Skip to content
worldfires
SS · South Sudan · –

Panyikang fire, 18 December 2017 Malakal, Panyikang

Out · last detection 8 Jan 2018, 11:13 UTC

The fire started on 18 December 2017 in Panyikang, South Sudan, and satellites saw it burning for 21 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 6,781 hectares from heat detections, spread across 2 municipalities.

It is the 133th largest in Upper Nile since 2016 (of 238 with a page). Number 109 in South Sudan in 2017, of 203.

Burnt area
6,781ha
GWIS perimeter (Copernicus)
Duration
21days
18 Dec 2017 – 7 Jan 2018
Municipalities hit
2
counties
Started on
18 Dec
2017
Heat detections
225
in a single hotspot: 66 MW
Danger at start
76
Very extreme · FWI index
Average daily power
136MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 18 Dec7 Jan
8 Jan 2018

How it evolved, day by day

19 Dec 2017 · 6 MW · 2 20 Dec 2017 · 6 MW · 1 21 Dec 2017 · 89 MW · 14 23 Dec 2017 · 355 MW · 16 24 Dec 2017 · 82 MW · 18 25 Dec 2017 · 567 MW · 64 26 Dec 2017 · 155 MW · 18 28 Dec 2017 · 10 MW · 5 29 Dec 2017 · 137 MW · 15 30 Dec 2017 · 220 MW · 19 31 Dec 2017 · 73 MW · 17 1 Jan 2018 · 32 MW · 6 4 Jan 2018 · 216 MW · 24 5 Jan 2018 · 87 MW · 5 8 Jan 2018 · 6 MW · 1
19 Dec 25 Dec 30 Dec 4 Jan

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

40°high
48km/h · peak gust
9%lowest humidity

It had gone 34 days without rain (1 mm or more) when it started.

This area had burned before

33% of the perimeter overlaps earlier fires recorded since 2016: 2,260 ha in 2016.

How big is it?

10 km
It burned the equivalent of 4.3% of the area of London (68 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. 4,915 ha reached on 23 Dec
    6.5 %
  2. Panyikang where it started
    1,910 ha reached on 19 Dec
    0.4 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2015
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2015, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
18 Dec 38.5 °C 15 % 40 km/h 0.0 mm Very extreme 76
19 Dec 39.0 °C 13 % 41 km/h 0.0 mm Very extreme 77
20 Dec 39.3 °C 12 % 32 km/h 0.0 mm Extreme 66
21 Dec 40.0 °C 11 % 30 km/h 0.0 mm Extreme 70
22 Dec 38.9 °C 10 % 28 km/h 0.0 mm Extreme 65
23 Dec 39.1 °C 10 % 37 km/h 0.0 mm Very extreme 78
24 Dec 39.4 °C 10 % 38 km/h 0.0 mm Very extreme 82
25 Dec 37.3 °C 14 % 46 km/h 0.0 mm Very extreme 89
26 Dec 37.2 °C 14 % 47 km/h 0.0 mm Very extreme 86
27 Dec 37.8 °C 14 % 46 km/h 0.0 mm Very extreme 84
28 Dec 38.7 °C 13 % 44 km/h 0.0 mm Very extreme 81
29 Dec 39.1 °C 10 % 46 km/h 0.0 mm Very extreme 93
30 Dec 38.4 °C 10 % 48 km/h 0.0 mm Very extreme 95
31 Dec 37.2 °C 13 % 46 km/h 0.0 mm Very extreme 92
1 Jan 34.1 °C 15 % 48 km/h 0.0 mm Very extreme 85
2 Jan 33.1 °C 17 % 44 km/h 0.0 mm Very extreme 76
3 Jan 34.2 °C 18 % 42 km/h 0.0 mm Very extreme 74
4 Jan 33.7 °C 15 % 46 km/h 0.0 mm Very extreme 80
5 Jan 33.6 °C 14 % 45 km/h 0.0 mm Very extreme 79
6 Jan 34.0 °C 13 % 43 km/h 0.0 mm Very extreme 78
7 Jan 34.6 °C 9 % 46 km/h 0.0 mm Very extreme 88
8 Jan after 35.3 °C 10 % 46 km/h 0.0 mm Very extreme 85
9 Jan after 35.5 °C 11 % 45 km/h 0.0 mm Very extreme 85
10 Jan after 36.6 °C 11 % 44 km/h 0.0 mm Very extreme 83
11 Jan after 37.8 °C 10 % 40 km/h 0.0 mm Very extreme 78
12 Jan after 38.1 °C 12 % 48 km/h 0.0 mm Very extreme 92
13 Jan after 39.6 °C 10 % 47 km/h 0.0 mm Very extreme 90
14 Jan after 38.6 °C 11 % 50 km/h 0.0 mm Very extreme 95
15 Jan after 36.7 °C 10 % 50 km/h 0.0 mm Very extreme 92
16 Jan after 36.3 °C 14 % 46 km/h 0.0 mm Very extreme 80
17 Jan after 36.7 °C 11 % 45 km/h 0.0 mm Very extreme 76

Its twins: fires that started in the same weather

It started with an FWI of 75.5, a minimum humidity of 15% and 34 days without rain. Fires in the area that started in weather like this since 2016: 25.

FWI at the start 75.5
Minimum humidity 15 %
Days without rain 34
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Baliet fire, December 2021
13,698 ha 5 days FWI 75.6 Min. humidity 14 % 27 km away, in 2021

First rain (1 mm or more) after it ended: none in the following ten days.

What happened to them

8 days
median duration
6,350 ha
median area
24 %
went past 10,000 ha
—
rain at the end (median; 0 of 25 had it)

It burned an area similar to its twins (6,781 ha against a median of 6,350 ha) and lasted 21 days, against 8 days.

In none of them did 1 mm fall in the ten days after the end: they all went out without rain.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
48km/h · max. gust

It was considered over on 7 Jan, and not even 1 mm fell in the following ten days: it went out without rain. None of its 25 twins had rain when they ended.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 11 Dec 2017
After · 14 Jan 2018

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 225Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in South Sudan

Frequently asked questions

How long did the Panyikang fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 18 December 2017 to 7 January 2018 (21 days). The perimeter dates it from 19 December 2017 to 1 January 2018.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 6,781 hectares (67.8 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Malakal (4,915 ha, 6.5 %); Panyikang (1,910 ha, 0.4 %).
What was the weather like?
During the fire the temperature reached 40.0 °C, humidity dropped to 9 % and gusts hit 48 km/h. The fire danger index (FWI) reached 95, class Very extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of South Sudan (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 25. Their median duration was 8 days and their median area 6,350 ha; 24 % went past 10,000 ha. In none of them did 1 mm fall in the ten days after the end: they all went out without rain.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

History of this page · 2 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Last day with fire: 1 January 2018 → 7 January 2018.
  2. Start date: 19 December 2017 → 18 December 2017.

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 19 December 2017 to 1 January 2018. 225 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2015, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.