Skip to content
worldfires
AR · Argentina · –

Rivadavia fire, September 2020 Rivadavia, Anta

Out · last detection

The fire started on in Rivadavia, Argentina, and satellites saw it burning for 14 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 2,281 hectares from heat detections, spread across 2 municipalities.

It is number 84 by size of the 215 fires with a page that started in Salta since 2016. Number 320 in Argentina in 2020, of 669.

Burnt area
2,281ha
GWIS perimeter (Copernicus)
Duration
14days
17 Sept 2020 – 30 Sept 2020
Municipalities hit
2
departments
Started on
17 Sept
2020
Heat detections
182
in a single hotspot: 169 MW
Danger at start
30
High · FWI index
Average daily power
306MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 17 Sept30 Sept
30 Sept 2020

How it evolved, day by day

17 Sept 2020 · 36 MW · 4 18 Sept 2020 · 496 MW · 20 19 Sept 2020 · 1,713 MW · 41 20 Sept 2020 · 237 MW · 16 21 Sept 2020 · 161 MW · 18 22 Sept 2020 · 705 MW · 21 23 Sept 2020 · 229 MW · 32 25 Sept 2020 · 161 MW · 7 26 Sept 2020 · 2 MW · 2 27 Sept 2020 · 25 MW · 8 28 Sept 2020 · 53 MW · 4 29 Sept 2020 · 128 MW · 6 30 Sept 2020 · 26 MW · 3
19 Sept 23 Sept 27 Sept 30 Sept

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

43°high
69km/h · peak gust
9%lowest humidity

It had gone 2 days without rain (1 mm or more) when it started.

This area had burned before

58% of the perimeter overlaps earlier fires recorded since 2016: 184 ha in 2017, 1,442 ha in 2018, 158 ha in 2019. Part of it burned more than once, so the yearly figures add up to more than the 1,327 ha that had burned before.

How big is it?

10 km
It burned the equivalent of 1.4% of the area of London (23 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Rivadavia where it started
    2,098 ha reached on 17 Sept
    0.1 %
  2. 216 ha
    0.0 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area0.10 ha
Residents< 20

Inside the perimeter there were about 0.10 hectares of built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with Very dry air: 14 % of the area in Argentina

Day High Min. humidity Peak gust Rain Danger (FWI)
17 Sept 33.5 °C 13 % 28 km/h 0.0 mm High 30
18 Sept 37.8 °C 10 % 40 km/h 0.0 mm Extreme 59
19 Sept 28.7 °C 15 % 67 km/h 0.0 mm Very extreme 108
20 Sept 26.4 °C 12 % 35 km/h 0.0 mm Very high 46
21 Sept 27.5 °C 11 % 29 km/h 0.0 mm Very high 44
22 Sept 32.0 °C 9 % 41 km/h 0.0 mm Extreme 62
23 Sept 35.5 °C 17 % 44 km/h 0.0 mm Very extreme 72
24 Sept 39.3 °C 24 % 55 km/h 0.0 mm Very extreme 85
25 Sept 42.5 °C 16 % 64 km/h 0.0 mm Very extreme 102
26 Sept 42.9 °C 18 % 56 km/h 0.2 mm Extreme 68
27 Sept 32.1 °C 15 % 69 km/h 0.1 mm Extreme 64
28 Sept 30.0 °C 16 % 37 km/h 0.0 mm Very high 43
29 Sept 35.5 °C 24 % 52 km/h 0.0 mm Very extreme 74
30 Sept 42.0 °C 19 % 43 km/h 0.0 mm Extreme 56
1 Oct after 40.5 °C 22 % 52 km/h 0.0 mm Very high 49
2 Oct after 31.8 °C 25 % 48 km/h 0.0 mm Very extreme 73
3 Oct after 23.8 °C 40 % 50 km/h 0.0 mm Very high 50
4 Oct after 25.5 °C 29 % 33 km/h 0.0 mm High 26
5 Oct after 25.4 °C 29 % 50 km/h 0.0 mm High 38
6 Oct after 31.5 °C 23 % 31 km/h 0.0 mm High 36
7 Oct after 35.8 °C 24 % 44 km/h 0.1 mm Very high 41
8 Oct after 37.1 °C 23 % 41 km/h 0.0 mm Extreme 55
9 Oct after 33.7 °C 16 % 45 km/h 0.0 mm Extreme 66
10 Oct after 36.3 °C 8 % 48 km/h 0.0 mm Very extreme 96

Its twins: fires that started in the same weather

It started with an FWI of 30.4, a minimum humidity of 13% and 2 days without rain. Fires in the area that started in weather like this since 2016: 24.

FWI at the start 30.4
Minimum humidity 13 %
Days without rain 2
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Anta fire, October 2016
2,152 ha 11 days FWI 30.5 Min. humidity 13 % 25 km away, in 2016

First rain (1 mm or more) after it ended: 12.8 mm on 11 Nov.

What happened to them

8 days
median duration
2,350 ha
median area
100 %
went past 1,000 ha
8.6 mm
rain at the end (median; 17 of 24 had it)

It burned an area similar to its twins (2,281 ha against a median of 2,350 ha) and lasted 14 days, against 8 days.

In 7 of 24, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 8.6 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
69km/h · max. gust

It was considered over on 30 Sept, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 17 of 24, with a median of 8.6 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 10 Sept 2020
After · 7 Oct 2020

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 182Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Argentina

Frequently asked questions

How long did the Rivadavia fire last?
GWIS (Copernicus) dates it between 17 September 2020 and 30 September 2020: 14 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 2,281 hectares (22.8 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Rivadavia (2,098 ha, 0.1 %); Anta (216 ha, 0.0 %).
What was the weather like?
During the fire the temperature reached 42.9 °C, humidity dropped to 9 % and gusts hit 69 km/h. The fire danger index (FWI) reached 108, class Very extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Argentina (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 24. Their median duration was 8 days and their median area 2,350 ha; 100 % went past 1,000 ha. In 7 of 24, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 8.6 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 911 · 100 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 911 · 100.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 182 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.