Skip to content
worldfires
NG · Nigeria · →

Nganzai fire, 2 November 2020 Nganzai

Out · last detection 6 Nov 2020, 11:45 UTC

The fire started on 2 November 2020 in Nganzai, Nigeria, and satellites saw it burning for 5 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 2,294 hectares from heat detections, spread across a single municipality.

It is the 346th largest in Borno since 2016 (of 466 with a page). Number 108 in Nigeria in 2020, of 150.

The power measured by the satellite is low (22.1 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
2,294ha
GWIS perimeter (Copernicus)
Duration
5days
2 Nov 2020 – 6 Nov 2020
Municipalities hit
1
local government areas
Started on
2 Nov
2020
Heat detections
64
in a single hotspot: 22 MW
Average daily power
138MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 2 Nov6 Nov
6 Nov 2020

How it evolved, day by day

3 Nov 2020 · 223 MW · 17 4 Nov 2020 · 29 MW · 9 5 Nov 2020 · 288 MW · 32 6 Nov 2020 · 12 MW · 6
3 Nov 4 Nov 5 Nov 6 Nov

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

This area had burned before

69% of the perimeter overlaps earlier fires recorded since 2016: 888 ha in 2016, 1,115 ha in 2017. Part of it burned more than once, so the yearly figures add up to more than the 1,585 ha that had burned before.

How big is it?

10 km
It burned the equivalent of 1.4% of the area of London (23 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Nganzai where it started
    2,307 ha reached on 3 Nov
    1.1 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area1.1 ha
Residents≈ 350

Inside the perimeter there were about 1.1 hectares of built-up land and about 350 residents (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 26 Oct 2020
After · 13 Nov 2020

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 64Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Nigeria ›

Frequently asked questions

How long did the Nganzai fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 2 November 2020 to 6 November 2020 (5 days). The perimeter dates it from 3 November 2020 to 5 November 2020.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 2,294 hectares (22.9 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Nganzai (2,307 ha, 1.1 %).
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Nigeria (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page · 2 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Last day with fire: 5 November 2020 → 6 November 2020.
  2. Start date: 3 November 2020 → 2 November 2020.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 3 November 2020 to 5 November 2020. 64 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology ›

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.