Skip to content
worldfires
UA · Ukraine · →

Polohy fire, 10 August 2024 Пологівський район · Polohy

Out · last detection 10 Aug 2024, 11:11 UTC

The fire started on 10 August 2024 in Polohy, Ukraine, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 122 hectares from satellite imagery, spread across a single municipality.

It is the 383th largest in Zaporizhzhia Oblast since 2016 (of 490 with a page). Number 1665 in Ukraine in 2024, of 2092.

The power measured by the satellite is low (13.7 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
122ha
Copernicus perimeter
Duration
1day
10 Aug 2024 – 10 Aug 2024
Municipalities hit
1
districts
Started on
10 Aug
2024
Heat detections
2
in a single hotspot: 14 MW
Danger at start
26
High · FWI index
Energy released
27MW
sum of detected power

Where it burned

HOTSPOTS BY DAY 10 Aug10 Aug

How it evolved, day by day

10

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

30°high
30km/h · peak gust
33%lowest humidity

It had gone 4 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Polohy Пологівський район 39,115 inhabitants · 9.4 km from the town where it started
    123 ha reached on 10 Aug
    0.1 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Agricultural areas70 %
  • Other natural land29 %
  • Mixed forest0.8 %
  • Artificial surfaces0.8 %

Land cover inside the perimeter as reported by Copernicus EFFIS (outside the Corine Land Cover area).

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
10 Aug 29.7 °C 33 % 30 km/h 0.0 mm High 26
11 Aug after 31.4 °C 33 % 38 km/h 0.0 mm High 33
12 Aug after 27.1 °C 28 % 45 km/h 0.2 mm High 36
13 Aug after 27.6 °C 28 % 42 km/h 0.0 mm High 35
14 Aug after 26.7 °C 28 % 38 km/h 0.0 mm High 32
15 Aug after 27.4 °C 30 % 33 km/h 0.0 mm High 32
16 Aug after 28.9 °C 26 % 32 km/h 0.0 mm High 32
17 Aug after 29.4 °C 26 % 22 km/h 0.0 mm High 28
18 Aug after 31.6 °C 20 % 27 km/h 0.0 mm High 35
19 Aug after 33.8 °C 14 % 30 km/h 0.0 mm Very high 43
20 Aug after 34.0 °C 18 % 32 km/h 0.0 mm Very high 45

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 3 Aug 2024
After · 17 Aug 2024

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 10 August 2024 the air beside the fire reached 15 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak15 µg/m³
Days over the guideline0 days
PM1017 µg/m³
Optical depth0.28
8910111213
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 2Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Ukraine ›

Frequently asked questions

How long did the Polohy fire last?
Copernicus dates it between 10 August 2024 and 10 August 2024: 1 day between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 122 hectares (1.2 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Polohy (123 ha, 0.1 %).
Did the fire reach a town?
The closest fire to a town centre came within 9.4 km of Polohy. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 29.7 °C, humidity dropped to 33 % and gusts hit 30 km/h. The fire danger index (FWI) reached 26, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Ukraine (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 101 · 112

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 101 · 112.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Public Domain). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.