Skip to content
worldfires
UA · Ukraine · →

Novomoskovsk fire, October 2026 Новомосковський район · Novomoskovsk, Zachepylivka

Out · last detection 30 Oct 2026, 11:19 UTC

Satellites first detected fire on 25 October 2026 in Novomoskovsk, Ukraine. It was active for 6 days, with 19 heat detections and an area with fire of about 252 hectares rebuilt from them, spread across 2 municipalities.

The power measured by the satellite is low (18.5 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…

Copernicus has not yet published the burnt perimeter, which takes a few days to measure on satellite imagery. For now the area is the one rebuilt from heat detections (about 14 hectares per pixel). When the perimeter arrives, this page picks it up on its own and keeps the same address.

Area with fire
≈ 252ha
rebuilt from hotspots, no official perimeter yet
Duration
6days
25 Oct 2026 – 30 Oct 2026
Municipalities hit
2
districts
Started on
25 Oct
2026
Heat detections
19
in a single hotspot: 19 MW
Danger at start
5
Low · FWI index
Average daily power
34MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 25 Oct30 Oct
30 Oct 2026

How it evolved, day by day

25 Oct 2026 · 3 MW · 1 26 Oct 2026 · 43 MW · 4 27 Oct 2026 · 0 MW · 0 28 Oct 2026 · 30 MW · 5 29 Oct 2026 · 0 MW · 0 30 Oct 2026 · 63 MW · 7
25 Oct 26 Oct 27 Oct 28 Oct 29 Oct 30 Oct

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

16°high
45km/h · peak gust
41%lowest humidity

It had gone 6 days without rain (1 mm or more) when it started. Rain came after the fire: 11.3 mm on 31 Oct.

What happened to each town

  1. Novomoskovsk Новомосковський район 73,224 inhabitants · 35.9 km from the centre where it started
    210 ha reached on 25 Oct
    0.1 %
  2. Zachepylivka Зачепилівський район 21.3 km from the centre
    42 ha reached on 30 Oct
    0.0 %

Area with fire inside each municipality, rebuilt from heat detections (about 14 hectares per VIIRS pixel). An estimate until the official perimeter arrives. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · forecast models, provisional until the ERA5 reanalysis arrives

Day High Min. humidity Peak gust Rain Danger (FWI)
25 Oct 16.2 °C 50 % 41 km/h 0.0 mm Low 5
26 Oct 14.0 °C 51 % 40 km/h 0.0 mm Low 6
27 Oct 14.9 °C 50 % 40 km/h 0.0 mm Low 6
28 Oct 14.6 °C 41 % 41 km/h 0.6 mm Low 6
29 Oct 14.8 °C 42 % 45 km/h 0.0 mm Low 8
30 Oct 15.0 °C 45 % 44 km/h 0.0 mm Low 8
31 Oct after 11.6 °C 45 % 31 km/h 11.3 mm Very low 0

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 18 Oct 2026
After · 3 Nov 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 26 October 2026 the air beside the fire reached 27 µg/m³ of PM2.5. That day averaged 21: 1.4 times the WHO daily guideline (15).

PM2.5 peak27 µg/m³
Days over the guideline3 days
PM1058 µg/m³
Optical depth0.38
2324252627282930
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 19Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Ukraine ›

Frequently asked questions

How long did the Novomoskovsk fire last?
According to the heat detections seen by satellite, it burned from 25 October 2026 to 30 October 2026 (6 days between the first and the last detection). There is no perimeter yet to date it.
How much area did it burn?
There is no official perimeter yet. Heat detections rebuild about 252 hectares with fire (2.5 km²); Copernicus will publish the measured figure within days.
Which municipalities burned?
The fire entered 2 municipalities: Novomoskovsk (210 ha, 0.1 %); Zachepylivka (42 ha, 0.0 %).
Is the Novomoskovsk fire still active?
No fire detections since 30 Oct 2026, 11:19 UTC. A lack of detections is not an official extinction.
Did the fire reach a town?
The fire came within 21.3 km of the centre of Zachepylivka, the closest of the areas it touched. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 16.2 °C, humidity dropped to 41 % and gusts hit 45 km/h. The fire danger index (FWI) reached 8, class Low.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Ukraine (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 101 · 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page · 1 Changes in area, dates, name, official record or merged pages, compared every night since 31 October 2026.
  1. Page published (≈ 252 ha).

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 101 · 112.

How we know this
  • No perimeter yet: the area (≈ 252 ha) is estimated by counting VIIRS pixels with fire, about 14 ha each.
  • Dates of the first and last VIIRS detection of the cluster. 19 Suomi-NPP VIIRS detections on those dates.
  • Weather: ECMWF IFS model, provisional until the ERA5 reanalysis arrives.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Public Domain). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.