Skip to content
worldfires
UA · Ukraine · →

Pavlohrad fire, September 2026 Павлоградський район · Ukraine

Out · last detection 29 Sept 2026, 11:17 UTC

Satellites first detected fire on 29 September 2026 in Pavlohrad, Ukraine. It was active for 1 day, with 3 heat detections and an area with fire of about 182 hectares rebuilt from them, spread across a single municipality.

The power measured by the satellite is low (14.9 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…

Copernicus has not yet published the burnt perimeter, which takes a few days to measure on satellite imagery. For now the area is the one rebuilt from heat detections (about 14 hectares per pixel). When the perimeter arrives, this page picks it up on its own and keeps the same address.

Area with fire
≈ 182ha
rebuilt from hotspots, no official perimeter yet
Duration
1day
29 Sept 2026 – 29 Sept 2026
Municipalities hit
0
districts
Started on
29 Sept
2026
Heat detections
3
in a single hotspot: 15 MW
Danger at start
14
Moderate · FWI index
Average daily power
25MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 29 Sept29 Sept

How it evolved, day by day

29 Sept 2026 · 25 MW · 3

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

28°high
34km/h · peak gust
30%lowest humidity

It had gone 2 days without rain (1 mm or more) when it started. Rain came after the fire: 4.0 mm on 22 Sept.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
18 Sept 23.8 °C 37 % 12 km/h 0.0 mm Moderate 14
19 Sept 26.0 °C 30 % 19 km/h 0.0 mm Moderate 21
20 Sept 27.5 °C 31 % 15 km/h 0.0 mm Moderate 20
21 Sept 26.9 °C 34 % 34 km/h 1.0 mm Moderate 21
22 Sept 20.5 °C 48 % 28 km/h 4.0 mm Very low 4

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 22 Sept 2026
After · 6 Oct 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 19 September 2026 the air beside the fire reached 17 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak17 µg/m³
Days over the guideline0 days
PM1020 µg/m³
Optical depth0.32
161718192021
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 3Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Ukraine ›

Frequently asked questions

How long did the Pavlohrad fire last?
According to the heat detections seen by satellite, it burned from 29 September 2026 to 29 September 2026 (1 day between the first and the last detection). There is no perimeter yet to date it.
How much area did it burn?
There is no official perimeter yet. Heat detections rebuild about 182 hectares with fire (1.8 km²); Copernicus will publish the measured figure within days.
What was the weather like?
During the fire the temperature reached 27.5 °C, humidity dropped to 30 % and gusts hit 34 km/h. The fire danger index (FWI) reached 21, class Moderate.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Ukraine (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 101 · 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 101 · 112.

How we know this
  • No perimeter yet: the area (≈ 182 ha) is estimated by counting VIIRS pixels with fire, about 14 ha each.
  • Dates of the first and last VIIRS detection of the cluster. 3 Suomi-NPP VIIRS detections on those dates.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Public Domain). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.