Skip to content
worldfires
BO · Bolivia · –

Reyes fire, October 2026 Reyes

Dying down · last detection 4 Nov 2026, 18:55 UTC

The fire started on 25 October 2026 in Reyes, Bolivia, and satellites saw it burning for 11 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 4,480 hectares from heat detections, spread across a single municipality.

Number 43 in Bolivia in 2026, of 82.

GWIS near-real-time perimeter, from the layer that changed in October 2025: this fire is not compared with fires from earlier years, because since then the GWIS layer gives more and larger perimeters.

The power measured by the satellite is low (17.1 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…

Is it still active?

No detections since 4 Nov 2026, 18:55 UTC. That usually means no flame is visible from space any more, although hotspots may remain. Satellites pass a few times a day and cloud or smoke can hide the fire: a lack of detections is not an official extinction. Each country’s emergency service declares a fire contained or out.

Wind, humidity and rain for the next 72 h

Burnt area
4,480ha
GWIS perimeter (Copernicus)
Duration
11days
25 Oct 2026 – 4 Nov 2026
Municipalities hit
1
municipalities
Started on
25 Oct
2026
Heat detections
94
in a single hotspot: 17 MW
Danger at start
11
Low · FWI index
Average daily power
66MW
detected power per day, on average

The next 72 hours

The wind is blowing from the north and pushing southwards; no sharp shifts are expected until Sun 8, 02:00.

ECMWF IFS 0.25° at the centre of the fire · computed 5 Nov 2026, 05:53 UTC

Thu 5, 10:00, local time

First useful rain: 3.6 mm in 6 h

Chance of rain up to 88 % in those hours. It can slow the fire at the surface, but that does not mean it will go out.

Checked, no warning: no wind shifts of more than 60° nights recover humidity (peaks of 90 % or more)

Hour by hour, local time

Tap the strip to see each hour

Mean wind Gusts where it blows to Relative humidity Night (8 pm to 8 am) Rain (mm) · chance in %

Where is it blowing? The next 48 h

geoBoundaries/GeoBolivia (Public Domain)

At this hour

Places the fan reaches

    Is it heading my way?

    We compare your point with the fan for each hour. Your location never leaves your device.

    or tap the map

    This is not an official warning. It is a global model forecast with cells of about 25 km, at the centre of the fire: it cannot see valley winds or the winds the fire itself creates. The fan shows where the wind blows, not where the fire will spread. If in doubt, follow what the authorities say.

    Emergencies · Bolivia 119 · 110 Emergency number and official warnings

    Forecast: ECMWF IFS 0.25° (European Centre for Medium-Range Weather Forecasts), served by our own Open-Meteo instance; the chance of rain comes from the ECMWF ensemble. Variables: wind and gusts at 10 m, wind at 850 hPa, relative humidity and temperature at 2 m, rain. Open-Meteo.com (CC BY 4.0).

    Fire: GWIS / Copernicus (reconstructed from VIIRS) (CC BY 4.0); hotspots from the last 24 h: VIIRS from NASA FIRMS. Boundaries: geoBoundaries/GeoBolivia (Public Domain).

    How it is worked out: wind shift = a change of more than 60° in 6 h or less, with at least 15 km/h before and after; no overnight recovery = peak humidity between 8 pm and 8 am stays below 55 %; useful rain = 2 mm or more in 6 h. The fan opens 18° plus however much the wind varies within ±3 h and reaches 25 km beyond the edge of the fire: one model cell, not a rate of spread. Methodology

    Where it burned

    HOTSPOTS BY DAY 25 Oct4 Nov
    4 Nov 2026

    How it evolved, day by day

    25 Oct 2026 · 0 MW · 0 26 Oct 2026 · 2 MW · 2 27 Oct 2026 · 8 MW · 5 28 Oct 2026 · 14 MW · 3 29 Oct 2026 · 37 MW · 9 30 Oct 2026 · 0 MW · 0 31 Oct 2026 · 0 MW · 0 1 Nov 2026 · 133 MW · 27 2 Nov 2026 · 94 MW · 12 3 Nov 2026 · 125 MW · 11 4 Nov 2026 · 117 MW · 25
    25 Oct 28 Oct 1 Nov

    Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

    The weather it burned in

    37°high
    40km/h · peak gust
    36%lowest humidity

    It had gone 2 days without rain (1 mm or more) when it started.

    This area had burned before

    67% of the perimeter overlaps earlier fires recorded since 2016: 435 ha in 2016, 1,349 ha in 2017, 527 ha in 2019, 438 ha in 2020, 890 ha in 2021, 226 ha in 2022, 1,802 ha in 2023, 1,292 ha in 2024. Part of it burned more than once, so the yearly figures add up to more than the 3,013 ha that had burned before.

    How big is it?

    10 km
    It burned the equivalent of 2.8% of the area of London (45 km² against 1,583 km²).

    London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

    This compares size, not location: both shapes are at the same scale, north up, centred on each other.

    What happened to each town

    1. Reyes 11,478 inhabitants where it started
      4,490 ha reached on 25 Oct
      0.4 %

    Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

    People and buildings inside the perimeter

    GHSL 2025
    Built-up area< 0.1 ha
    Residents< 20

    Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2025, satellite-based estimate).

    This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned. The GHSL 2025 epoch is a projection made from 2020 and earlier data.

    Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

    The weather day by day

    ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

    Open-Meteo.com (CC BY 4.0) · forecast models, provisional until the ERA5 reanalysis arrives

    Day High Min. humidity Peak gust Rain Danger (FWI)
    25 Oct 36.9 °C 36 % 40 km/h 1.5 mm Low 11
    26 Oct 28.4 °C 56 % 38 km/h 0.2 mm Low 10
    27 Oct 29.4 °C 62 % 27 km/h 0.1 mm Low 8
    28 Oct 31.4 °C 55 % 23 km/h 2.8 mm Very low 2
    29 Oct 27.3 °C 66 % 30 km/h 12.1 mm Very low 0
    30 Oct 30.1 °C 59 % 22 km/h 0.6 mm Very low 1
    31 Oct 33.1 °C 51 % 23 km/h 0.4 mm Low 5
    1 Nov 35.0 °C 46 % 35 km/h 0.7 mm Low 9
    2 Nov 33.0 °C 56 % 35 km/h 2.7 mm Very low 2
    3 Nov 35.7 °C 43 % 28 km/h 0.5 mm Low 9
    4 Nov 36.3 °C 43 % 35 km/h 2.8 mm Low 6

    Before and after, from space

    Drag the line to compare the same ground before the fire and after it.

    Before · 18 Oct 2026
    After · 4 Nov 2026

    If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

    The smoke

    CAMS · Copernicus

    On 27 October 2026 the air beside the fire reached 37 µg/m³ of PM2.5. That day averaged 26: 1.7 times the WHO daily guideline (15).

    PM2.5 peak37 µg/m³
    Days over the guideline7 days
    PM1038 µg/m³
    Optical depth0.81
    26 Oct28 Oct30 Oct1 Nov
    Good Fair Moderate Poor Very poor Extremely poor

    Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

    Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

    Detections table · 94Every satellite heat detection, one by one, with time, satellite, power and coordinates.
    ⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
    Date and timeSatelliteFRP (MW)LatLon

    Other fires nearby

    All fires in Bolivia

    Frequently asked questions

    How long did the Reyes fire last?
    According to the heat detections seen by satellite inside the perimeter, it burned from 25 October 2026 to 4 November 2026 (11 days). The perimeter dates it from 29 October 2026 to 4 November 2026.
    How much area did it burn?
    The perimeter GWIS (Copernicus) rebuilt from heat detections is 4,480 hectares (44.8 km²). It is an estimate: official national figures may differ.
    Which municipalities burned?
    The fire only entered Reyes (4,490 ha, 0.4 %).
    Is the Reyes fire still active?
    No fire detections since 4 Nov 2026, 18:55 UTC. A lack of detections is not an official extinction.
    What was the weather like?
    During the fire the temperature reached 36.9 °C, humidity dropped to 36 % and gusts hit 40 km/h. The fire danger index (FWI) reached 11, class Low.
    What weather is expected at the fire over the next 72 hours?
    The wind is blowing from the north and pushing southwards; no sharp shifts are expected until Sun 8, 02:00. First useful rain: 3.6 mm in 6 h (Thu 5, 10:00). Times are local time at the fire. ECMWF IFS forecast (Open-Meteo) computed 5 Nov 2026, 05:53 UTC; this is not an official warning.
    Where does this data come from?
    From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Bolivia (geoBoundaries). It is not an official report.

    Where to verify it

    A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

    Emergency number: 119 · 110 · Emergency number and official warnings

    Satellite cross-check

    History of this page · 3 Changes in area, dates, name, official record or merged pages, compared every night since 3 November 2026.
    1. Area: 3,219 → 3,829 ha.
    2. Start date: 28 October 2026 → 25 October 2026.
    3. Page published (3,219 ha).

    RSS Changes to this page With cross-checks and a citable version

    Does something look wrong on this page?

    This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

    Report an error
    What do you think is wrong?

    We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 119 · 110.

    How we know this
    • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
    • Dates adjusted with the VIIRS detections inside the perimeter, which said 29 October 2026 to 4 November 2026. 94 Suomi-NPP VIIRS detections on those dates.
    • We have not matched this page with any official record.
    • Weather: ECMWF IFS model, provisional until the ERA5 reanalysis arrives.
    • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2025, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

    How we build fire pages: methodology

    Where this data comes from

    The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Public Domain). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.