Svatove fire, 24 October 2026
Сватівський район · Svatove
Out · last detection 30 Oct 2026, 10:41 UTC
Satellites first detected fire on 24 October 2026 in Svatove, Ukraine. It was active for 7 days, with 11 heat detections and an area with fire of about 154 hectares rebuilt from them, spread across a single municipality.
The power measured by the satellite is low (8.4 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.
matches the official recordwith caveatssatellite onlymodel
When copying, the sentence is
Tick the figures you want: they make up the lede and the CSV.
Burned area
satellite only
≈ 154ha
Estimated from hotspots: no perimeter has been published yet.
Source
NASA FIRMS · VIIRS
Date
24 Oct 2026 – 30 Oct 2026
+− cross-check
This is an estimate from the VIIRS pixels that saw fire. It will change when the perimeter is published.
Duration by satellite
satellite only
7days
24 Oct 2026 to 30 Oct 2026: first and last day with fire on the page.
Source
NASA FIRMS · VIIRS
Date
last detection: 30 Oct 2026, 10:41 UTC
+− cross-check
Satellites pass a few times a day and cloud or smoke can hide the fire: a lack of detections is not an official extinction. Each country’s emergency service declares a fire contained or out.
Start
satellite only
24 Oct 2026
First day with fire seen by the satellites or the perimeter.
Source
NASA FIRMS · VIIRS
Date
24 Oct 2026
+− cross-check
No official record is matched to this page, so the alert time and the cause are not known here.
Hotspots
satellite only
11
VIIRS detections at 375 m. Most intense hotspot: 8 MW.
Source
NASA FIRMS · VIIRS (Suomi NPP)
Date
24 Oct 2026 – 30 Oct 2026
+− cross-check
There is no official record to compare with. Each hotspot is a pixel detected in one satellite pass, not a separate fire.
The worst day
satellite only
16MW
Total radiative power on 24 October 2026; hotspots that day: 5.
Source
NASA FIRMS · VIIRS (FRP)
Date
24 Oct 2026
+− cross-check
Fire radiative power (FRP) measures the energy the fire gives off when the satellite passes. Added up by day, it compares intensity, not area.
Danger at the start
model
19.8FWI · moderate
Fire Weather Index (Canadian system) computed by WorldFires for the day the fire started. Consecutive days without rain before: 4.
This is an index computed from weather model data, not a measurement of the fire nor an official warning. Danger warnings are issued by each country’s authority. Emergency number and official warnings ›
Weather during the fire
model
18.4°C · 33% RH
High of 18.4 °C and minimum humidity of 33% on 24 October 2026; gusts of 51 km/h on 29 October 2026.
These are model values for a cell of about 25 km, not from a weather station: they may differ from what was measured on the ground.
ⓘThis page’s change log has been kept since 31 October 2026: every night what it publishes is compared and the difference is logged. Anything earlier is reconstructed from each source’s date and marked as reconstructed.
A version keeps the area, dates, name and official record; the area as it was logged (changes under 2% are not logged). The map, hotspots and weather always show today’s data.
Citation
A lede of about 60 words figures only, no adjectives
Copernicus has not yet published the burnt perimeter, which takes a few days to measure on satellite imagery. For now the area is the one rebuilt from heat detections (about 14 hectares per pixel). When the perimeter arrives, this page picks it up on its own and keeps the same address.
Area with fire
≈ 154ha
rebuilt from hotspots, no official perimeter yet
Duration
7days
24 Oct 2026 – 30 Oct 2026
Municipalities hit
1
districts
Started on
24 Oct
2026
Heat detections
11
in a single hotspot: 8 MW
Danger at start
20
Moderate · FWI index
Average daily power
7MW
detected power per day, on average
Where it burned
HOTSPOTS BY DAY
24 Oct30 Oct
Play back30 Oct 2026
How it evolved, day by day
24 Oct26 Oct29 Oct
Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.
The weather it burned in
18°high
51km/h · peak gust
25%lowest humidity
It had gone 4 days without rain (1 mm or more) when it started. Rain came after the fire: 2.9 mm on 31 Oct.
What happened to each town
SvatoveСватівський район80,900 inhabitants · 12.3 km from the centrewhere it started
154 hareached on 24 Oct
0.1 %
Area with fire inside each municipality, rebuilt from heat detections (about 14 hectares per VIIRS pixel). An estimate until the official perimeter arrives. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.
The weather day by day
ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.
Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
Day
High
Min. humidity
Peak gust
Rain
Danger (FWI)
24 Oct
18.4 °C
33 %
38 km/h
0.0 mm
Moderate 20
25 Oct
15.6 °C
29 %
45 km/h
0.0 mm
High 24
26 Oct
14.3 °C
34 %
45 km/h
0.0 mm
High 25
27 Oct
15.4 °C
27 %
48 km/h
0.0 mm
High 27
28 Oct
17.0 °C
25 %
48 km/h
0.0 mm
High 31
29 Oct
17.0 °C
28 %
51 km/h
0.0 mm
High 34
30 Oct
17.0 °C
27 %
47 km/h
0.0 mm
High 32
31 Oct after
11.5 °C
55 %
36 km/h
2.9 mm
Moderate 16
Its twins: fires that started in the same weather
It started with an FWI of 19.8, a minimum humidity of 33% and 4 days without rain. Fires in the area that started in weather like this since 2020: 16.
FWI at the start19.8
Minimum humidity33 %
Days without rain4
this firechosen twinsrest of the area
Almost identicalSimilar
Outlines of the closest twins
Kupiansk fire, August 2025
125 ha1 dayFWI 18.0Min. humidity 33 %35 km away, in 2025
First rain (1 mm or more) after it ended: none in the following ten days.
It burned an area similar to its twins (154 ha against a median of 198 ha) and lasted 7 days, against 2 days.
In 2 of 16, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 1.8 mm.
This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it
How it ended
2.9 mmfirst rain
31 Octthe day after it ended
51km/h · max. gust
It was considered over on 30 Oct, and on 31 Oct 2.9 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 14 of 16, with a median of 1.8 mm.
Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
How a twin is chosen
Same area: fires that have already ended, less than 250 km from this one, since 2020.
Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
They are sorted by similarity, and the outlines of the first five are drawn.
Drag the line to compare the same ground before the fire and after it.
↔
Before · 17 Oct 2026
After · 6 Nov 2026
Sentinel-2 did not pass over on that day. Try another date, or use false colour, which is daily.
If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.
The smoke
CAMS · Copernicus
On 26 October 2026 the air beside the fire reached 15 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).
PM2.5 peak15µg/m³
Days over the guideline0days
PM1041µg/m³
Optical depth0.33
21 Oct23 Oct25 Oct27 Oct29 Oct
GoodFairModeratePoorVery poorExtremely poor
Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.
Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)
Detections table· 11Every satellite heat detection, one by one, with time, satellite, power and coordinates.›
⬇ Download CSVTimes in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
According to the heat detections seen by satellite, it burned from 24 October 2026 to 30 October 2026 (7 days between the first and the last detection). There is no perimeter yet to date it.
How much area did it burn?
There is no official perimeter yet. Heat detections rebuild about 154 hectares with fire (1.5 km²); Copernicus will publish the measured figure within days.
Which municipalities burned?
The fire only entered Svatove (154 ha, 0.1 %).
Is the Svatove fire still active?
No fire detections since 30 Oct 2026, 10:41 UTC. A lack of detections is not an official extinction.
Did the fire reach a town?
The fire started in Svatove and came within 12.3 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 18.4 °C, humidity dropped to 25 % and gusts hit 51 km/h. The fire danger index (FWI) reached 34, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Ukraine (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2020 with a similar FWI, humidity and dry spell: 16. Their median duration was 2 days and their median area 198 ha; 0 % went past 1,000 ha. In 2 of 16, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 1.8 mm.
Where to verify it
A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.
This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.
⚑Report an errorHow we know this›
No perimeter yet: the area (≈ 154 ha) is estimated by counting VIIRS pixels with fire, about 14 ha each.
Dates of the first and last VIIRS detection of the cluster. 11 Suomi-NPP VIIRS detections on those dates.
Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Public Domain). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.