Skip to content
worldfires
BF · Burkina Faso · →

Nako fire, October 2026 Bousséra, Nako, Malba

Dying down · last detection 2 Nov 2026, 13:52 UTC

Satellites first detected fire on 23 October 2026 in Nako, Burkina Faso. It has been active for 10 days, with 87 heat detections and an area with fire of about 1,120 hectares rebuilt from them, spread across 5 municipalities.

Compare with…

Suggestions: Bouroum-Bouroum · 2026

GWIS (Copernicus) has not yet published the perimeter of this fire. It rebuilds it from hotspots, which can take several days, and it does not always arrive. For now the area is the one rebuilt from heat detections (about 14 hectares per pixel). If the perimeter arrives, this page picks it up on its own and keeps the same address.

Is it still active?

No detections since 2 Nov 2026, 13:52 UTC. That usually means no flame is visible from space any more, although hotspots may remain. Satellites pass a few times a day and cloud or smoke can hide the fire: a lack of detections is not an official extinction. Each country’s emergency service declares a fire contained or out.

Area with fire
≈ 1,120ha
rebuilt from hotspots, no official perimeter yet
Duration
10days
23 Oct 2026 – 1 Nov 2026
Municipalities hit
5
communes
Started on
23 Oct
2026
Heat detections
87
in a single hotspot: 51 MW
Danger at start
19
Moderate · FWI index
Average daily power
80MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 23 Oct1 Nov
2 Nov 2026

How it evolved, day by day

23 Oct 2026 · 51 MW · 14 24 Oct 2026 · 15 MW · 3 25 Oct 2026 · 53 MW · 13 26 Oct 2026 · 30 MW · 7 27 Oct 2026 · 64 MW · 13 28 Oct 2026 · 123 MW · 14 29 Oct 2026 · 96 MW · 10 30 Oct 2026 · 4 MW · 1 31 Oct 2026 · 151 MW · 10 1 Nov 2026 · 91 MW · 14 2 Nov 2026 · 197 MW · 24
23 Oct 25 Oct 27 Oct 29 Oct 31 Oct 2 Nov

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

36°high
35km/h · peak gust
27%lowest humidity

It had gone 3 days without rain (1 mm or more) when it started.

What happened to each town

  1. Bousséra where it started
    518 ha reached on 23 Oct
    1.2 %
  2. 434 ha reached on 23 Oct
    0.6 %
  3. 154 ha reached on 23 Oct
    0.8 %
  4. 14 ha reached on 23 Oct
    0.0 %
  5. 0 ha reached on 30 Oct
    0.0 %

Area with fire inside each municipality, rebuilt from heat detections (about 14 hectares per VIIRS pixel). An estimate until the official perimeter arrives. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · forecast models, provisional until the ERA5 reanalysis arrives

Day High Min. humidity Peak gust Rain Danger (FWI)
23 Oct 36.4 °C 30 % 34 km/h 0.0 mm Moderate 19
24 Oct 36.0 °C 27 % 22 km/h 0.0 mm Moderate 18
25 Oct 36.2 °C 28 % 20 km/h 0.0 mm Moderate 18
26 Oct 35.8 °C 30 % 21 km/h 0.0 mm Moderate 19
27 Oct 34.9 °C 37 % 27 km/h 0.4 mm Moderate 21
28 Oct 34.3 °C 41 % 22 km/h 1.4 mm Moderate 12
29 Oct 35.0 °C 42 % 22 km/h 0.5 mm Moderate 15
30 Oct 35.3 °C 38 % 35 km/h 0.7 mm Moderate 18
31 Oct 35.7 °C 32 % 23 km/h 0.0 mm Moderate 21
1 Nov 36.5 °C 30 % 23 km/h 1.3 mm Moderate 17
2 Nov after 37.2 °C 31 % 27 km/h 0.5 mm High 22

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 16 Oct 2026
After · 2 Nov 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 26 October 2026 the air beside the fire reached 38 µg/m³ of PM2.5. That day averaged 35: 2.3 times the WHO daily guideline (15).

PM2.5 peak38 µg/m³
Days over the guideline10 days
PM10103 µg/m³
Optical depth0.45
171819202122232425262728
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 87Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Burkina Faso ›

Frequently asked questions

How long did the Nako fire last?
According to the heat detections seen by satellite, it burned from 23 October 2026 to 1 November 2026 (10 days between the first and the last detection). There is no perimeter yet to date it.
How much area did it burn?
There is no perimeter yet. Heat detections rebuild about 1,120 hectares with fire (11.2 km²), a rough figure; GWIS will give its own when it publishes the perimeter, which can take several days.
Which municipalities burned?
The fire entered 5 municipalities: Bousséra (518 ha, 1.2 %); Nako (434 ha, 0.6 %); Malba (154 ha, 0.8 %); Gaoua (14 ha, 0.0 %); Bouroum-Bouroum (0 ha, 0.0 %).
Is the Nako fire still active?
No fire detections since 2 Nov 2026, 13:52 UTC. A lack of detections is not an official extinction.
What was the weather like?
During the fire the temperature reached 36.5 °C, humidity dropped to 27 % and gusts hit 35 km/h. The fire danger index (FWI) reached 21, class Moderate.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Burkina Faso (OCHA COD-AB). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

History of this page · 9 Changes in area, dates, name, official record or merged pages, compared every night since 29 October 2026.
  1. Area: ≈ 1,148 → ≈ 1,120 ha.
  2. Start date: 22 October 2026 → 23 October 2026.
  3. Area: ≈ 1,260 → ≈ 1,148 ha.
  4. Start date: 21 October 2026 → 22 October 2026.
  5. Area: ≈ 1,148 → ≈ 1,260 ha.
  6. Start date: 20 October 2026 → 21 October 2026.
  7. Area: ≈ 1,064 → ≈ 1,148 ha.
  8. Start date: 19 October 2026 → 20 October 2026.
  9. Page published (≈ 1,064 ha).

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

How we know this
  • No perimeter yet: the area (≈ 1,120 ha) is estimated by counting VIIRS pixels with fire, about 14 ha each.
  • Dates of the first and last VIIRS detection of the cluster. 87 Suomi-NPP VIIRS detections on those dates.
  • Weather: ECMWF IFS model, provisional until the ERA5 reanalysis arrives.

How we build fire pages: methodology ›

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from OCHA COD-AB (Institut Geographique Burkina (IGB)) (Creative Commons Attribution for Intergovernmental Organisations (CC BY-IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.