Skip to content
worldfires
HR · Croatia · →

Općina Orebić fire, August 2026 Općina Orebić

Out · last detection 15 Aug 2026, 00:16 UTC

The fire started on 14 August 2026 in Općina Orebić, Croatia, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 291 hectares from satellite imagery, spread across a single municipality.

It is the 12th largest in Dubrovnik-Neretva since 2016 (of 27 with a page). Number 10 in Croatia in 2026, of 25.

The power measured by the satellite is low (11.4 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
291ha
Copernicus perimeter
Duration
≈ 2days
14 Aug 2026 – 15 Aug 2026
Municipalities hit
1
municipalities
Started on
14 Aug
2026
Heat detections
3
in a single hotspot: 11 MW
Danger at start
38
High · FWI index
Average daily power
10MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 14 Aug15 Aug
15 Aug 2026

How it evolved, day by day

14 Aug 2026 · 20 MW · 2 15 Aug 2026 · 1 MW · 1
14 Aug 15 Aug

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

33°high
28km/h · peak gust
27%lowest humidity

It had gone 17 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Općina Orebić where it started
    291 ha reached on 14 Aug
    2.2 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Agricultural areas76 %
  • Scrub and transitional woodland21 %
  • Other natural land2.8 %

Natura 2000 protected area affected: 100 %

Natura 2000 sites (European Environment Agency, 2024 release) crossed by the perimeter.

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
14 Aug 33.3 °C 27 % 28 km/h 0.0 mm High 38
15 Aug 32.2 °C 37 % 27 km/h 0.0 mm High 32
16 Aug after 31.8 °C 42 % 30 km/h 0.0 mm High 30
17 Aug after 31.8 °C 43 % 28 km/h 0.0 mm High 30
18 Aug after 30.4 °C 42 % 24 km/h 0.0 mm High 26
19 Aug after 32.2 °C 36 % 27 km/h 0.0 mm High 28
20 Aug after 33.1 °C 34 % 36 km/h 0.0 mm High 34
21 Aug after 32.6 °C 45 % 38 km/h 0.0 mm High 33
22 Aug after 33.3 °C 34 % 33 km/h 0.0 mm High 34
23 Aug after 32.8 °C 31 % 31 km/h 0.0 mm High 35
24 Aug after 32.2 °C 32 % 31 km/h 0.0 mm High 33
25 Aug after 30.6 °C 40 % 41 km/h 0.1 mm High 35

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 7 Aug 2026
After · 22 Aug 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 17 August 2026 the air beside the fire reached 23 µg/m³ of PM2.5. That day averaged 18: 1.2 times the WHO daily guideline (15).

PM2.5 peak23 µg/m³
Days over the guideline3 days
PM1031 µg/m³
Optical depth0.39
121314151617
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 3Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Croatia ›

Frequently asked questions

How long did the Općina Orebić fire last?
The official perimeter only gives the start date (14 August 2026). The end comes from the heat detections inside the perimeter: it burned until 15 August 2026 (2 days from 14 August 2026), the last day with detections before more than 10 days in a row without any, so it is approximate.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 291 hectares (2.9 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Općina Orebić (291 ha, 2.2 %).
What was the weather like?
During the fire the temperature reached 33.3 °C, humidity dropped to 27 % and gusts hit 28 km/h. The fire danger index (FWI) reached 38, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Croatia (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 193 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 193.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • The official perimeter has no end date: the end is the last day with VIIRS detections inside the perimeter before a gap of more than 10 days (150 days at most), so it is approximate. 3 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution-ShareAlike 2.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.