Skip to content
worldfires
MM · Myanmar · –

Paletwa fire, 3 April 2021 Paletwa

Out · last detection 13 Apr 2021, 07:20 UTC

The fire started on 3 April 2021 in Paletwa, Myanmar, and satellites saw it burning for 11 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 2,361 hectares from heat detections, spread across a single municipality.

It is the 160th largest in Chin since 2016 (of 209 with a page). Number 139 in Myanmar in 2021, of 190.

Burnt area
2,361ha
GWIS perimeter (Copernicus)
Duration
11days
3 Apr 2021 – 13 Apr 2021
Municipalities hit
1
municipalities
Started on
3 Apr
2021
Heat detections
70
in a single hotspot: 98 MW
Danger at start
47
Very high · FWI index
Average daily power
350MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 3 Apr13 Apr
13 Apr 2021

How it evolved, day by day

3 Apr 2021 · 328 MW · 9 6 Apr 2021 · 103 MW · 8 7 Apr 2021 · 579 MW · 14 9 Apr 2021 · 514 MW · 16 10 Apr 2021 · 694 MW · 16 11 Apr 2021 · 227 MW · 5 13 Apr 2021 · 9 MW · 2
3 Apr 7 Apr 10 Apr 13 Apr

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

41°high
45km/h · peak gust
15%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started.

This area had burned before

97% of the perimeter overlaps earlier fires recorded since 2016: 1,838 ha in 2016, 860 ha in 2017, 977 ha in 2018, 2,053 ha in 2019, 907 ha in 2020. Part of it burned more than once, so the yearly figures add up to more than the 2,283 ha that had burned before.

How big is it?

10 km
It burned the equivalent of 1.5% of the area of London (24 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Paletwa where it started
    2,379 ha reached on 3 Apr
    0.3 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with 60 days without rain: 24 % of the area in Myanmar

Day High Min. humidity Peak gust Rain Danger (FWI)
3 Apr 41.0 °C 21 % 34 km/h 0.0 mm Very high 47
4 Apr 39.8 °C 15 % 28 km/h 0.0 mm Very high 43
5 Apr 37.5 °C 21 % 30 km/h 0.8 mm Very high 48
6 Apr 36.9 °C 28 % 37 km/h 0.0 mm High 32
7 Apr 37.5 °C 30 % 34 km/h 0.0 mm High 34
8 Apr 38.7 °C 25 % 38 km/h 0.0 mm High 36
9 Apr 38.0 °C 32 % 35 km/h 0.0 mm High 37
10 Apr 38.9 °C 32 % 34 km/h 0.4 mm High 38
11 Apr 39.0 °C 36 % 33 km/h 0.2 mm High 37
12 Apr 40.2 °C 27 % 42 km/h 0.0 mm Very high 43
13 Apr 39.2 °C 32 % 45 km/h 0.0 mm Very high 42
14 Apr after 39.7 °C 27 % 34 km/h 0.0 mm Very high 43
15 Apr after 39.7 °C 26 % 36 km/h 0.0 mm Very high 42
16 Apr after 34.3 °C 45 % 22 km/h 0.0 mm High 31
17 Apr after 33.6 °C 29 % 28 km/h 0.1 mm High 31
18 Apr after 38.6 °C 28 % 36 km/h 0.0 mm Very high 40
19 Apr after 36.7 °C 38 % 29 km/h 0.0 mm High 36
20 Apr after 39.3 °C 29 % 37 km/h 0.0 mm Very high 38
21 Apr after 41.1 °C 23 % 34 km/h 0.0 mm Very high 42
22 Apr after 39.9 °C 25 % 45 km/h 0.0 mm Very high 46
23 Apr after 39.3 °C 30 % 40 km/h 0.0 mm Very high 47

Its twins: fires that started in the same weather

It started with an FWI of 47.0, a minimum humidity of 21% and more than two months without rain. Fires in the area that started in weather like this since 2016: 17.

FWI at the start 47.0
Minimum humidity 21 %
Days without rain 60+
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

S' Bungtlang fire, March 2021
5,137 ha 7 days FWI 45.9 Min. humidity 20 % 56 km away, in 2021

First rain (1 mm or more) after it ended: none in the following ten days.

What happened to them

10 days
median duration
4,356 ha
median area
6 %
went past 10,000 ha
2.6 mm
rain at the end (median; 12 of 17 had it)

It stayed below its twins: 2,361 ha against a median of 4,356 ha. It lasted 11 days, against 10 days.

In 5 of 17, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.6 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
45km/h · max. gust

It was considered over on 13 Apr, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 12 of 17, with a median of 2.6 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 27 Mar 2021
After · 20 Apr 2021

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 70Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Myanmar

Frequently asked questions

How long did the Paletwa fire last?
GWIS (Copernicus) dates it between 3 April 2021 and 13 April 2021: 11 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 2,361 hectares (23.6 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Paletwa (2,379 ha, 0.3 %).
What was the weather like?
During the fire the temperature reached 41.0 °C, humidity dropped to 15 % and gusts hit 45 km/h. The fire danger index (FWI) reached 48, class Very high.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Myanmar (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 17. Their median duration was 10 days and their median area 4,356 ha; 6 % went past 10,000 ha. In 5 of 17, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.6 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 70 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution 4.0 (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.