Skip to content
worldfires
UA · Ukraine · →

Oleshky fire, March 2026 Олешківський район · Oleshky

Out · last detection 23 Mar 2026, 11:55 UTC

The fire started on 13 March 2026 in Oleshky, Ukraine, and satellites saw it burning for 11 days. Copernicus mapped a burnt perimeter of 117 hectares from satellite imagery, spread across a single municipality.

It is the 978th largest in Kherson Oblast since 2016 (of 1103 with a page). Number 823 in Ukraine in 2026, of 984.

The power measured by the satellite is low (18.2 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
117ha
Copernicus perimeter
Duration
≈ 11days
13 Mar 2026 – 23 Mar 2026
Municipalities hit
1
districts
Started on
13 Mar
2026
Heat detections
8
in a single hotspot: 18 MW
Danger at start
6
Low · FWI index
Average daily power
37MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 13 Mar23 Mar
23 Mar 2026

How it evolved, day by day

13 Mar 2026 · 61 MW · 6 23 Mar 2026 · 13 MW · 2
13 Mar 23 Mar

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

15°high
36km/h · peak gust
32%lowest humidity

It had gone 16 days without rain (1 mm or more) when it started.

This area had burned before

79% of the perimeter overlaps earlier fires recorded since 2016: 24 ha in 2022, 13 ha in 2023, 80 ha in 2025. Part of it burned more than once, so the yearly figures add up to more than the 92 ha that had burned before.

What happened to each town

  1. Oleshky Олешківський район 70,367 inhabitants · 24.2 km from the centre where it started
    117 ha reached on 13 Mar
    0.1 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land96 %
  • Mixed forest4.3 %

Land cover inside the perimeter as reported by Copernicus EFFIS (outside the Corine Land Cover area).

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
13 Mar 14.9 °C 32 % 36 km/h 0.0 mm Low 6
14 Mar 13.6 °C 40 % 45 km/h 0.0 mm Low 8
15 Mar 12.9 °C 38 % 51 km/h 0.0 mm Low 9
16 Mar 12.4 °C 39 % 36 km/h 0.0 mm Low 7
17 Mar 10.7 °C 53 % 28 km/h 0.0 mm Very low 5
18 Mar 9.0 °C 54 % 29 km/h 0.1 mm Very low 5
19 Mar 9.1 °C 61 % 35 km/h 0.2 mm Very low 5
20 Mar 11.8 °C 60 % 47 km/h 0.0 mm Low 6
21 Mar 11.6 °C 55 % 44 km/h 0.3 mm Low 6
22 Mar 12.1 °C 44 % 38 km/h 0.4 mm Low 6
23 Mar 14.7 °C 40 % 38 km/h 0.0 mm Low 7

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 6 Mar 2026
After · 30 Mar 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 15 March 2026 the air beside the fire reached 15 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak15 µg/m³
Days over the guideline0 days
PM1048 µg/m³
Optical depth0.33
111213141516
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 8Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Ukraine ›

Frequently asked questions

How long did the Oleshky fire last?
The official perimeter only gives the start date (13 March 2026). The end comes from the heat detections inside the perimeter: it burned until 23 March 2026 (11 days from 13 March 2026), the last day with detections before more than 10 days in a row without any, so it is approximate.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 117 hectares (1.2 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Oleshky (117 ha, 0.1 %).
Did the fire reach a town?
The fire started in Oleshky and came within 24.2 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 14.9 °C, humidity dropped to 32 % and gusts hit 36 km/h. The fire danger index (FWI) reached 6, class Low.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Ukraine (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 101 · 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 101 · 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • The official perimeter has no end date: the end is the last day with VIIRS detections inside the perimeter before a gap of more than 10 days (150 days at most), so it is approximate. 8 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Public Domain). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.