Skip to content
worldfires
TN · Tunisia · →

تبرسق fire, July 2026 تبرسق, باجة الجنوبية

Out · last detection 23 Jul 2026, 00:50 UTC

The fire started on 22 July 2026 in تبرسق, Tunisia, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 171 hectares from satellite imagery, spread across 2 municipalities.

It is the 16th largest in Béja since 2016 (of 23 with a page). Number 22 in Tunisia in 2026, of 36.

The power measured by the satellite is low (21.0 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
171ha
Copernicus perimeter
Duration
≈ 1day
22 Jul 2026 – 22 Jul 2026
Municipalities hit
2
delegations
Started on
22 Jul
2026
Heat detections
10
in a single hotspot: 21 MW
Danger at start
54
Extreme · FWI index
Average daily power
46MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 22 Jul22 Jul
23 Jul 2026

How it evolved, day by day

22 Jul 2026 · 86 MW · 8 23 Jul 2026 · 6 MW · 2
22 Jul 23 Jul

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

42°high
39km/h · peak gust
14%lowest humidity

It had gone 28 days without rain (1 mm or more) when it started. Rain came after the fire: 1.3 mm on 25 Jul.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. تبرسق where it started
    166 ha reached on 22 Jul
    0.4 %
  2. 5 ha reached on 22 Jul
    0.0 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Broadleaved forest40 %
  • Agricultural areas23 %
  • Sclerophyllous scrub20 %
  • Coniferous forest14 %
  • Mixed forest2.3 %
  • Scrub and transitional woodland0.6 %

Land cover inside the perimeter as reported by Copernicus EFFIS (outside the Corine Land Cover area).

People and buildings inside the perimeter

GHSL 2025
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2025, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned. The GHSL 2025 epoch is a projection made from 2020 and earlier data.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
22 Jul 41.6 °C 14 % 39 km/h 0.6 mm Extreme 54
23 Jul after 42.3 °C 14 % 43 km/h 0.1 mm Extreme 61
24 Jul after 36.6 °C 25 % 41 km/h 0.0 mm Very high 49
25 Jul after 41.3 °C 21 % 26 km/h 1.3 mm Very high 45

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 15 Jul 2026
After · 29 Jul 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 24 July 2026 the air beside the fire reached 51 µg/m³ of PM2.5. That day averaged 30: 2.0 times the WHO daily guideline (15).

PM2.5 peak51 µg/m³
Days over the guideline5 days
PM1095 µg/m³
Optical depth0.88
20212223242526
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 10Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Tunisia ›

Frequently asked questions

How long did the تبرسق fire last?
The official perimeter only gives the start date (22 July 2026). The end comes from the heat detections inside the perimeter: it burned until 22 July 2026 (1 day from 22 July 2026), the last day with detections before more than 10 days in a row without any, so it is approximate.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 171 hectares (1.7 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: تبرسق (166 ha, 0.4 %); باجة الجنوبية (5 ha, 0.0 %).
What was the weather like?
During the fire the temperature reached 41.6 °C, humidity dropped to 14 % and gusts hit 39 km/h. The fire danger index (FWI) reached 54, class Extreme.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Tunisia (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 198 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 198.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • The official perimeter has no end date: the end is the last day with VIIRS detections inside the perimeter before a gap of more than 10 days (150 days at most), so it is approximate. 10 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2025, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.