Skip to content
worldfires
DZ · Algeria · →

Ouled Rabah fire, July 2017 أولاد رابح · Ouled Rabah

Out · last detection 14 Jul 2017, 00:38 UTC

The fire started on 13 July 2017 in Ouled Rabah, Algeria, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 465 hectares from satellite imagery, spread across a single municipality.

It is the 19th largest in Jijel since 2016 (of 110 with a page). Number 40 in Algeria in 2017, of 173.

The power measured by the satellite is low (17.3 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
465ha
Copernicus perimeter
Duration
2days
13 Jul 2017 – 14 Jul 2017
Municipalities hit
1
communes
Started on
13 Jul
2017
Heat detections
9
in a single hotspot: 17 MW
Danger at start
32
High · FWI index
Average daily power
48MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 13 Jul14 Jul
14 Jul 2017

How it evolved, day by day

13 Jul 2017 · 90 MW · 6 14 Jul 2017 · 5 MW · 3
13 Jul 14 Jul

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

31°high
35km/h · peak gust
33%lowest humidity

It had gone 36 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Ouled Rabah أولاد رابح 10,681 inhabitants · 1.5 km from the town where it started
    466 ha reached on 13 Jul
    6.0 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land64 %
  • Mixed forest30 %
  • Agricultural areas5.6 %

Land cover inside the perimeter as reported by Copernicus EFFIS (outside the Corine Land Cover area).

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
13 Jul 31.2 °C 33 % 31 km/h 0.0 mm High 32
14 Jul 28.7 °C 37 % 35 km/h 0.0 mm High 30
15 Jul after 26.7 °C 39 % 37 km/h 0.0 mm High 28
16 Jul after 24.6 °C 41 % 42 km/h 0.0 mm High 28
17 Jul after 25.8 °C 41 % 34 km/h 0.0 mm High 26
18 Jul after 29.0 °C 36 % 34 km/h 0.0 mm High 26
19 Jul after 31.2 °C 31 % 33 km/h 0.0 mm High 29
20 Jul after 28.1 °C 38 % 36 km/h 0.0 mm High 29
21 Jul after 27.3 °C 36 % 36 km/h 0.0 mm High 29
22 Jul after 28.7 °C 51 % 49 km/h 0.7 mm Moderate 18
23 Jul after 32.6 °C 31 % 34 km/h 0.6 mm High 28
24 Jul after 26.2 °C 41 % 38 km/h 0.3 mm High 28

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 6 Jul 2017
After · 21 Jul 2017

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 11 July 2017 the air beside the fire reached 36 µg/m³ of PM2.5. That day averaged 24: 1.6 times the WHO daily guideline (15).

PM2.5 peak36 µg/m³
Days over the guideline3 days
PM1043 µg/m³
11121314151617
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 9Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Algeria ›

Frequently asked questions

How long did the Ouled Rabah fire last?
Copernicus dates it between 13 July 2017 and 14 July 2017: 2 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 465 hectares (4.6 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Ouled Rabah (466 ha, 6.0 %).
Did the fire reach a town?
The closest fire to a town centre came within 1.5 km of Ouled Rabah. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 31.2 °C, humidity dropped to 33 % and gusts hit 35 km/h. The fire danger index (FWI) reached 32, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Algeria (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 14 · 1021

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 14 · 1021.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 9 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution-ShareAlike 2.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.