Skip to content
worldfires
SS · South Sudan · –

Raga fire, 9 November 2026 Raga

Dying down · last detection 16 Nov 2026, 11:53 UTC

The fire started on 9 November 2026 in Raga, South Sudan, and satellites saw it burning for 8 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 19,433 hectares from heat detections, spread across a single municipality.

Number 24 in South Sudan in 2026, of 262.

GWIS near-real-time perimeter, from the layer that changed in August 2025: this fire is not compared with fires from earlier years, because since then the GWIS layer gives more and larger perimeters.

Compare with…

Is it still active?

No detections since 16 Nov 2026, 11:53 UTC. That usually means no flame is visible from space any more, although hotspots may remain. Satellites pass a few times a day and cloud or smoke can hide the fire: a lack of detections is not an official extinction. Each country’s emergency service declares a fire contained or out.

Wind, humidity and rain for the next 72 h

Burnt area
19,433ha
GWIS perimeter (Copernicus)
Duration
8days
9 Nov 2026 – 16 Nov 2026
Municipalities hit
1
counties
Started on
9 Nov
2026
Heat detections
484
in a single hotspot: 105 MW
Danger at start
66
Extreme · FWI index
Average daily power
448MW
detected power per day, on average

The next 72 hours

The wind is blowing from the north-east and pushing to the south-west; no sharp shifts are expected until Fri 20, 02:00.

ECMWF IFS 0.25° at the centre of the fire · computed 17 Nov 2026, 00:21 UTC

Tue 17, 20:00 – Wed 18, 07:00, local time

No overnight recovery: humidity stays at or below 27 %

Nights usually moisten the vegetation and the fire calms down. Tonight humidity does not reach 55 %, so it may stay active in the small hours.

Wed 18, 20:00 – Thu 19, 07:00, local time

No overnight recovery: humidity stays at or below 25 %

Nights usually moisten the vegetation and the fire calms down. Tonight humidity does not reach 55 %, so it may stay active in the small hours.

Checked, no warning: no wind shifts of more than 60° no useful rain expected (0.0 mm in 72 h)

Hour by hour, local time

Tap the strip to see each hour

Mean wind Gusts where it blows to Relative humidity Night (8 pm to 8 am) Rain (mm) · chance in %

Where is it blowing? The next 48 h

geoBoundaries/South Sudan Information Management Working Group (IMWG), National Bureau of Statistics (NBS), and OCHA, OCHA South Sudan (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)); geoBoundaries/Agency for Technical Cooperation and Development (ACTED), OCHA Central African Republic (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO))

At this hour

Places the fan reaches

    Is it heading my way?

    We compare your point with the fan for each hour. Your location never leaves your device.

    or tap the map

    This is not an official warning. It is a global model forecast with cells of about 25 km, at the centre of the fire: it cannot see valley winds or the winds the fire itself creates. The fan shows where the wind blows, not where the fire will spread. If in doubt, follow what the authorities say.

    Forecast: ECMWF IFS 0.25° (European Centre for Medium-Range Weather Forecasts), served by our own Open-Meteo instance; the chance of rain comes from the ECMWF ensemble. Variables: wind and gusts at 10 m, wind at 850 hPa, relative humidity and temperature at 2 m, rain. Open-Meteo.com (CC BY 4.0).

    Fire: GWIS / Copernicus (reconstructed from VIIRS) (CC BY 4.0); hotspots from the last 24 h: VIIRS from NASA FIRMS. Boundaries: geoBoundaries/South Sudan Information Management Working Group (IMWG), National Bureau of Statistics (NBS), and OCHA, OCHA South Sudan (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)); geoBoundaries/Agency for Technical Cooperation and Development (ACTED), OCHA Central African Republic (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)).

    How it is worked out: wind shift = a change of more than 60° in 6 h or less, with at least 15 km/h before and after; no overnight recovery = peak humidity between 8 pm and 8 am stays below 55 %; useful rain = 2 mm or more in 6 h. The fan opens 18° plus however much the wind varies within ±3 h and reaches 25 km beyond the edge of the fire: one model cell, not a rate of spread. Methodology

    Where it burned

    HOTSPOTS BY DAY 9 Nov16 Nov
    16 Nov 2026

    How it evolved, day by day

    9 Nov 2026 · 0 MW · 0 10 Nov 2026 · 19 MW · 14 11 Nov 2026 · 27 MW · 14 12 Nov 2026 · 186 MW · 31 13 Nov 2026 · 356 MW · 60 14 Nov 2026 · 932 MW · 127 15 Nov 2026 · 1,454 MW · 179 16 Nov 2026 · 161 MW · 59
    9 Nov 11 Nov 13 Nov 15 Nov

    Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

    Fire front film How it spread from one satellite pass to the next (27 passes) and with what wind. Watch the film

    The weather it burned in

    38°high
    40km/h · peak gust
    9%lowest humidity

    It had gone 23 days without rain (1 mm or more) when it started.

    This area had burned before

    22% of the perimeter overlaps earlier fires recorded since 2016: 2,028 ha in 2016, 1,171 ha in 2017, 27 ha in 2018, 1,222 ha in 2019, 596 ha in 2020, 2,029 ha in 2021, 581 ha in 2023, 762 ha in 2024, 1,518 ha in 2025. Part of it burned more than once, so the yearly figures add up to more than the 4,369 ha that had burned before.

    How big is it?

    10 km
    It burned the equivalent of 12% of the area of London (194 km² against 1,583 km²).

    London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

    This compares size, not location: both shapes are at the same scale, north up, centred on each other.

    What happened to each town

    1. Raga where it started
      19,533 ha reached on 9 Nov
      0.3 %

    Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

    The weather day by day

    ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

    Open-Meteo.com (CC BY 4.0) · forecast models, provisional until the ERA5 reanalysis arrives

    Started with Very dry air: 33 % of the area in South Sudan

    Day High Min. humidity Peak gust Rain Danger (FWI)
    9 Nov 36.3 °C 14 % 36 km/h 0.0 mm Extreme 66
    10 Nov 34.3 °C 9 % 40 km/h 0.0 mm Very extreme 74
    11 Nov 34.7 °C 10 % 35 km/h 0.0 mm Extreme 62
    12 Nov 35.2 °C 11 % 24 km/h 0.0 mm Extreme 55
    13 Nov 35.9 °C 12 % 22 km/h 0.0 mm Extreme 53
    14 Nov 36.5 °C 11 % 34 km/h 0.0 mm Extreme 68
    15 Nov 37.0 °C 11 % 34 km/h 0.0 mm Very extreme 70
    16 Nov 37.8 °C 16 % 39 km/h 0.0 mm Very extreme 76

    Before and after, from space

    Drag the line to compare the same ground before the fire and after it.

    Before · 2 Nov 2026
    After · 16 Nov 2026

    If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

    The smoke

    CAMS · Copernicus

    On 31 October 2026 the air beside the fire reached 66 µg/m³ of PM2.5. That day averaged 48: 3.2 times the WHO daily guideline (15).

    PM2.5 peak66 µg/m³
    Days over the guideline12 days
    PM10171 µg/m³
    Optical depth0.82
    30 Oct2 Nov5 Nov8 Nov
    Good Fair Moderate Poor Very poor Extremely poor

    Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

    Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

    Detections table · 484Every satellite heat detection, one by one, with time, satellite, power and coordinates.
    ⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
    Date and timeSatelliteFRP (MW)LatLon

    Other fires nearby

    All fires in South Sudan

    Frequently asked questions

    How long did the Raga fire last?
    According to the heat detections seen by satellite inside the perimeter, it burned from 9 November 2026 to 16 November 2026 (8 days). The perimeter dates it from 12 November 2026 to 15 November 2026.
    How much area did it burn?
    The perimeter GWIS (Copernicus) rebuilt from heat detections is 19,433 hectares (194.3 km²). It is an estimate: official national figures may differ.
    Which municipalities burned?
    The fire only entered Raga (19,533 ha, 0.3 %).
    Is the Raga fire still active?
    No fire detections since 16 Nov 2026, 11:53 UTC. A lack of detections is not an official extinction.
    What was the weather like?
    During the fire the temperature reached 37.8 °C, humidity dropped to 9 % and gusts hit 40 km/h. The fire danger index (FWI) reached 76, class Very extreme.
    What weather is expected at the fire over the next 72 hours?
    The wind is blowing from the north-east and pushing to the south-west; no sharp shifts are expected until Fri 20, 02:00. No overnight recovery: humidity stays at or below 27 % (Tue 17, 20:00 – Wed 18, 07:00). No overnight recovery: humidity stays at or below 25 % (Wed 18, 20:00 – Thu 19, 07:00). Times are local time at the fire. ECMWF IFS forecast (Open-Meteo) computed 17 Nov 2026, 00:21 UTC; this is not an official warning.
    Where does this data come from?
    From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of South Sudan (geoBoundaries). It is not an official report.

    Where to verify it

    A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

    Satellite cross-check

    History of this page · 11 Changes in area, dates, name, official record or merged pages, compared every night since 11 November 2026.
    1. Area: 5,477 → 19,433 ha.
    2. Start date: 11 November 2026 → 9 November 2026.
    3. Mapped perimeter arrives: from ≈ 6,832 ha estimated from hotspots to 5,477 ha.
    4. Start date: 4 November 2026 → 11 November 2026.
    5. Area: ≈ 5,502 → ≈ 6,832 ha.
    6. Start date: 3 November 2026 → 4 November 2026.
    7. Area: ≈ 6,300 → ≈ 5,502 ha.
    8. Start date: 2 November 2026 → 3 November 2026.
    9. Area: ≈ 6,538 → ≈ 6,300 ha.
    10. Start date: 1 November 2026 → 2 November 2026.
    11. Page published (≈ 6,538 ha).

    RSS Changes to this page With cross-checks and a citable version

    Does something look wrong on this page?

    This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

    Report an error
    What do you think is wrong?

    We will only use your email to reply about this report. Privacy.

    How we know this
    • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
    • Dates adjusted with the VIIRS detections inside the perimeter, which said 12 November 2026 to 15 November 2026. 484 Suomi-NPP VIIRS detections on those dates.
    • We have not matched this page with any official record.
    • Weather: ECMWF IFS model, provisional until the ERA5 reanalysis arrives.

    How we build fire pages: methodology

    Where this data comes from

    The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.