Skip to content
worldfires
IT · Italy · →

Simeri Crichi fire, July 2023 Simeri Crichi

Out · last detection 23 Jul 2023, 01:29 UTC

The fire started on 22 July 2023 in Simeri Crichi, Italy, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 121 hectares from satellite imagery, spread across a single municipality.

It is the 23th largest in Catanzaro since 2016 (of 30 with a page). Number 173 in Italy in 2023, of 207.

The power measured by the satellite is low (18.8 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
121ha
Copernicus perimeter
Duration
2days
22 Jul 2023 – 23 Jul 2023
Municipalities hit
1
municipalities
Started on
22 Jul
2023
Heat detections
7
in a single hotspot: 19 MW
Danger at start
48
Very high · FWI index
Energy released
49MW
sum of detected power

Where it burned

23 Jul 2023
HOTSPOTS BY DAY 22 Jul23 Jul

How it evolved, day by day

2223

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

42°high
45km/h · peak gust
18%lowest humidity

It had gone 16 days without rain (1 mm or more) when it started.

This area had burned before

12% of the perimeter overlaps earlier fires recorded since 2016: 15 ha in 2020.

What happened to each town

  1. Simeri Crichi 4,722 inhabitants · 5.9 km from the town where it started
    121 ha reached on 22 Jul
    2.6 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Agricultural areas94 %
  • Scrub and transitional woodland5.8 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
22 Jul 41.5 °C 18 % 44 km/h 0.0 mm Very high 48
23 Jul 40.3 °C 21 % 45 km/h 0.0 mm Very high 48
24 Jul after 40.5 °C 18 % 40 km/h 0.0 mm Very high 45
25 Jul after 43.0 °C 15 % 55 km/h 0.0 mm Extreme 62
26 Jul after 32.5 °C 42 % 60 km/h 0.0 mm Very high 41
27 Jul after 31.3 °C 40 % 31 km/h 0.1 mm High 32
28 Jul after 33.1 °C 34 % 41 km/h 0.0 mm High 33
29 Jul after 32.8 °C 34 % 27 km/h 0.0 mm High 30
30 Jul after 34.1 °C 34 % 34 km/h 0.0 mm High 34
31 Jul after 32.9 °C 43 % 35 km/h 0.0 mm High 32
1 Aug after 32.3 °C 44 % 34 km/h 0.4 mm High 30
2 Aug after 32.9 °C 42 % 33 km/h 0.0 mm High 31

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 15 Jul 2023
After · 30 Jul 2023

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 23 July 2023 the air beside the fire reached 25 µg/m³ of PM2.5. That day averaged 20: 1.3 times the WHO daily guideline (15).

PM2.5 peak25 µg/m³
Days over the guideline5 days
PM1073 µg/m³
Optical depth0.71
20212223242526
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 7Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Italy ›

Frequently asked questions

How long did the Simeri Crichi fire last?
Copernicus dates it between 22 July 2023 and 23 July 2023: 2 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 121 hectares (1.2 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Simeri Crichi (121 ha, 2.6 %).
Did the fire reach a town?
The closest fire to a town centre came within 5.9 km of Simeri Crichi. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 41.5 °C, humidity dropped to 18 % and gusts hit 45 km/h. The fire danger index (FWI) reached 48, class Very high.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Italy (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 1515

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 1515.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM4 (Creative Commons Attribution 3.0 License). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.