h. The fire danger index (FWI) reached 49, class Very high.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Cambodia (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 45. Their median duration was 21 days and their median area 3,049 ha; 100 % went past 1,000 ha. In 26 of 45, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.0 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

History of this page · 2 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Last day with fire: 15 February 2019 → 22 February 2019.
  2. Start date: 10 February 2019 → 3 February 2019.

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 10 February 2019 to 15 February 2019. 96 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.