Skip to content
worldfires
GM · Gambia · –

Niamina East fire, March 2017 Niamina East, Lower Fuladu West

Out · last detection

The fire started on in Niamina East, Gambia, and satellites saw it burning for 2 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 1,182 hectares from heat detections, spread across 2 municipalities.

It is number 9 by size of the 14 fires with a page that started in Janjanbureh since 2016. Number 16 in Gambia in 2017, of 22.

The power measured by the satellite is low (26.3 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
1,182ha
GWIS perimeter (Copernicus)
Duration
2days
17 Mar 2017 – 18 Mar 2017
Municipalities hit
2
districts
Started on
17 Mar
2017
Heat detections
30
in a single hotspot: 26 MW
Danger at start
73
Very extreme · FWI index
Average daily power
91MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 17 Mar18 Mar

How it evolved, day by day

18 Mar 2017 · 91 MW · 30

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

40°high
45km/h · peak gust
15%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

How big is it?

10 km
It burned the equivalent of 0.7% of the area of London (12 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Niamina East where it started
    1,180 ha reached on 18 Mar
    3.2 %
  2. 9 ha
    0.0 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2015
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2015, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with Extreme FWI: 82 % of the area in Gambia 60 days without rain: 92 % of the area in Gambia

Day High Min. humidity Peak gust Rain Danger (FWI)
17 Mar 39.9 °C 15 % 45 km/h 0.0 mm Very extreme 73
18 Mar 36.1 °C 19 % 37 km/h 0.0 mm Extreme 59
19 Mar after 35.5 °C 22 % 33 km/h 0.0 mm Extreme 57
20 Mar after 37.1 °C 18 % 34 km/h 0.0 mm Extreme 56
21 Mar after 39.4 °C 14 % 36 km/h 0.0 mm Extreme 70
22 Mar after 40.5 °C 13 % 30 km/h 0.0 mm Extreme 62
23 Mar after 39.0 °C 15 % 32 km/h 0.0 mm Extreme 63
24 Mar after 39.3 °C 15 % 28 km/h 0.0 mm Extreme 60
25 Mar after 38.6 °C 21 % 32 km/h 0.0 mm Extreme 57
26 Mar after 39.9 °C 20 % 34 km/h 0.0 mm Extreme 62
27 Mar after 41.9 °C 13 % 44 km/h 0.0 mm Very extreme 76
28 Mar after 42.8 °C 15 % 43 km/h 0.0 mm Extreme 69

Its twins: fires that started in the same weather

It started with an FWI of 73.0, a minimum humidity of 15% and more than two months without rain. Fires in the area that started in weather like this since 2016: 41.

FWI at the start 73.0
Minimum humidity 15 %
Days without rain 60+
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Diendé fire, February 2019
5,940 ha 12 days FWI 72.9 Min. humidity 15 % 87 km away, in 2019

First rain (1 mm or more) after it ended: none in the following ten days.

What happened to them

5 days
median duration
2,213 ha
median area
100 %
went past 1,000 ha
—
rain at the end (median; 0 of 41 had it)

It stayed below its twins: 1,182 ha against a median of 2,213 ha. It lasted 2 days, against 5 days.

In none of them did 1 mm fall in the ten days after the end: they all went out without rain.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
45km/h · max. gust

It was considered over on 18 Mar, and not even 1 mm fell in the following ten days: it went out without rain. None of its 41 twins had rain when they ended.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 10 Mar 2017
After · 25 Mar 2017

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 30Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Gambia

Frequently asked questions

How long did the Niamina East fire last?
GWIS (Copernicus) dates it between 17 March 2017 and 18 March 2017: 2 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 1,182 hectares (11.8 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Niamina East (1,180 ha, 3.2 %); Lower Fuladu West (9 ha, 0.0 %).
What was the weather like?
During the fire the temperature reached 39.9 °C, humidity dropped to 15 % and gusts hit 45 km/h. The fire danger index (FWI) reached 73, class Very extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Gambia (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 41. Their median duration was 5 days and their median area 2,213 ha; 100 % went past 1,000 ha. In none of them did 1 mm fall in the ten days after the end: they all went out without rain.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 30 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2015, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.