Skip to content
worldfires
AO · Angola · –

Rivungo fire, 21 September 2020 Rivungo

Out · last detection 30 Sept 2020, 11:31 UTC

The fire started on 21 September 2020 in Rivungo, Angola, and satellites saw it burning for 9 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 7,624 hectares from heat detections, spread across a single municipality.

It is the 246th largest in Cuando Cubango since 2016 (of 504 with a page). Number 43 in Angola in 2020, of 123.

Burnt area
7,624ha
GWIS perimeter (Copernicus)
Duration
9days
21 Sept 2020 – 29 Sept 2020
Municipalities hit
1
municipalities
Started on
21 Sept
2020
Heat detections
271
in a single hotspot: 55 MW
Danger at start
62
Extreme · FWI index
Average daily power
418MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 21 Sept29 Sept
30 Sept 2020

How it evolved, day by day

23 Sept 2020 · 147 MW · 14 24 Sept 2020 · 47 MW · 6 25 Sept 2020 · 855 MW · 64 26 Sept 2020 · 1,480 MW · 109 27 Sept 2020 · 218 MW · 26 28 Sept 2020 · 506 MW · 42 29 Sept 2020 · 87 MW · 9 30 Sept 2020 · 4 MW · 1
23 Sept 26 Sept 29 Sept

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

38°high
50km/h · peak gust
7%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started.

This area had burned before

89% of the perimeter overlaps earlier fires recorded since 2016: 3,869 ha in 2016, 3,168 ha in 2017, 2,741 ha in 2018, 1,971 ha in 2019. Part of it burned more than once, so the yearly figures add up to more than the 6,810 ha that had burned before.

How big is it?

10 km
It burned the equivalent of 4.8% of the area of London (76 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Rivungo where it started
    7,695 ha reached on 23 Sept
    0.3 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with Very dry air: 41 % of the area in Angola 60 days without rain: 84 % of the area in Angola

Day High Min. humidity Peak gust Rain Danger (FWI)
21 Sept 36.9 °C 12 % 36 km/h 0.0 mm Extreme 62
22 Sept 37.0 °C 10 % 50 km/h 0.0 mm Very extreme 92
23 Sept 35.0 °C 16 % 45 km/h 0.0 mm Very extreme 77
24 Sept 35.3 °C 15 % 37 km/h 0.0 mm Extreme 70
25 Sept 37.0 °C 13 % 37 km/h 0.0 mm Extreme 58
26 Sept 36.8 °C 11 % 30 km/h 0.0 mm Extreme 60
27 Sept 37.6 °C 7 % 32 km/h 0.0 mm Extreme 56
28 Sept 37.3 °C 10 % 37 km/h 0.0 mm Extreme 60
29 Sept 37.1 °C 12 % 33 km/h 0.0 mm Extreme 66
30 Sept after 35.6 °C 19 % 39 km/h 0.0 mm Very extreme 72
1 Oct after 35.4 °C 19 % 28 km/h 0.0 mm Extreme 58
2 Oct after 35.6 °C 20 % 28 km/h 0.0 mm Extreme 58
3 Oct after 36.0 °C 18 % 24 km/h 0.0 mm Extreme 57
4 Oct after 38.5 °C 13 % 48 km/h 0.0 mm Very extreme 77
5 Oct after 39.0 °C 12 % 49 km/h 0.0 mm Very extreme 86
6 Oct after 38.5 °C 12 % 42 km/h 0.0 mm Very extreme 72
7 Oct after 37.0 °C 12 % 38 km/h 0.0 mm Extreme 70
8 Oct after 37.3 °C 16 % 51 km/h 0.0 mm Very extreme 77
9 Oct after 37.5 °C 9 % 36 km/h 0.0 mm Extreme 64

Its twins: fires that started in the same weather

It started with an FWI of 61.8, a minimum humidity of 12% and more than two months without rain. Fires in the area that started in weather like this since 2016: 20.

FWI at the start 61.8
Minimum humidity 12 %
Days without rain 60+
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Rivungo fire, September 2016
5,466 ha 10 days FWI 60.5 Min. humidity 12 % 15 km away, in 2016

First rain (1 mm or more) after it ended: none in the following ten days.

What happened to them

9 days
median duration
5,567 ha
median area
10 %
went past 10,000 ha
3.3 mm
rain at the end (median; 1 of 20 had it)

It burned an area similar to its twins (7,624 ha against a median of 5,567 ha) and lasted 9 days, against 9 days.

In 19 of 20, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.3 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
50km/h · max. gust

It was considered over on 29 Sept, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 1 of 20, with a median of 3.3 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 14 Sept 2020
After · 6 Oct 2020

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 271Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Angola

Frequently asked questions

How long did the Rivungo fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 21 September 2020 to 29 September 2020 (9 days). The perimeter dates it from 24 September 2020 to 28 September 2020.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 7,624 hectares (76.2 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Rivungo (7,695 ha, 0.3 %).
What was the weather like?
During the fire the temperature reached 37.6 °C, humidity dropped to 7 % and gusts hit 50 km/h. The fire danger index (FWI) reached 92, class Very extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Angola (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 20. Their median duration was 9 days and their median area 5,567 ha; 10 % went past 10,000 ha. In 19 of 20, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.3 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

History of this page · 2 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Last day with fire: 28 September 2020 → 29 September 2020.
  2. Start date: 24 September 2020 → 21 September 2020.

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 24 September 2020 to 28 September 2020. 271 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Public Domain). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.