Skip to content
worldfires
BJ · Benin · –

Tanguiéta fire, 20 November 2019 Tanguiéta

Out · last detection 5 Dec 2019, 13:45 UTC

The fire started on 20 November 2019 in Tanguiéta, Benin, and satellites saw it burning for 16 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 1,039 hectares from heat detections, spread across a single municipality.

It is the 399th largest in Atakora since 2016 (of 420 with a page). Number 110 in Benin in 2019, of 120.

Burnt area
1,039ha
GWIS perimeter (Copernicus)
Duration
16days
20 Nov 2019 – 5 Dec 2019
Municipalities hit
1
communes
Started on
20 Nov
2019
Heat detections
41
in a single hotspot: 34 MW
Danger at start
28
High · FWI index
Average daily power
29MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 20 Nov5 Dec
5 Dec 2019

How it evolved, day by day

20 Nov 2019 · 7 MW · 4 22 Nov 2019 · 40 MW · 4 26 Nov 2019 · 66 MW · 7 27 Nov 2019 · 22 MW · 3 29 Nov 2019 · 86 MW · 4 30 Nov 2019 · 62 MW · 12 1 Dec 2019 · 4 MW · 1 2 Dec 2019 · 2 MW · 1 3 Dec 2019 · 5 MW · 4 5 Dec 2019 · 1 MW · 1
20 Nov 26 Nov 29 Nov 1 Dec 3 Dec

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

37°high
42km/h · peak gust
11%lowest humidity

It had gone 19 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

How big is it?

10 km
It burned the equivalent of 0.7% of the area of London (10 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Tanguiéta where it started
    1,046 ha reached on 20 Nov
    0.2 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
20 Nov 36.3 °C 22 % 22 km/h 0.0 mm High 28
21 Nov 35.9 °C 19 % 22 km/h 0.0 mm High 29
22 Nov 34.8 °C 31 % 24 km/h 0.0 mm High 27
23 Nov 36.4 °C 26 % 19 km/h 0.0 mm High 28
24 Nov 36.8 °C 26 % 24 km/h 0.0 mm High 29
25 Nov 37.0 °C 24 % 26 km/h 0.0 mm High 30
26 Nov 37.1 °C 22 % 26 km/h 0.0 mm High 31
27 Nov 36.9 °C 22 % 34 km/h 0.0 mm High 36
28 Nov 37.1 °C 13 % 41 km/h 0.0 mm Very high 46
29 Nov 35.5 °C 11 % 42 km/h 0.0 mm Very high 49
30 Nov 35.4 °C 13 % 40 km/h 0.0 mm Very high 49
1 Dec 35.4 °C 16 % 32 km/h 0.0 mm Very high 44
2 Dec 34.8 °C 17 % 26 km/h 0.0 mm Very high 41
3 Dec 34.7 °C 22 % 28 km/h 0.0 mm Very high 39
4 Dec 34.3 °C 16 % 29 km/h 0.0 mm Very high 41
5 Dec 33.9 °C 13 % 32 km/h 0.0 mm Very high 42
6 Dec after 34.9 °C 22 % 26 km/h 0.0 mm Very high 39
7 Dec after 34.5 °C 20 % 28 km/h 0.0 mm Very high 41
8 Dec after 35.0 °C 12 % 28 km/h 0.0 mm Very high 42
9 Dec after 34.8 °C 15 % 26 km/h 0.0 mm Very high 42
10 Dec after 35.1 °C 15 % 25 km/h 0.0 mm Very high 42
11 Dec after 34.4 °C 14 % 27 km/h 0.0 mm Very high 43
12 Dec after 33.8 °C 13 % 34 km/h 0.0 mm Very high 47
13 Dec after 33.2 °C 15 % 34 km/h 0.0 mm Very high 49
14 Dec after 33.2 °C 12 % 32 km/h 0.0 mm Very high 48
15 Dec after 33.3 °C 14 % 29 km/h 0.0 mm Very high 47

Its twins: fires that started in the same weather

It started with an FWI of 28.3, a minimum humidity of 22% and 19 days without rain. Fires in the area that started in weather like this since 2016: 38.

FWI at the start 28.3
Minimum humidity 22 %
Days without rain 19
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Bitou fire, November 2024
1,012 ha 6 days FWI 28.5 Min. humidity 22 % 184 km away, in 2024

First rain (1 mm or more) after it ended: none in the following ten days.

What happened to them

7 days
median duration
1,388 ha
median area
100 %
went past 1,000 ha
—
rain at the end (median; 0 of 38 had it)

It burned an area similar to its twins (1,039 ha against a median of 1,388 ha) and lasted 16 days, against 7 days.

In none of them did 1 mm fall in the ten days after the end: they all went out without rain.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
42km/h · max. gust

It was considered over on 5 Dec, and not even 1 mm fell in the following ten days: it went out without rain. None of its 38 twins had rain when they ended.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 13 Nov 2019
After · 12 Dec 2019

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 41Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Benin

Frequently asked questions

How long did the Tanguiéta fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 20 November 2019 to 5 December 2019 (16 days). The perimeter dates it from 27 November 2019 to 3 December 2019.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 1,039 hectares (10.4 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Tanguiéta (1,046 ha, 0.2 %).
What was the weather like?
During the fire the temperature reached 37.1 °C, humidity dropped to 11 % and gusts hit 42 km/h. The fire danger index (FWI) reached 49, class Very high.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Benin (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 38. Their median duration was 7 days and their median area 1,388 ha; 100 % went past 1,000 ha. In none of them did 1 mm fall in the ten days after the end: they all went out without rain.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

History of this page · 1 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Start date: 26 November 2019 → 20 November 2019.

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 27 November 2019 to 3 December 2019. 41 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Public Domain). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.