Skip to content
worldfires
ID · Indonesia · –

Ogan Komering Ilir fire, 3 September 2019 Ogan Komering Ilir

Out · last measured on 27 Sept 2019

The fire started on 3 September 2019 in Ogan Komering Ilir, Indonesia, and satellites saw it burning for 25 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 3,401 hectares from heat detections, spread across a single municipality.

It is the 34th largest in South Sumatra since 2016 (of 116 with a page). Number 133 in Indonesia in 2019, of 409.

We have the GWIS perimeter for this fire, but the VIIRS sensors did not capture it in enough detail: no day-by-day evolution, but the split by municipality is there.

Burnt area
3,401ha
GWIS perimeter (Copernicus)
Duration
25days
3 Sept 2019 – 27 Sept 2019
Municipalities hit
1
regencies
Started on
3 Sept
2019
Danger at start
20
Moderate · FWI index

Where it burned

The weather it burned in

34°high
46km/h · peak gust
38%lowest humidity

It had gone 5 days without rain (1 mm or more) when it started. Rain came after the fire: 3.6 mm on 3 Oct.

This area had burned before

28% of the perimeter overlaps earlier fires recorded since 2016: 1,023 ha in 2018. Part of it burned more than once, so the yearly figures add up to more than the 962 ha that had burned before.

How big is it?

10 km
It burned the equivalent of 2.1% of the area of London (34 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Ogan Komering Ilir where it started
    3,749 ha
    0.2 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area0.94 ha
Residents≈ 150

Inside the perimeter there were about 0.94 hectares of built-up land and about 150 residents (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
3 Sept 32.3 °C 55 % 35 km/h 0.1 mm Moderate 20
4 Sept 33.0 °C 49 % 35 km/h 0.0 mm High 21
5 Sept 32.9 °C 47 % 33 km/h 0.0 mm Moderate 20
6 Sept 32.0 °C 52 % 35 km/h 0.0 mm High 22
7 Sept 32.1 °C 50 % 37 km/h 0.0 mm High 24
8 Sept 31.9 °C 53 % 41 km/h 0.0 mm High 26
9 Sept 32.3 °C 51 % 34 km/h 0.0 mm High 25
10 Sept 33.8 °C 40 % 39 km/h 0.0 mm High 28
11 Sept 32.6 °C 46 % 45 km/h 0.0 mm High 31
12 Sept 33.4 °C 38 % 33 km/h 0.0 mm High 26
13 Sept 32.6 °C 46 % 35 km/h 0.0 mm High 24
14 Sept 32.6 °C 40 % 38 km/h 0.0 mm High 30
15 Sept 32.4 °C 43 % 33 km/h 0.0 mm High 28
16 Sept 32.8 °C 44 % 38 km/h 0.0 mm High 32
17 Sept 32.8 °C 48 % 39 km/h 0.0 mm High 33
18 Sept 33.3 °C 51 % 44 km/h 0.0 mm High 34
19 Sept 32.6 °C 54 % 39 km/h 0.5 mm High 29
20 Sept 33.0 °C 47 % 36 km/h 0.0 mm High 29
21 Sept 33.3 °C 46 % 38 km/h 0.0 mm High 32
22 Sept 32.2 °C 50 % 39 km/h 0.0 mm High 32
23 Sept 31.7 °C 60 % 45 km/h 0.7 mm High 29
24 Sept 29.9 °C 68 % 35 km/h 14.5 mm Very low 0
25 Sept 32.9 °C 56 % 46 km/h 2.1 mm Very low 5
26 Sept 33.0 °C 59 % 45 km/h 1.4 mm Low 10
27 Sept 32.3 °C 55 % 38 km/h 0.8 mm Moderate 15
28 Sept after 33.2 °C 45 % 42 km/h 0.0 mm High 25
29 Sept after 33.5 °C 52 % 39 km/h 0.7 mm High 22
30 Sept after 33.3 °C 46 % 38 km/h 0.1 mm High 27
1 Oct after 33.5 °C 45 % 42 km/h 0.0 mm High 29
2 Oct after 32.4 °C 49 % 43 km/h 0.1 mm High 30
3 Oct after 31.6 °C 61 % 39 km/h 3.6 mm Low 8

Its twins: fires that started in the same weather

It started with an FWI of 19.9, a minimum humidity of 55% and 5 days without rain. Fires in the area that started in weather like this since 2017: 28.

FWI at the start 19.9
Minimum humidity 55 %
Days without rain 5
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Ogan Komering Ilir fire, October 2019
3,139 ha 18 days FWI 18.9 Min. humidity 56 % 51 km away, in 2019

First rain (1 mm or more) after it ended: 5.1 mm on 1 Nov.

What happened to them

8 days
median duration
2,285 ha
median area
100 %
went past 1,000 ha
3.7 mm
rain at the end (median; 27 of 28 had it)

It burned an area similar to its twins (3,401 ha against a median of 2,285 ha) and lasted 25 days, against 8 days.

In 1 of 28, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.7 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

3.6 mmfirst rain
3 Oct6 days after it ended
46km/h · max. gust

It was considered over on 27 Sept, and on 3 Oct 3.6 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 27 of 28, with a median of 3.7 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2017.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 27 Aug 2019
After · 4 Oct 2019

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Other fires nearby

All fires in Indonesia

Frequently asked questions

How long did the Ogan Komering Ilir fire last?
GWIS (Copernicus) dates it between 3 September 2019 and 27 September 2019: 25 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 3,401 hectares (34.0 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Ogan Komering Ilir (3,749 ha, 0.2 %).
What was the weather like?
During the fire the temperature reached 33.8 °C, humidity dropped to 38 % and gusts hit 46 km/h. The fire danger index (FWI) reached 34, class High.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Indonesia (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2017 with a similar FWI, humidity and dry spell: 28. Their median duration was 8 days and their median area 2,285 ha; 100 % went past 1,000 ha. In 1 of 28, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.7 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings

Satellite cross-check

History of this page · 1 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Area: 3,721 → 3,401 ha.

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery; 2 polygons grouped in this page.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. No Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.