Skip to content
worldfires
TR · Türkiye · →

Susurluk fire, 31 July 2026 Susurluk

Out · last detection 31 Jul 2026, 23:39 UTC

The fire started on 31 July 2026 in Susurluk, Türkiye, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 703 hectares from satellite imagery, spread across a single municipality.

It is the 2th largest in Balıkesir since 2016 (of 20 with a page). Number 16 in Türkiye in 2026, of 109.

The power measured by the satellite is low (23.2 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
703ha
Copernicus perimeter
Duration
≈ 1day
31 Jul 2026 – 31 Jul 2026
Municipalities hit
1
districts
Started on
31 Jul
2026
Heat detections
2
in a single hotspot: 23 MW
Danger at start
32
High · FWI index
Average daily power
24MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 31 Jul31 Jul

How it evolved, day by day

31 Jul 2026 · 24 MW · 2

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

27°high
104km/h · peak gust
40%lowest humidity

It had gone 5 days without rain (1 mm or more) when it started.

This area had burned before

0% of the perimeter overlaps earlier fires recorded since 2016: 1 ha in 2021.

How big is it?

10 km
It burned the equivalent of 0.4% of the area of London (7 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Susurluk 39,058 inhabitants · 8.7 km from the centre where it started
    703 ha reached on 31 Jul
    0.9 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Mixed forest69 %
  • Scrub and transitional woodland24 %
  • Other natural land3.7 %
  • Agricultural areas3.3 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

People and buildings inside the perimeter

GHSL 2025
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2025, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned. The GHSL 2025 epoch is a projection made from 2020 and earlier data.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
31 Jul 27.2 °C 40 % 104 km/h 0.0 mm High 32
1 Aug after 28.3 °C 38 % 93 km/h 0.0 mm High 30
2 Aug after 30.1 °C 45 % 59 km/h 0.0 mm High 23
3 Aug after 30.0 °C 45 % 77 km/h 0.0 mm High 26
4 Aug after 30.9 °C 32 % 81 km/h 0.0 mm High 30
5 Aug after 32.0 °C 32 % 78 km/h 0.0 mm High 32
6 Aug after 30.3 °C 44 % 71 km/h 0.0 mm High 30
7 Aug after 30.1 °C 45 % 63 km/h 0.0 mm High 27
8 Aug after 31.6 °C 33 % 77 km/h 0.0 mm High 33
9 Aug after 28.6 °C 54 % 88 km/h 0.0 mm High 27
10 Aug after 29.7 °C 50 % 89 km/h 0.0 mm High 27

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 24 Jul 2026
After · 7 Aug 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 2 August 2026 the air beside the fire reached 16 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak16 µg/m³
Days over the guideline0 days
PM1024 µg/m³
Optical depth0.29
293031123
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 2Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Türkiye ›

Frequently asked questions

How long did the Susurluk fire last?
The official perimeter only gives the start date (31 July 2026). The end comes from the heat detections inside the perimeter: it burned until 31 July 2026 (1 day from 31 July 2026), the last day with detections before more than 10 days in a row without any, so it is approximate.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 703 hectares (7.0 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Susurluk (703 ha, 0.9 %).
Did the fire reach a town?
The fire started in Susurluk and came within 8.7 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 27.2 °C, humidity dropped to 40 % and gusts hit 104 km/h. The fire danger index (FWI) reached 32, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Türkiye (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • The official perimeter has no end date: the end is the last day with VIIRS detections inside the perimeter before a gap of more than 10 days (150 days at most), so it is approximate. 2 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2025, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.