Skip to content
worldfires
TR · Türkiye · →

Silvan fire, September 2026 Silvan

Out · last detection 20 Sept 2026, 10:43 UTC

The fire started on 20 September 2026 in Silvan, Türkiye, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 129 hectares from satellite imagery, spread across a single municipality.

It is the 89th largest in Diyarbakır since 2016 (of 110 with a page). Number 87 in Türkiye in 2026, of 106.

The power measured by the satellite is low (10.9 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
129ha
Copernicus perimeter
Duration
1day
20 Sept 2026 – 20 Sept 2026
Municipalities hit
1
districts
Started on
20 Sept
2026
Heat detections
2
in a single hotspot: 11 MW
Danger at start
39
Very high · FWI index
Energy released
22MW
sum of detected power

Where it burned

HOTSPOTS BY DAY 20 Sept20 Sept

How it evolved, day by day

20

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

32°high
26km/h · peak gust
24%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started.

This area had burned before

96% of the perimeter overlaps earlier fires recorded since 2016: 121 ha in 2016, 4 ha in 2018.

What happened to each town

  1. Silvan 86,672 inhabitants · 22.6 km from the town where it started
    130 ha reached on 20 Sept
    0.1 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Scrub and transitional woodland96 %
  • Other natural land3.9 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
20 Sept 31.9 °C 24 % 26 km/h 0.0 mm Very high 39
21 Sept after 30.6 °C 27 % 36 km/h 0.2 mm Very high 42
22 Sept after 33.4 °C 22 % 47 km/h 0.0 mm Very high 49
23 Sept after 33.1 °C 25 % 37 km/h 0.0 mm Very high 41
24 Sept after 30.8 °C 24 % 28 km/h 0.0 mm Very high 38
25 Sept after 29.9 °C 29 % 23 km/h 0.0 mm High 34
26 Sept after 33.0 °C 24 % 23 km/h 0.2 mm High 35
27 Sept after 34.4 °C 21 % 36 km/h 0.0 mm Very high 42
28 Sept after 29.5 °C 27 % 42 km/h 0.3 mm Very high 45
29 Sept after 25.3 °C 35 % 26 km/h 0.2 mm High 32
30 Sept after 27.4 °C 27 % 24 km/h 0.0 mm High 32

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 13 Sept 2026
After · 27 Sept 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 22 September 2026 the air beside the fire reached 31 µg/m³ of PM2.5. That day averaged 19: 1.3 times the WHO daily guideline (15).

PM2.5 peak31 µg/m³
Days over the guideline1 day
PM1078 µg/m³
Optical depth0.92
181920212223
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 2Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Türkiye ›

Frequently asked questions

How long did the Silvan fire last?
Copernicus dates it between 20 September 2026 and 20 September 2026: 1 day between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 129 hectares (1.3 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Silvan (130 ha, 0.1 %).
Did the fire reach a town?
The closest fire to a town centre came within 22.6 km of Silvan. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 31.9 °C, humidity dropped to 24 % and gusts hit 26 km/h. The fire danger index (FWI) reached 39, class Very high.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Türkiye (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.