Skip to content
worldfires
MK · North Macedonia · →

Prilep fire, July 2026 Општина Прилеп · Prilep

Out · last detection 27 Jul 2026, 01:13 UTC

The fire started on 27 July 2026 in Prilep, North Macedonia, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 242 hectares from satellite imagery, spread across a single municipality.

It is the 42th largest in Pelagonia since 2016 (of 76 with a page). Number 21 in North Macedonia in 2026, of 40.

The power measured by the satellite is low (1.2 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
242ha
Copernicus perimeter
Duration
1day
27 Jul 2026 – 27 Jul 2026
Municipalities hit
1
municipalities
Started on
27 Jul
2026
Heat detections
3
in a single hotspot: 1 MW
Danger at start
56
Extreme · FWI index
Energy released
3MW
sum of detected power

Where it burned

HOTSPOTS BY DAY 27 Jul27 Jul

How it evolved, day by day

27

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

33°high
17km/h · peak gust
23%lowest humidity

It had gone 4 days without rain (1 mm or more) when it started.

This area had burned before

67% of the perimeter overlaps earlier fires recorded since 2016: 162 ha in 2017, 115 ha in 2024. Part of it burned more than once, so the yearly figures add up to more than the 163 ha that had burned before.

What happened to each town

  1. Prilep Општина Прилеп 69,025 inhabitants · 16.2 km from the town where it started
    242 ha reached on 27 Jul
    0.2 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Agricultural areas68 %
  • Scrub and transitional woodland26 %
  • Other natural land6.8 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
27 Jul 32.7 °C 23 % 17 km/h 0.4 mm Extreme 56
28 Jul after 28.1 °C 38 % 31 km/h 0.0 mm High 27
29 Jul after 29.4 °C 36 % 25 km/h 0.0 mm High 24
30 Jul after 29.9 °C 30 % 26 km/h 0.0 mm High 25
31 Jul after 30.4 °C 24 % 31 km/h 0.0 mm High 30
1 Aug after 30.1 °C 22 % 28 km/h 0.0 mm High 30
2 Aug after 30.5 °C 17 % 23 km/h 0.0 mm High 32
3 Aug after 30.8 °C 19 % 23 km/h 0.0 mm High 33
4 Aug after 31.1 °C 22 % 20 km/h 0.0 mm High 33
5 Aug after 31.8 °C 20 % 22 km/h 0.0 mm High 34
6 Aug after 32.0 °C 24 % 20 km/h 0.0 mm High 33

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 20 Jul 2026
After · 3 Aug 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 29 July 2026 the air beside the fire reached 13 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak13 µg/m³
Days over the guideline0 days
PM1022 µg/m³
Optical depth0.56
252627282930
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 3Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in North Macedonia ›

Frequently asked questions

How long did the Prilep fire last?
Copernicus dates it between 27 July 2026 and 27 July 2026: 1 day between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 242 hectares (2.4 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Prilep (242 ha, 0.2 %).
Did the fire reach a town?
The closest fire to a town centre came within 16.2 km of Prilep. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 32.7 °C, humidity dropped to 23 % and gusts hit 17 km/h. The fire danger index (FWI) reached 56, class Extreme.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of North Macedonia (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 193 · 112

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 193 · 112.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.