Skip to content
worldfires
IT · Italy · →

Sutera fire, July 2021 Sutera, Mussomeli

Out · last detection 25 Jul 2021, 00:38 UTC

The fire started on 22 July 2021 in Sutera, Italy, and satellites saw it burning for 4 days. Copernicus mapped a burnt perimeter of 230 hectares from satellite imagery, spread across 2 municipalities.

It is the 48th largest in Caltanissetta since 2016 (of 149 with a page). Number 130 in Italy in 2021, of 291.

The power measured by the satellite is low (6.6 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
230ha
Copernicus perimeter
Duration
4days
22 Jul 2021 – 25 Jul 2021
Municipalities hit
2
municipalities
Started on
22 Jul
2021
Heat detections
5
in a single hotspot: 7 MW
Danger at start
33
High · FWI index
Average daily power
6MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 22 Jul25 Jul
25 Jul 2021

How it evolved, day by day

22 Jul 2021 · 9 MW · 3 24 Jul 2021 · 7 MW · 1 25 Jul 2021 · 3 MW · 1
22 Jul 24 Jul 25 Jul

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

32°high
37km/h · peak gust
27%lowest humidity

It had gone 4 days without rain (1 mm or more) when it started.

This area had burned before

0% of the perimeter overlaps earlier fires recorded since 2016: 1 ha in 2019.

What happened to each town

  1. Sutera 1,178 inhabitants · fire reached the centre where it started
    229 ha reached on 22 Jul
    6.5 %
  2. Mussomeli 9,913 inhabitants · 3.9 km from the centre
    1 ha
    0.0 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land56 %
  • Agricultural areas34 %
  • Broadleaved forest9.1 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
22 Jul 31.4 °C 27 % 33 km/h 0.0 mm High 33
23 Jul 31.3 °C 33 % 26 km/h 0.0 mm High 30
24 Jul 31.7 °C 30 % 29 km/h 0.0 mm High 32
25 Jul 30.5 °C 29 % 37 km/h 0.0 mm High 34
26 Jul after 30.1 °C 32 % 36 km/h 0.0 mm High 35
27 Jul after 31.8 °C 30 % 27 km/h 0.0 mm High 34
28 Jul after 33.5 °C 31 % 34 km/h 0.0 mm High 35
29 Jul after 34.5 °C 25 % 34 km/h 0.0 mm Very high 38
30 Jul after 33.3 °C 29 % 42 km/h 0.0 mm Very high 42
31 Jul after 34.9 °C 31 % 24 km/h 0.0 mm High 35
1 Aug after 36.4 °C 26 % 40 km/h 0.0 mm Very high 42
2 Aug after 35.3 °C 29 % 23 km/h 0.0 mm High 36
3 Aug after 34.5 °C 24 % 28 km/h 0.0 mm High 36
4 Aug after 34.9 °C 26 % 42 km/h 0.0 mm Very high 43

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 15 Jul 2021
After · 1 Aug 2021

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 28 July 2021 the air beside the fire reached 19 µg/m³ of PM2.5. That day averaged 16: 1.0 times the WHO daily guideline (15).

PM2.5 peak19 µg/m³
Days over the guideline1 day
PM1037 µg/m³
202122232425262728
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 5Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Italy ›

Frequently asked questions

How long did the Sutera fire last?
Copernicus dates it between 22 July 2021 and 25 July 2021: 4 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 230 hectares (2.3 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Sutera (229 ha, 6.5 %); Mussomeli (1 ha, 0.0 %).
Did the fire reach a town?
The fire started in Sutera and reached its centre: the point marking it was inside the burnt area or less than 500 metres from it. That does not mean houses burned.
What was the weather like?
During the fire the temperature reached 31.7 °C, humidity dropped to 27 % and gusts hit 37 km/h. The fire danger index (FWI) reached 34, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Italy (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 1515 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 1515.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 5 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM4 (Creative Commons Attribution 3.0 License). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.