Skip to content
worldfires
TR · Türkiye · →

Şemdinli fire, July 2018 Şemdinli, Derecik

Out · last detection 11 Jul 2018, 22:49 UTC

The fire started on 10 July 2018 in Şemdinli, Türkiye, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 517 hectares from satellite imagery, spread across 2 municipalities.

It is the 13th largest in Hakkâri since 2016 (of 111 with a page). Number 10 in Türkiye in 2018, of 104.

Burnt area
517ha
Copernicus perimeter
Duration
2days
10 Jul 2018 – 11 Jul 2018
Municipalities hit
2
districts
Started on
10 Jul
2018
Heat detections
31
in a single hotspot: 49 MW
Danger at start
33
High · FWI index
Energy released
298MW
sum of detected power

Where it burned

11 Jul 2018
HOTSPOTS BY DAY 10 Jul11 Jul

How it evolved, day by day

1011

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

35°high
40km/h · peak gust
21%lowest humidity

It had gone 24 days without rain (1 mm or more) when it started.

This area had burned before

26% of the perimeter overlaps earlier fires recorded since 2016: 190 ha in 2017. Part of it burned more than once, so the yearly figures add up to more than the 132 ha that had burned before.

What happened to each town

  1. Şemdinli 45,117 inhabitants · 16.4 km from the town where it started
    515 ha reached on 10 Jul
    0.4 %
  2. Derecik 25,907 inhabitants · 15.3 km from the town
    3 ha
    0.0 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Scrub and transitional woodland78 %
  • Other natural land22 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
10 Jul 34.0 °C 23 % 40 km/h 0.0 mm High 33
11 Jul 35.1 °C 21 % 36 km/h 0.0 mm High 34
12 Jul after 35.1 °C 22 % 38 km/h 0.0 mm High 35
13 Jul after 34.1 °C 23 % 45 km/h 0.0 mm High 36
14 Jul after 31.4 °C 27 % 49 km/h 0.0 mm Very high 38
15 Jul after 27.6 °C 28 % 55 km/h 0.0 mm High 37
16 Jul after 27.4 °C 30 % 49 km/h 0.0 mm High 34
17 Jul after 28.8 °C 30 % 48 km/h 0.0 mm High 33
18 Jul after 30.9 °C 28 % 51 km/h 0.0 mm High 35
19 Jul after 30.8 °C 16 % 53 km/h 0.0 mm Very high 39
20 Jul after 29.9 °C 18 % 50 km/h 0.0 mm Very high 39
21 Jul after 30.3 °C 15 % 42 km/h 0.0 mm Very high 39

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 3 Jul 2018
After · 18 Jul 2018

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 13 July 2018 the air beside the fire reached 22 µg/m³ of PM2.5. That day averaged 19: 1.3 times the WHO daily guideline (15).

PM2.5 peak22 µg/m³
Days over the guideline4 days
PM1038 µg/m³
891011121314
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 31Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Türkiye ›

Frequently asked questions

How long did the Şemdinli fire last?
Copernicus dates it between 10 July 2018 and 11 July 2018: 2 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 517 hectares (5.2 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Şemdinli (515 ha, 0.4 %); Derecik (3 ha, 0.0 %).
Did the fire reach a town?
The closest fire to a town centre came within 15.3 km of Derecik. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 35.1 °C, humidity dropped to 21 % and gusts hit 40 km/h. The fire danger index (FWI) reached 34, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Türkiye (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.