Skip to content
worldfires
UA · Ukraine · →

Perevalsk fire, July 2022 Перевальський район · Perevalsk

Out · last detection 3 Jul 2022, 00:02 UTC

The fire started on 2 July 2022 in Perevalsk, Ukraine, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 791 hectares from satellite imagery, spread across a single municipality.

It is the 91th largest in Luhansk Oblast since 2016 (of 909 with a page). Number 48 in Ukraine in 2022, of 531.

The power measured by the satellite is low (18.8 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
791ha
Copernicus perimeter
Duration
2days
2 Jul 2022 – 3 Jul 2022
Municipalities hit
1
districts
Started on
2 Jul
2022
Heat detections
18
in a single hotspot: 19 MW
Danger at start
33
High · FWI index
Average daily power
76MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 2 Jul3 Jul
3 Jul 2022

How it evolved, day by day

2 Jul 2022 · 152 MW · 17 3 Jul 2022 · 1 MW · 1
2 Jul 3 Jul

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

25°high
50km/h · peak gust
28%lowest humidity

It had gone 6 days without rain (1 mm or more) when it started. Rain came after the fire: 21.6 mm on 11 Jul.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

How big is it?

10 km
It burned the equivalent of 0.5% of the area of London (7.9 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Perevalsk Перевальський район 69,738 inhabitants · 15.5 km from the centre where it started
    792 ha reached on 2 Jul
    1.0 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land97 %
  • Mixed forest2.8 %
  • Agricultural areas0.5 %

Land cover inside the perimeter as reported by Copernicus EFFIS (outside the Corine Land Cover area).

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
2 Jul 23.3 °C 28 % 50 km/h 0.0 mm High 33
3 Jul 25.1 °C 32 % 38 km/h 0.0 mm High 28
4 Jul after 29.2 °C 34 % 26 km/h 0.0 mm High 24
5 Jul after 30.0 °C 36 % 23 km/h 0.0 mm High 24
6 Jul after 31.1 °C 27 % 29 km/h 0.0 mm High 29
7 Jul after 30.9 °C 22 % 31 km/h 0.0 mm High 32
8 Jul after 30.4 °C 24 % 35 km/h 0.0 mm High 36
9 Jul after 32.2 °C 23 % 37 km/h 0.0 mm High 36
10 Jul after 32.0 °C 23 % 52 km/h 0.7 mm Very high 43
11 Jul after 24.9 °C 55 % 45 km/h 21.6 mm Very low 2

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 25 Jun 2022
After · 10 Jul 2022

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 5 July 2022 the air beside the fire reached 17 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak17 µg/m³
Days over the guideline0 days
PM1020 µg/m³
30123456
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 18Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Ukraine ›

Frequently asked questions

How long did the Perevalsk fire last?
Copernicus dates it between 2 July 2022 and 3 July 2022: 2 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 791 hectares (7.9 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Perevalsk (792 ha, 1.0 %).
Did the fire reach a town?
The fire started in Perevalsk and came within 15.5 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 25.1 °C, humidity dropped to 28 % and gusts hit 50 km/h. The fire danger index (FWI) reached 33, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Ukraine (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 101 · 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 101 · 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 18 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Public Domain). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.