Skip to content
worldfires
TH · Thailand · →

Phichai fire, December 2024 พิชัย · Phichai

Out · last detection 12 Dec 2024, 07:13 UTC

The fire started on 7 December 2024 in Phichai, Thailand, and satellites saw it burning for 6 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 1,108 hectares from heat detections, spread across a single municipality.

It is the 89th largest in Uttaradit Province since 2016 (of 104 with a page). Number 236 in Thailand in 2024, of 277.

The power measured by the satellite is low (14.7 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…

Suggestions: Phichai · 2021

Burnt area
1,108ha
GWIS perimeter (Copernicus)
Duration
6days
7 Dec 2024 – 12 Dec 2024
Municipalities hit
1
districts
Started on
7 Dec
2024
Heat detections
31
in a single hotspot: 15 MW
Danger at start
16
Moderate · FWI index
Average daily power
24MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 7 Dec12 Dec
12 Dec 2024

How it evolved, day by day

7 Dec 2024 · 11 MW · 3 8 Dec 2024 · 8 MW · 2 9 Dec 2024 · 19 MW · 5 10 Dec 2024 · 61 MW · 9 11 Dec 2024 · 17 MW · 5 12 Dec 2024 · 25 MW · 2
7 Dec 8 Dec 9 Dec 10 Dec 11 Dec 12 Dec

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

35°high
24km/h · peak gust
48%lowest humidity

It had gone 25 days without rain (1 mm or more) when it started. Rain came after the fire: 1.0 mm on 13 Dec.

This area had burned before

90% of the perimeter overlaps earlier fires recorded since 2016: 40 ha in 2016, 299 ha in 2017, 297 ha in 2019, 517 ha in 2020, 701 ha in 2021, 238 ha in 2022, 208 ha in 2023. Part of it burned more than once, so the yearly figures add up to more than the 1,001 ha that had burned before.

How big is it?

10 km
It burned the equivalent of 0.7% of the area of London (11 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Phichai พิชัย where it started
    1,114 ha
    1.4 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
1 Dec 31.7 °C 53 % 15 km/h 0.0 mm Moderate 16
2 Dec 32.8 °C 53 % 15 km/h 0.0 mm Moderate 16
3 Dec 34.2 °C 51 % 14 km/h 0.0 mm Moderate 16
4 Dec 34.8 °C 49 % 13 km/h 0.0 mm Moderate 16
5 Dec 33.8 °C 52 % 15 km/h 0.0 mm Moderate 16
6 Dec 33.8 °C 50 % 18 km/h 0.0 mm Moderate 17
7 Dec 34.4 °C 49 % 17 km/h 0.0 mm Moderate 17
8 Dec 34.4 °C 48 % 24 km/h 0.0 mm Moderate 18
9 Dec 32.9 °C 50 % 16 km/h 0.0 mm Moderate 18
10 Dec 33.1 °C 53 % 14 km/h 0.0 mm Moderate 17
11 Dec 33.8 °C 50 % 21 km/h 0.0 mm Moderate 20
12 Dec 33.7 °C 52 % 18 km/h 0.0 mm Moderate 18
13 Dec after 32.2 °C 56 % 18 km/h 1.0 mm Moderate 11

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 30 Nov 2024
After · 19 Dec 2024

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 10 December 2024 the air beside the fire reached 26 µg/m³ of PM2.5. That day averaged 20: 1.4 times the WHO daily guideline (15).

PM2.5 peak26 µg/m³
Days over the guideline5 days
PM1026 µg/m³
Optical depth0.41
56789101112131415
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 31Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Frequently asked questions

How long did the Phichai fire last?
GWIS (Copernicus) dates it between 7 December 2024 and 12 December 2024: 6 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 1,108 hectares (11.1 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Phichai (1,114 ha, 1.4 %).
What was the weather like?
During the fire the temperature reached 34.8 °C, humidity dropped to 48 % and gusts hit 24 km/h. The fire danger index (FWI) reached 20, class Moderate.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Thailand (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 199 · 191 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 199 · 191.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 31 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.