Skip to content
worldfires
ES · Spain · –

Quintanilla del Coco fire, July 2022 Santo Domingo de Silos, Santibáñez del Val, Quintanilla del Coco

Out · last detection 25 Jul 2022, 01:34 UTC

The fire started on 24 July 2022 in Quintanilla del Coco, Spain, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 3,011 hectares from satellite imagery, spread across 7 municipalities.

Number 19 in Spain in 2022, of 196.

Burnt area
3,011ha
Copernicus perimeter
Duration
2days
24 Jul 2022 – 25 Jul 2022
Municipalities hit
7
municipalities
Started on
24 Jul
2022
Heat detections
28
in a single hotspot: 65 MW
Danger at start
59
Extreme · FWI index
Average daily power
366MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 24 Jul25 Jul
25 Jul 2022

How it evolved, day by day

24 Jul 2022 · 728 MW · 25 25 Jul 2022 · 4 MW · 3
24 Jul 25 Jul

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

36°high
50km/h · peak gust
10%lowest humidity

It had gone 6 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

How big is it?

10 km
It burned the equivalent of 1.9% of the area of London (30 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Santo Domingo de Silos 251 inhabitants · fire reached the centre
    1,482 ha reached on 25 Jul
    19 %
  2. Santibáñez del Val 64 inhabitants · fire reached the centre
    773 ha reached on 25 Jul
    52 %
  3. Quintanilla del Coco 50 inhabitants · fire reached the centre where it started
    742 ha reached on 24 Jul
    36 %
  4. Comunidad de Covarrubias, Quintanilla del Coco y Comunidad de Covarrubias, Quintanilla del Coco y * 2.0 km from the centre
    8 ha reached on 25 Jul
    0.5 %
  5. Contreras 81 inhabitants · 3.4 km from the centre
    6 ha
    0.2 %
  6. Tejada 35 inhabitants · 2.0 km from the centre
    2 ha
    0.1 %
  7. Carazo 42 inhabitants · 3.0 km from the centre
    1 ha
    0.0 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Agricultural areas30 %
  • Broadleaved forest23 %
  • Mixed forest20 %
  • Coniferous forest19 %
  • Scrub and transitional woodland7.1 %

Natura 2000 protected area affected: 100 %

Natura 2000 sites (European Environment Agency, 2024 release) crossed by the perimeter.

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

People and buildings inside the perimeter

GHSL 2020
Built-up area5.8 ha
Residents≈ 150

Inside the perimeter there were about 5.8 hectares of built-up land and about 150 residents (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

Official record

According to EGIF (MITECO), this fire started on 24 July 2022 and burned 1,808 ha (the satellite measured 3,011 ha). The two figures differ a lot, so these may not be exactly the same fire: take them as nearby records.

MITECO, Estadística General de Incendios Forestales (EGIF). This is the agency’s consolidated statistic: it measures the area in its own way, which is why it can differ from the satellite.

Checked against the press

Checked on 30 September 2026

We checked this page against 4 sources published once the fire was out. This is what they add:

Also known as
Incendio de Santibáñez del Val · Incendio de Santo Domingo de Silos · Incendio de Sabinares del Arlanza
Official area reported: 2,540 ha (the satellite measured 3,011 ha)
Declared extinguished: 14 August 2022

Sources

Official figures are measured differently from satellite ones and sometimes cover only part of the fire.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with Extreme FWI: 13 % of the area in Spain Very dry air: 15 % of the area in Spain

Day High Min. humidity Peak gust Rain Danger (FWI)
24 Jul 35.8 °C 10 % 50 km/h 0.0 mm Extreme 59
25 Jul 30.2 °C 19 % 38 km/h 0.0 mm Extreme 52
26 Jul after 28.8 °C 29 % 46 km/h 0.0 mm High 35
27 Jul after 30.5 °C 23 % 36 km/h 0.0 mm High 32
28 Jul after 31.1 °C 21 % 38 km/h 0.0 mm Very high 40
29 Jul after 29.5 °C 27 % 50 km/h 0.0 mm High 37
30 Jul after 32.6 °C 21 % 49 km/h 0.0 mm High 31
31 Jul after 33.0 °C 24 % 39 km/h 0.0 mm High 35
1 Aug after 34.2 °C 15 % 37 km/h 0.0 mm Very high 46
2 Aug after 35.9 °C 17 % 26 km/h 0.0 mm Very high 44
3 Aug after 34.0 °C 20 % 44 km/h 0.9 mm Very high 46
4 Aug after 34.5 °C 11 % 46 km/h 0.0 mm Very high 48

Its twins: fires that started in the same weather

It started with an FWI of 59.3, a minimum humidity of 10% and 6 days without rain. Fires in the area that started in weather like this since 2016: 24.

FWI at the start 59.3
Minimum humidity 10 %
Days without rain 6
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Budia fire, July 2022
185 ha 1 day FWI 60.9 Min. humidity 12 % 158 km away, in 2022

First rain (1 mm or more) after it ended: 6.8 mm on 6 Jul.

What happened to them

2 days
median duration
296 ha
median area
29 %
went past 1,000 ha
1.9 mm
rain at the end (median; 20 of 24 had it)

It was 10.2 times larger than the median of its twins and lasted 2 days, against 2 days.

Only 5 of its 24 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. In 4 of 24, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 1.9 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
50km/h · max. gust

It was considered over on 25 Jul, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 20 of 24, with a median of 1.9 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 17 Jul 2022
After · 1 Aug 2022

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 28Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Spain

Frequently asked questions

How long did the Quintanilla del Coco fire last?
Copernicus dates it between 24 July 2022 and 25 July 2022: 2 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 3,011 hectares (30.1 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 7 municipalities: Santo Domingo de Silos (1,482 ha, 19 %); Santibáñez del Val (773 ha, 52 %); Quintanilla del Coco (742 ha, 36 %); Comunidad de Covarrubias, Quintanilla del Coco y (8 ha, 0.5 %); Contreras (6 ha, 0.2 %); Tejada (2 ha, 0.1 %); Carazo (1 ha, 0.0 %).
Did the fire reach a town?
The fire started in Quintanilla del Coco and reached its centre: the point marking it was inside the burnt area or less than 500 metres from it. That does not mean houses burned.
What was the weather like?
During the fire the temperature reached 35.8 °C, humidity dropped to 10 % and gusts hit 50 km/h. The fire danger index (FWI) reached 59, class Extreme.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Spain (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 24. Their median duration was 2 days and their median area 296 ha; 29 % went past 1,000 ha. Only 5 of its 24 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. In 4 of 24, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 1.9 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 28 Suomi-NPP VIIRS detections on those dates.
  • Compared with EGIF (MITECO): 1,808 official ha against 3,011 ha of perimeter; similar, but with reservations.
  • Checked against news and agencies: 4 confirmed sources.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.