Pokrovsk fire, 29 October 2026
Покровський район · Pokrovsk, Marinka
Out · last detection 30 Oct 2026, 00:54 UTC
Satellites first detected fire on 29 October 2026 in Pokrovsk, Ukraine. It was active for 2 days, with 14 heat detections and an area with fire of about 182 hectares rebuilt from them, spread across 2 municipalities.
matches the official recordwith caveatssatellite onlymodel
When copying, the sentence is
Tick the figures you want: they make up the lede and the CSV.
Burned area
satellite only
≈ 182ha
Estimated from hotspots: no perimeter has been published yet.
Source
NASA FIRMS · VIIRS
Date
29 Oct 2026 – 30 Oct 2026
+− cross-check
This is an estimate from the VIIRS pixels that saw fire. It will change when the perimeter is published.
Duration by satellite
satellite only
2days
29 Oct 2026 to 30 Oct 2026: first and last day with fire on the page.
Source
NASA FIRMS · VIIRS
Date
last detection: 30 Oct 2026, 00:54 UTC
+− cross-check
Satellites pass a few times a day and cloud or smoke can hide the fire: a lack of detections is not an official extinction. Each country’s emergency service declares a fire contained or out.
Start
satellite only
29 Oct 2026
First day with fire seen by the satellites or the perimeter.
Source
NASA FIRMS · VIIRS
Date
29 Oct 2026
+− cross-check
No official record is matched to this page, so the alert time and the cause are not known here.
Hotspots
satellite only
14
VIIRS detections at 375 m. Most intense hotspot: 42 MW.
Source
NASA FIRMS · VIIRS (Suomi NPP)
Date
29 Oct 2026 – 30 Oct 2026
+− cross-check
There is no official record to compare with. Each hotspot is a pixel detected in one satellite pass, not a separate fire.
The worst day
satellite only
208MW
Total radiative power on 29 October 2026; hotspots that day: 12.
Source
NASA FIRMS · VIIRS (FRP)
Date
29 Oct 2026
+− cross-check
Fire radiative power (FRP) measures the energy the fire gives off when the satellite passes. Added up by day, it compares intensity, not area.
Danger at the start
model
26.3FWI · high
Fire Weather Index (Canadian system) computed by WorldFires for the day the fire started. Consecutive days without rain before: 10.
This is an index computed from weather model data, not a measurement of the fire nor an official warning. Danger warnings are issued by each country’s authority. Emergency number and official warnings ›
Weather during the fire
model
16.4°C · 32% RH
High of 16.4 °C and minimum humidity of 32% on 29 October 2026; gusts of 54 km/h on 29 October 2026.
These are model values for a cell of about 25 km, not from a weather station: they may differ from what was measured on the ground.
ⓘThis page’s change log has been kept since 30 October 2026: every night what it publishes is compared and the difference is logged. Anything earlier is reconstructed from each source’s date and marked as reconstructed.
Show
· reconstructedweather
Weather and FWI computed from the ERA5 reanalysis
log
Last day with fire: 29 October 2026 → 30 October 2026.
A version keeps the area, dates, name and official record; the area as it was logged (changes under 2% are not logged). The map, hotspots and weather always show today’s data.
Citation
A lede of about 60 words figures only, no adjectives
Copernicus has not yet published the burnt perimeter, which takes a few days to measure on satellite imagery. For now the area is the one rebuilt from heat detections (about 14 hectares per pixel). When the perimeter arrives, this page picks it up on its own and keeps the same address.
Area with fire
≈ 182ha
rebuilt from hotspots, no official perimeter yet
Duration
2days
29 Oct 2026 – 30 Oct 2026
Municipalities hit
2
districts
Started on
29 Oct
2026
Heat detections
14
in a single hotspot: 42 MW
Danger at start
26
High · FWI index
Average daily power
208MW
detected power per day, on average
Where it burned
HOTSPOTS BY DAY
29 Oct30 Oct
Play back30 Oct 2026
How it evolved, day by day
29 Oct30 Oct
Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.
The weather it burned in
16°high
54km/h · peak gust
32%lowest humidity
It had gone 10 days without rain (1 mm or more) when it started. Rain came after the fire: 2.0 mm on 31 Oct.
What happened to each town
PokrovskПокровський район30,653 inhabitants · 15.0 km from the centrewhere it started
182 hareached on 29 Oct
0.1 %
MarinkaМар'їнський район90,434 inhabitants · 17.6 km from the centre
0 hareached on 30 Oct
0.0 %
Area with fire inside each municipality, rebuilt from heat detections (about 14 hectares per VIIRS pixel). An estimate until the official perimeter arrives. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.
The weather day by day
ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.
Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
It started with an FWI of 26.3, a minimum humidity of 32% and 10 days without rain. Fires in the area that started in weather like this since 2016: 83.
FWI at the start26.3
Minimum humidity32 %
Days without rain10
this firechosen twinsrest of the area
Almost identicalSimilar
Outlines of the closest twins
Shakhtarsk fire, August 2026
157 ha3 daysFWI 26.4Min. humidity 32 %51 km away, in 2026
First rain (1 mm or more) after it ended: none in the following ten days.
It burned an area similar to its twins (182 ha against a median of 167 ha) and lasted 2 days, against 3 days.
In 15 of 83, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.3 mm.
This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it
How it ended
2.0 mmfirst rain
31 Octthe day after it ended
54km/h · max. gust
It was considered over on 30 Oct, and on 31 Oct 2.0 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 68 of 83, with a median of 2.3 mm.
Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
How a twin is chosen
Same area: fires that have already ended, less than 250 km from this one, since 2016.
Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
They are sorted by similarity, and the outlines of the first five are drawn.
Drag the line to compare the same ground before the fire and after it.
↔
Before · 22 Oct 2026
After · 6 Nov 2026
Sentinel-2 did not pass over on that day. Try another date, or use false colour, which is daily.
If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.
The smoke
CAMS · Copernicus
On 27 October 2026 the air beside the fire reached 35 µg/m³ of PM2.5. That day averaged 25: 1.7 times the WHO daily guideline (15).
PM2.5 peak35µg/m³
Days over the guideline1day
PM1049µg/m³
Optical depth0.32
WHO 15
272829
GoodFairModeratePoorVery poorExtremely poor
Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.
Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)
Detections table· 14Every satellite heat detection, one by one, with time, satellite, power and coordinates.›
⬇ Download CSVTimes in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
According to the heat detections seen by satellite, it burned from 29 October 2026 to 30 October 2026 (2 days between the first and the last detection). There is no perimeter yet to date it.
How much area did it burn?
There is no official perimeter yet. Heat detections rebuild about 182 hectares with fire (1.8 km²); Copernicus will publish the measured figure within days.
Which municipalities burned?
The fire entered 2 municipalities: Pokrovsk (182 ha, 0.1 %); Marinka (0 ha, 0.0 %).
Is the Pokrovsk fire still active?
No fire detections since 30 Oct 2026, 00:54 UTC. A lack of detections is not an official extinction.
Did the fire reach a town?
The fire started in Pokrovsk and came within 15.0 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 16.4 °C, humidity dropped to 32 % and gusts hit 54 km/h. The fire danger index (FWI) reached 26, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Ukraine (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 83. Their median duration was 3 days and their median area 167 ha; 1 % went past 1,000 ha. In 15 of 83, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.3 mm.
Where to verify it
A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.
This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.
⚑Report an errorHow we know this›
No perimeter yet: the area (≈ 182 ha) is estimated by counting VIIRS pixels with fire, about 14 ha each.
Dates of the first and last VIIRS detection of the cluster. 14 Suomi-NPP VIIRS detections on those dates.
Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Public Domain). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.