Skip to content
worldfires
IT · Italy · –

Roccella Ionica fire, 14 August 2019 Roccella Ionica

Out · last detection 16 Aug 2019, 11:53 UTC

The fire started on 14 August 2019 in Roccella Ionica, Italy, and satellites saw it burning for 3 days. Copernicus mapped a burnt perimeter of 168 hectares from satellite imagery, spread across a single municipality.

It is the 53th largest in Reggio di Calabria since 2016 (of 101 with a page). Number 43 in Italy in 2019, of 103.

The power measured by the satellite is low (13.2 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
168ha
Copernicus perimeter
Duration
3days
14 Aug 2019 – 16 Aug 2019
Municipalities hit
1
municipalities
Started on
14 Aug
2019
Heat detections
8
in a single hotspot: 13 MW
Danger at start
30
High · FWI index
Average daily power
38MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 14 Aug16 Aug
16 Aug 2019

How it evolved, day by day

14 Aug 2019 · 70 MW · 7 16 Aug 2019 · 5 MW · 1
14 Aug 16 Aug

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

28°high
58km/h · peak gust
54%lowest humidity

It had gone 28 days without rain (1 mm or more) when it started.

This area had burned before

24% of the perimeter overlaps earlier fires recorded since 2016: 40 ha in 2018.

What happened to each town

  1. Roccella Ionica where it started
    168 ha reached on 14 Aug
    4.5 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land56 %
  • Agricultural areas29 %
  • Sclerophyllous scrub14 %
  • Scrub and transitional woodland0.6 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with Strong wind: 15 % of the area in Italy

Day High Min. humidity Peak gust Rain Danger (FWI)
14 Aug 28.5 °C 61 % 58 km/h 0.0 mm High 30
15 Aug 27.6 °C 58 % 37 km/h 0.0 mm High 23
16 Aug 27.8 °C 54 % 32 km/h 0.0 mm High 22
17 Aug after 27.0 °C 58 % 23 km/h 0.0 mm Moderate 18
18 Aug after 27.5 °C 58 % 22 km/h 0.0 mm Moderate 20
19 Aug after 27.9 °C 58 % 22 km/h 0.0 mm Moderate 19
20 Aug after 28.7 °C 50 % 23 km/h 0.0 mm High 22
21 Aug after 29.6 °C 52 % 20 km/h 0.0 mm Moderate 20
22 Aug after 28.8 °C 59 % 21 km/h 0.0 mm High 22
23 Aug after 28.7 °C 61 % 27 km/h 0.0 mm High 25
24 Aug after 29.1 °C 57 % 18 km/h 0.0 mm Moderate 21
25 Aug after 29.0 °C 59 % 17 km/h 0.0 mm Moderate 19
26 Aug after 28.8 °C 59 % 16 km/h 0.0 mm Moderate 19

Its twins: fires that started in the same weather

It started with an FWI of 29.8, a minimum humidity of 61% and 28 days without rain. Fires in the area that started in weather like this since 2016: 42.

FWI at the start 29.8
Minimum humidity 61 %
Days without rain 28
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Reggio di Calabria fire, July 2021
113 ha 2 days FWI 28.0 Min. humidity 63 % 66 km away, in 2021

First rain (1 mm or more) after it ended: none in the following ten days.

What happened to them

2 days
median duration
144 ha
median area
2 %
went past 1,000 ha
2.8 mm
rain at the end (median; 25 of 42 had it)

It burned an area similar to its twins (168 ha against a median of 144 ha) and lasted 3 days, against 2 days.

In 17 of 42, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.8 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
58km/h · max. gust

It was considered over on 16 Aug, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 25 of 42, with a median of 2.8 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 7 Aug 2019
After · 23 Aug 2019

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 13 August 2019 the air beside the fire reached 19 µg/m³ of PM2.5. That day averaged 16: 1.0 times the WHO daily guideline (15).

PM2.5 peak19 µg/m³
Days over the guideline2 days
PM1030 µg/m³
12 Aug14 Aug16 Aug18 Aug
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 8Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Italy

Frequently asked questions

How long did the Roccella Ionica fire last?
Copernicus dates it between 14 August 2019 and 16 August 2019: 3 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 168 hectares (1.7 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Roccella Ionica (168 ha, 4.5 %).
What was the weather like?
During the fire the temperature reached 28.5 °C, humidity dropped to 54 % and gusts hit 58 km/h. The fire danger index (FWI) reached 30, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Italy (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 42. Their median duration was 2 days and their median area 144 ha; 2 % went past 1,000 ha. In 17 of 42, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.8 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 1515 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 1515.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 8 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM4 (Creative Commons Attribution 3.0 License). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.