Skip to content
worldfires
MX · Mexico · –

Talpa de Allende fire, 10 May 2018 Talpa de Allende

Out · last detection 3 Jun 2018, 07:54 UTC

The fire started on 10 May 2018 in Talpa de Allende, Mexico, and satellites saw it burning for 25 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 2,518 hectares from heat detections, spread across a single municipality.

It is the 116th largest in Jalisco since 2016 (of 267 with a page). Number 109 in Mexico in 2018, of 233.

The power measured by the satellite is low (23.0 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
2,518ha
GWIS perimeter (Copernicus)
Duration
25days
10 May 2018 – 3 Jun 2018
Municipalities hit
1
municipalities
Started on
10 May
2018
Heat detections
188
in a single hotspot: 23 MW
Danger at start
5
Very low · FWI index
Average daily power
49MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 10 May3 Jun
3 Jun 2018

How it evolved, day by day

12 May 2018 · 10 MW · 1 13 May 2018 · 4 MW · 1 14 May 2018 · 70 MW · 13 15 May 2018 · 115 MW · 17 16 May 2018 · 13 MW · 9 17 May 2018 · 1 MW · 1 18 May 2018 · 126 MW · 15 19 May 2018 · 70 MW · 12 20 May 2018 · 77 MW · 16 21 May 2018 · 29 MW · 8 22 May 2018 · 38 MW · 11 23 May 2018 · 88 MW · 14 24 May 2018 · 63 MW · 24 25 May 2018 · 52 MW · 11 26 May 2018 · 63 MW · 19 27 May 2018 · 65 MW · 7 30 May 2018 · 25 MW · 5 1 Jun 2018 · 15 MW · 2 3 Jun 2018 · 2 MW · 2
12 May 18 May 24 May 30 May

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

34°high
44km/h · peak gust
17%lowest humidity

It had gone 0 days without rain (1 mm or more) when it started. Rain came after the fire: 25.4 mm on 4 Jun.

This area had burned before

12% of the perimeter overlaps earlier fires recorded since 2016: 170 ha in 2016, 128 ha in 2017.

How big is it?

10 km
It burned the equivalent of 1.6% of the area of London (25 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Talpa de Allende where it started
    2,529 ha reached on 12 May
    1.3 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
10 May 30.4 °C 49 % 39 km/h 1.2 mm Very low 5
11 May 30.3 °C 46 % 35 km/h 1.8 mm Low 10
12 May 30.0 °C 49 % 32 km/h 1.1 mm Low 6
13 May 30.9 °C 49 % 30 km/h 1.8 mm Low 11
14 May 31.7 °C 39 % 33 km/h 1.7 mm Low 10
15 May 32.8 °C 39 % 37 km/h 0.1 mm Moderate 12
16 May 32.8 °C 38 % 37 km/h 0.0 mm Moderate 19
17 May 32.4 °C 38 % 39 km/h 0.0 mm Moderate 21
18 May 32.7 °C 33 % 40 km/h 0.0 mm High 24
19 May 33.4 °C 24 % 43 km/h 0.0 mm High 30
20 May 33.3 °C 17 % 43 km/h 0.0 mm High 33
21 May 33.2 °C 26 % 41 km/h 0.0 mm High 33
22 May 33.4 °C 26 % 40 km/h 0.0 mm High 34
23 May 33.6 °C 29 % 37 km/h 0.0 mm High 36
24 May 33.2 °C 32 % 39 km/h 0.1 mm High 35
25 May 33.0 °C 36 % 40 km/h 0.0 mm High 33
26 May 32.9 °C 42 % 38 km/h 0.0 mm High 30
27 May 32.3 °C 46 % 38 km/h 0.0 mm High 29
28 May 32.5 °C 47 % 38 km/h 0.0 mm High 25
29 May 32.5 °C 51 % 35 km/h 0.0 mm High 25
30 May 33.6 °C 46 % 39 km/h 0.7 mm High 22
31 May 32.9 °C 50 % 40 km/h 1.3 mm Moderate 20
1 Jun 33.1 °C 53 % 42 km/h 2.8 mm Moderate 21
2 Jun 34.0 °C 42 % 44 km/h 5.0 mm Low 8
3 Jun 30.5 °C 57 % 37 km/h 0.2 mm Very low 4
4 Jun after 29.5 °C 70 % 30 km/h 25.4 mm Very low 3

Its twins: fires that started in the same weather

It started with an FWI of 4.6, a minimum humidity of 49% and rain the day before. Fires in the area that started in weather like this since 2016: 15.

FWI at the start 4.6
Minimum humidity 49 %
Days without rain 0
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Talpa de Allende fire, June 2024
1,545 ha 2 days FWI 4.4 Min. humidity 47 % 14 km away, in 2024

First rain (1 mm or more) after it ended: 24.0 mm on 21 Jun.

What happened to them

14 days
median duration
2,240 ha
median area
100 %
went past 1,000 ha
8.1 mm
rain at the end (median; 15 of 15 had it)

It burned an area similar to its twins (2,518 ha against a median of 2,240 ha) and lasted 25 days, against 14 days.

All of them had rain in the ten days after the end: the first rainy day brought a median of 8.1 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

25.4 mmfirst rain
4 Junthe day after it ended
44km/h · max. gust

It was considered over on 3 Jun, and on 4 Jun 25.4 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 15 of 15, with a median of 8.1 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 3 May 2018
After · 10 Jun 2018

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 188Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Mexico

Frequently asked questions

How long did the Talpa de Allende fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 10 May 2018 to 3 June 2018 (25 days). The perimeter dates it from 13 May 2018 to 27 May 2018.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 2,518 hectares (25.2 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Talpa de Allende (2,529 ha, 1.3 %).
What was the weather like?
During the fire the temperature reached 34.0 °C, humidity dropped to 17 % and gusts hit 44 km/h. The fire danger index (FWI) reached 36, class High.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Mexico (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 15. Their median duration was 14 days and their median area 2,240 ha; 100 % went past 1,000 ha. All of them had rain in the ten days after the end: the first rainy day brought a median of 8.1 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 911 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 911.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 13 May 2018 to 27 May 2018. 188 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.