Skip to content
worldfires
SS · South Sudan · –

Rumbek East fire, December 2016 Rumbek East, Yirol West, Wulu

Out · last detection 27 Dec 2016, 10:41 UTC

The fire started on 18 December 2016 in Rumbek East, South Sudan, and satellites saw it burning for 9 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 5,372 hectares from heat detections, spread across 3 municipalities.

It is the 107th largest in Lakes since 2016 (of 119 with a page). Number 220 in South Sudan in 2016, of 244.

The power measured by the satellite is low (23.6 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
5,372ha
GWIS perimeter (Copernicus)
Duration
9days
18 Dec 2016 – 26 Dec 2016
Municipalities hit
3
counties
Started on
18 Dec
2016
Heat detections
126
in a single hotspot: 24 MW
Danger at start
58
Extreme · FWI index
Average daily power
68MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 18 Dec26 Dec
27 Dec 2016

How it evolved, day by day

18 Dec 2016 · 16 MW · 7 19 Dec 2016 · 42 MW · 7 20 Dec 2016 · 151 MW · 32 21 Dec 2016 · 82 MW · 20 22 Dec 2016 · 94 MW · 11 23 Dec 2016 · 132 MW · 27 24 Dec 2016 · 35 MW · 8 25 Dec 2016 · 1 MW · 1 26 Dec 2016 · 119 MW · 12 27 Dec 2016 · 3 MW · 1
18 Dec 20 Dec 22 Dec 24 Dec 26 Dec

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

37°high
43km/h · peak gust
18%lowest humidity

It had gone 15 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

How big is it?

10 km
It burned the equivalent of 3.4% of the area of London (54 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Rumbek East where it started
    3,197 ha reached on 18 Dec
    0.9 %
  2. 1,511 ha reached on 22 Dec
    0.3 %
  3. 698 ha reached on 20 Dec
    0.1 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2015
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2015, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with Extreme FWI: 63 % of the area in South Sudan

Day High Min. humidity Peak gust Rain Danger (FWI)
18 Dec 36.2 °C 18 % 37 km/h 0.0 mm Extreme 58
19 Dec 36.8 °C 20 % 37 km/h 0.0 mm Extreme 57
20 Dec 36.7 °C 19 % 42 km/h 0.0 mm Extreme 62
21 Dec 36.6 °C 21 % 38 km/h 0.0 mm Extreme 57
22 Dec 37.1 °C 25 % 40 km/h 0.0 mm Extreme 61
23 Dec 37.1 °C 24 % 43 km/h 0.0 mm Extreme 65
24 Dec 37.2 °C 22 % 38 km/h 0.1 mm Extreme 61
25 Dec 37.4 °C 22 % 40 km/h 0.0 mm Extreme 59
26 Dec 36.0 °C 21 % 37 km/h 0.0 mm Extreme 60
27 Dec after 35.5 °C 22 % 37 km/h 0.0 mm Extreme 58
28 Dec after 36.2 °C 20 % 36 km/h 0.0 mm Extreme 58
29 Dec after 37.7 °C 15 % 31 km/h 0.0 mm Extreme 55
30 Dec after 37.7 °C 17 % 34 km/h 0.0 mm Extreme 58
31 Dec after 38.2 °C 14 % 41 km/h 0.0 mm Extreme 67
1 Jan after 37.0 °C 16 % 39 km/h 0.0 mm Extreme 66
2 Jan after 37.7 °C 15 % 36 km/h 0.0 mm Extreme 59
3 Jan after 37.2 °C 17 % 38 km/h 0.0 mm Extreme 63
4 Jan after 37.0 °C 17 % 42 km/h 0.0 mm Extreme 68
5 Jan after 36.6 °C 16 % 38 km/h 0.0 mm Extreme 65

Its twins: fires that started in the same weather

It started with an FWI of 57.6, a minimum humidity of 18% and 15 days without rain. Fires in the area that started in weather like this since 2016: 16.

FWI at the start 57.6
Minimum humidity 18 %
Days without rain 15
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Yambio fire, December 2022
5,339 ha 13 days FWI 57.0 Min. humidity 18 % 210 km away, in 2022

First rain (1 mm or more) after it ended: none in the following ten days.

What happened to them

13 days
median duration
7,174 ha
median area
25 %
went past 10,000 ha
2.0 mm
rain at the end (median; 1 of 16 had it)

It burned an area similar to its twins (5,372 ha against a median of 7,174 ha) and lasted 9 days, against 13 days.

In 15 of 16, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.0 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
43km/h · max. gust

It was considered over on 26 Dec, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 1 of 16, with a median of 2.0 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 11 Dec 2016
After · 2 Jan 2017

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 126Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in South Sudan

Frequently asked questions

How long did the Rumbek East fire last?
GWIS (Copernicus) dates it between 18 December 2016 and 26 December 2016: 9 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 5,372 hectares (53.7 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 3 municipalities: Rumbek East (3,197 ha, 0.9 %); Yirol West (1,511 ha, 0.3 %); Wulu (698 ha, 0.1 %).
What was the weather like?
During the fire the temperature reached 37.4 °C, humidity dropped to 18 % and gusts hit 43 km/h. The fire danger index (FWI) reached 65, class Extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of South Sudan (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 16. Their median duration was 13 days and their median area 7,174 ha; 25 % went past 10,000 ha. In 15 of 16, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.0 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 126 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2015, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.