Skip to content
worldfires
AL · Albania · →

Tepelenë fire, August 2019 Tepelenë

Out · last detection 23 Aug 2019, 11:22 UTC

The fire started on 23 August 2019 in Tepelenë, Albania, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 127 hectares from satellite imagery, spread across a single municipality.

It is the 24th largest in Gjirokastër since 2016 (of 40 with a page). Number 21 in Albania in 2019, of 31.

The power measured by the satellite is low (7.0 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
127ha
Copernicus perimeter
Duration
2days
23 Aug 2019 – 24 Aug 2019
Municipalities hit
1
municipalities
Started on
23 Aug
2019
Heat detections
2
in a single hotspot: 7 MW
Danger at start
20
Moderate · FWI index
Average daily power
14MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 23 Aug24 Aug

How it evolved, day by day

23 Aug 2019 · 14 MW · 2

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

27°high
27km/h · peak gust
33%lowest humidity

It had gone 8 days without rain (1 mm or more) when it started. Rain came after the fire: 1.4 mm on 27 Aug.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Tepelenë where it started
    127 ha reached on 23 Aug
    0.2 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Scrub and transitional woodland72 %
  • Other natural land28 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
23 Aug 26.6 °C 33 % 23 km/h 0.0 mm Moderate 20
24 Aug 26.7 °C 35 % 27 km/h 2.1 mm Low 7
25 Aug after 26.2 °C 36 % 28 km/h 0.0 mm Moderate 15
26 Aug after 27.0 °C 30 % 26 km/h 0.0 mm Moderate 20
27 Aug after 26.5 °C 34 % 33 km/h 1.4 mm Low 11

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 16 Aug 2019
After · 31 Aug 2019

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 25 August 2019 the air beside the fire reached 18 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak18 µg/m³
Days over the guideline0 days
PM1032 µg/m³
21222324252627
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 2Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Albania ›

Frequently asked questions

How long did the Tepelenë fire last?
Copernicus dates it between 23 August 2019 and 24 August 2019: 2 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 127 hectares (1.3 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Tepelenë (127 ha, 0.2 %).
What was the weather like?
During the fire the temperature reached 26.7 °C, humidity dropped to 33 % and gusts hit 27 km/h. The fire danger index (FWI) reached 20, class Moderate.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Albania (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 128 · 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 128 · 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 2 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 2.5 Generic). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.