Skip to content
worldfires
UA · Ukraine · →

Polohy fire, 3 July 2024 Пологівський район · Polohy

Out · last detection 3 Jul 2024, 11:23 UTC

The fire started on 3 July 2024 in Polohy, Ukraine, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 442 hectares from satellite imagery, spread across a single municipality.

It is the 54th largest in Zaporizhzhia Oblast since 2016 (of 490 with a page). Number 366 in Ukraine in 2024, of 2092.

The power measured by the satellite is low (20.8 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
442ha
Copernicus perimeter
Duration
1day
3 Jul 2024 – 3 Jul 2024
Municipalities hit
1
districts
Started on
3 Jul
2024
Heat detections
16
in a single hotspot: 21 MW
Danger at start
43
Very high · FWI index
Average daily power
225MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 3 Jul3 Jul

How it evolved, day by day

3 Jul 2024 · 225 MW · 16

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

34°high
41km/h · peak gust
21%lowest humidity

It had gone 15 days without rain (1 mm or more) when it started. Rain came after the fire: 1.3 mm on 5 Jul.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Polohy Пологівський район 39,115 inhabitants · 8.2 km from the town where it started
    442 ha reached on 3 Jul
    0.4 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Agricultural areas91 %
  • Other natural land7.4 %
  • Mixed forest1.8 %

Land cover inside the perimeter as reported by Copernicus EFFIS (outside the Corine Land Cover area).

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
3 Jul 34.5 °C 21 % 41 km/h 0.0 mm Very high 43
4 Jul after 33.3 °C 28 % 39 km/h 0.0 mm Very high 40
5 Jul after 34.3 °C 31 % 30 km/h 1.3 mm High 28

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 26 Jun 2024
After · 10 Jul 2024

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 4 July 2024 the air beside the fire reached 25 µg/m³ of PM2.5. That day averaged 17: 1.1 times the WHO daily guideline (15).

PM2.5 peak25 µg/m³
Days over the guideline2 days
PM1067 µg/m³
Optical depth0.50
123456
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 16Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Ukraine ›

Frequently asked questions

How long did the Polohy fire last?
Copernicus dates it between 3 July 2024 and 3 July 2024: 1 day between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 442 hectares (4.4 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Polohy (442 ha, 0.4 %).
Did the fire reach a town?
The closest fire to a town centre came within 8.2 km of Polohy. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 34.5 °C, humidity dropped to 21 % and gusts hit 41 km/h. The fire danger index (FWI) reached 43, class Very high.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Ukraine (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 101 · 112

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 101 · 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 16 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Public Domain). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.