Skip to content
worldfires
ZA · South Africa · →

Phumelela fire, October 2026 Phumelela

Out · last detection 2 Oct 2026, 11:21 UTC

The fire started on 1 October 2026 in Phumelela, South Africa, and satellites saw it burning for 2 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 2,337 hectares from heat detections, spread across a single municipality.

It is the 62th largest in Free State since 2016 (of 91 with a page). Number 116 in South Africa in 2026, of 149.

The power measured by the satellite is low (29.9 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
2,337ha
GWIS perimeter (Copernicus)
Duration
2days
1 Oct 2026 – 2 Oct 2026
Municipalities hit
1
municipalities
Started on
1 Oct
2026
Heat detections
28
in a single hotspot: 30 MW
Danger at start
0
Very low · FWI index
Average daily power
190MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 1 Oct2 Oct
2 Oct 2026

How it evolved, day by day

1 Oct 2026 · 312 MW · 22 2 Oct 2026 · 67 MW · 6
1 Oct 2 Oct

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

19°high
24km/h · peak gust
29%lowest humidity

It had gone 0 days without rain (1 mm or more) when it started.

This area had burned before

15% of the perimeter overlaps earlier fires recorded since 2016: 166 ha in 2018, 190 ha in 2019.

How big is it?

10 km
It burned the equivalent of 1.5% of the area of London (23 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Phumelela where it started
    2,344 ha
    0.3 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2025
Built-up area0.33 ha
Residents< 20

Inside the perimeter there were about 0.33 hectares of built-up land and almost nobody lived there (GHSL 2025, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned. The GHSL 2025 epoch is a projection made from 2020 and earlier data.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
1 Oct 15.3 °C 40 % 24 km/h 0.0 mm Very low 0
2 Oct 19.4 °C 29 % 20 km/h 0.0 mm Very low 1
3 Oct after 20.3 °C 26 % 23 km/h 0.0 mm Very low 4
4 Oct after 17.1 °C 42 % 36 km/h 0.0 mm Low 6
5 Oct after 20.2 °C 34 % 22 km/h 0.0 mm Low 6
6 Oct after 19.5 °C 46 % 41 km/h 0.4 mm Low 8
7 Oct after 20.3 °C 41 % 24 km/h 0.2 mm Low 7
8 Oct after 24.4 °C 35 % 47 km/h 0.0 mm Low 11
9 Oct after 27.4 °C 25 % 36 km/h 0.0 mm Moderate 13
10 Oct after 25.1 °C 32 % 32 km/h 0.4 mm Moderate 12
11 Oct after 25.4 °C 25 % 32 km/h 0.1 mm Moderate 13
12 Oct after 27.0 °C 25 % 27 km/h 0.0 mm Moderate 13

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 24 Sept 2026
After · 9 Oct 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 2 October 2026 the air beside the fire reached 62 µg/m³ of PM2.5. That day averaged 45: 3.0 times the WHO daily guideline (15).

PM2.5 peak62 µg/m³
Days over the guideline2 days
PM1064 µg/m³
Optical depth0.49
293012345
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 28Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in South Africa ›

Frequently asked questions

How long did the Phumelela fire last?
GWIS (Copernicus) dates it between 1 October 2026 and 2 October 2026: 2 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 2,337 hectares (23.4 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Phumelela (2,344 ha, 0.3 %).
Is the Phumelela fire still active?
No fire detections since 2 Oct 2026, 11:21 UTC. A lack of detections is not an official extinction.
What was the weather like?
During the fire the temperature reached 19.4 °C, humidity dropped to 29 % and gusts hit 24 km/h. The fire danger index (FWI) reached 1, class Very low.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of South Africa (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 10177 · 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 10177 · 112.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 28 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2025, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology ›

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.