Skip to content
worldfires
US · United States · →

Roberts Fire, May 2024 Monterey, San Luis Obispo

Out · last detection 18 May 2024, 20:52 UTC

The fire started on 17 May 2024 in Monterey, United States, and satellites saw it burning for 1 day. United States agencies (MTBS / NIFC) mapped an official burnt perimeter of 3,406 hectares, spread across 2 counties.

It is the 157th largest in California since 2016 (of 442 with a page). Number 102 in United States in 2024, of 371.

The power measured by the satellite is low (25.0 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
3,406ha
official perimeter (MTBS / NIFC)
Duration
1day
17 May 2024 – 17 May 2024
Municipalities hit
2
counties
Started on
17 May
2024
Heat detections
25
in a single hotspot: 25 MW
Danger at start
14
Moderate · FWI index
Energy released
14MW
sum of detected power

Where it burned

18 May 2024
HOTSPOTS BY DAY 17 May17 May

How it evolved, day by day

1718

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

22°high
34km/h · peak gust
47%lowest humidity

It had gone 12 days without rain (1 mm or more) when it started.

This area had burned before

1% of the perimeter overlaps earlier fires recorded since 2016: 34 ha in 2016.

What happened to each town

  1. Monterey where it started
    2,964 ha reached on 17 May
    0.4 %
  2. 425 ha reached on 20 May
    0.0 %

Burnt area inside each county, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
17 May 20.0 °C 58 % 34 km/h 0.0 mm Moderate 14
18 May after 18.8 °C 61 % 34 km/h 0.0 mm Moderate 13
19 May after 21.9 °C 47 % 32 km/h 0.0 mm Moderate 15
20 May after 19.8 °C 51 % 34 km/h 0.0 mm Moderate 15
21 May after 24.3 °C 35 % 32 km/h 0.0 mm Moderate 18
22 May after 24.4 °C 34 % 35 km/h 0.0 mm Moderate 21
23 May after 23.5 °C 41 % 34 km/h 0.0 mm High 21
24 May after 21.2 °C 39 % 43 km/h 0.0 mm High 25
25 May after 21.1 °C 48 % 35 km/h 0.0 mm Moderate 19
26 May after 23.3 °C 45 % 36 km/h 0.0 mm Moderate 20
27 May after 24.4 °C 44 % 35 km/h 0.0 mm Moderate 21
28 May after 25.9 °C 36 % 33 km/h 0.0 mm Moderate 21
29 May after 27.3 °C 30 % 24 km/h 0.0 mm High 23
30 May after 29.0 °C 28 % 32 km/h 0.0 mm High 27

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 10 May 2024
After · 24 May 2024

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 17 May 2024 the air beside the fire reached 11 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak11 µg/m³
Days over the guideline0 days
PM1018 µg/m³
Optical depth0.22
151617181920
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 25Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in United States ›

Frequently asked questions

How long did the Roberts fire last?
It burned between 17 May 2024 and 17 May 2024: 1 day, according to the start date recorded by United States agencies (MTBS / NIFC) and the heat detections seen by satellite.
How much area did it burn?
The official perimeter published by United States agencies (MTBS / NIFC) is 3,406 hectares (34.1 km²). Other tallies, such as daily incident reports, may give slightly different figures.
Which counties burned?
The fire entered 2 counties: Monterey (2,964 ha, 0.4 %); San Luis Obispo (425 ha, 0.0 %).
What was the weather like?
During the fire the temperature reached 21.9 °C, humidity dropped to 47 % and gusts hit 34 km/h. The fire danger index (FWI) reached 15, class Moderate.
Where does this data come from?
From the official burnt perimeter of United States agencies (MTBS / NIFC, public domain), NASA FIRMS VIIRS hotspots and the administrative boundaries of United States. It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 911

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 911.

Where this data comes from

The perimeter is official and in the public domain. For past years it comes from MTBS (Monitoring Trends in Burn Severity), run by the U.S. Geological Survey and the USDA Forest Service, which map it on Landsat and Sentinel-2 imagery. For the current and last year it comes from WFIGS at the National Interagency Fire Center (NIFC): incident perimeters mapped by fire crews, aircraft and imagery. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. County boundaries come from geoBoundaries ADM2 (Public Domain). The area per county is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from official figures.