Skip to content
worldfires
ZM · Zambia · –

Mumbwa fire, 23 July 2016 Mumbwa, Chibombo

Out · last detection 14 Aug 2016, 11:07 UTC

The fire started on 23 July 2016 in Mumbwa, Zambia, and satellites saw it burning for 23 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 4,143 hectares from heat detections, spread across 2 municipalities.

It is the 150th largest in Central since 2016 (of 258 with a page). Number 133 in Zambia in 2016, of 246.

Compare with…

Suggestions: Mumbwa · 2020Mumbwa · 2023

Burnt area
4,143ha
GWIS perimeter (Copernicus)
Duration
23days
23 Jul 2016 – 14 Aug 2016
Municipalities hit
2
districts
Started on
23 Jul
2016
Heat detections
137
in a single hotspot: 86 MW
Danger at start
36
High · FWI index
Average daily power
81MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 23 Jul14 Aug
14 Aug 2016

How it evolved, day by day

23 Jul 2016 · 175 MW · 10 24 Jul 2016 · 62 MW · 6 26 Jul 2016 · 4 MW · 1 30 Jul 2016 · 5 MW · 6 1 Aug 2016 · 166 MW · 19 2 Aug 2016 · 19 MW · 5 3 Aug 2016 · 242 MW · 26 4 Aug 2016 · 307 MW · 23 5 Aug 2016 · 96 MW · 15 6 Aug 2016 · 137 MW · 8 7 Aug 2016 · 10 MW · 2 8 Aug 2016 · 30 MW · 5 9 Aug 2016 · 3 MW · 3 10 Aug 2016 · 8 MW · 2 13 Aug 2016 · 25 MW · 4 14 Aug 2016 · 10 MW · 2
23 Jul 1 Aug 4 Aug 9 Aug

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

28°high
48km/h · peak gust
22%lowest humidity

It had gone 55 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

How big is it?

10 km
It burned the equivalent of 2.6% of the area of London (41 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Mumbwa where it started
    3,967 ha
    0.2 %
  2. 196 ha
    0.0 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2015
Built-up area4.6 ha
Residents≈ 350

Inside the perimeter there were about 4.6 hectares of built-up land and about 350 residents (GHSL 2015, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
23 Jul 24.8 °C 25 % 29 km/h 0.0 mm High 36
24 Jul 26.6 °C 27 % 35 km/h 0.0 mm Very high 38
25 Jul 26.2 °C 32 % 37 km/h 0.0 mm Very high 40
26 Jul 28.0 °C 31 % 37 km/h 0.0 mm Very high 41
27 Jul 27.3 °C 35 % 34 km/h 0.0 mm High 35
28 Jul 28.3 °C 29 % 29 km/h 0.0 mm High 33
29 Jul 28.4 °C 24 % 35 km/h 0.0 mm Very high 44
30 Jul 28.4 °C 27 % 28 km/h 0.0 mm Very high 39
31 Jul 27.1 °C 30 % 39 km/h 0.0 mm Very high 46
1 Aug 27.7 °C 27 % 31 km/h 0.0 mm Very high 40
2 Aug 28.1 °C 22 % 35 km/h 0.0 mm Very high 43
3 Aug 26.6 °C 31 % 31 km/h 0.0 mm High 32
4 Aug 26.9 °C 30 % 35 km/h 0.0 mm Very high 42
5 Aug 24.5 °C 34 % 47 km/h 0.0 mm Very high 47
6 Aug 23.0 °C 37 % 48 km/h 0.0 mm Very high 43
7 Aug 23.3 °C 28 % 39 km/h 0.0 mm Very high 41
8 Aug 24.3 °C 34 % 36 km/h 0.0 mm High 33
9 Aug 24.6 °C 32 % 46 km/h 0.0 mm Very high 39
10 Aug 22.4 °C 48 % 48 km/h 0.2 mm High 34
11 Aug 24.4 °C 38 % 41 km/h 0.0 mm High 36
12 Aug 25.5 °C 25 % 37 km/h 0.0 mm Very high 44
13 Aug 25.9 °C 27 % 32 km/h 0.0 mm High 36
14 Aug 27.1 °C 32 % 30 km/h 0.0 mm High 36
15 Aug after 27.6 °C 33 % 40 km/h 0.0 mm Very high 43
16 Aug after 26.3 °C 32 % 48 km/h 0.0 mm Extreme 52
17 Aug after 24.3 °C 42 % 53 km/h 0.0 mm Extreme 52
18 Aug after 25.0 °C 38 % 44 km/h 0.0 mm Very high 42
19 Aug after 26.6 °C 32 % 39 km/h 0.0 mm High 37
20 Aug after 28.3 °C 35 % 28 km/h 0.0 mm High 30
21 Aug after 29.9 °C 27 % 30 km/h 0.0 mm High 36
22 Aug after 30.2 °C 25 % 34 km/h 0.0 mm Very high 44
23 Aug after 30.0 °C 21 % 52 km/h 0.0 mm Extreme 66
24 Aug after 24.4 °C 38 % 52 km/h 0.0 mm Very high 45

Its twins: fires that started in the same weather

It started with an FWI of 36.3, a minimum humidity of 25% and 55 days without rain. Fires in the area that started in weather like this since 2016: 17.

FWI at the start 36.3
Minimum humidity 25 %
Days without rain 55
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Mumbwa fire, June 2020
3,341 ha 1 day FWI 36.5 Min. humidity 25 % 119 km away, in 2020

First rain (1 mm or more) after it ended: none in the following ten days.

What happened to them

5 days
median duration
4,218 ha
median area
0 %
went past 10,000 ha
—
rain at the end (median; 0 of 17 had it)

It burned an area similar to its twins (4,143 ha against a median of 4,218 ha) and lasted 23 days, against 5 days.

In none of them did 1 mm fall in the ten days after the end: they all went out without rain.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
48km/h · max. gust

It was considered over on 14 Aug, and not even 1 mm fell in the following ten days: it went out without rain. None of its 17 twins had rain when they ended.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 16 Jul 2016
After · 21 Aug 2016

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 137Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Frequently asked questions

How long did the Mumbwa fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 23 July 2016 to 14 August 2016 (23 days). The perimeter dates it from 30 July 2016 to 7 August 2016.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 4,143 hectares (41.4 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Mumbwa (3,967 ha, 0.2 %); Chibombo (196 ha, 0.0 %).
What was the weather like?
During the fire the temperature reached 28.4 °C, humidity dropped to 22 % and gusts hit 48 km/h. The fire danger index (FWI) reached 47, class Very high.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Zambia (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 17. Their median duration was 5 days and their median area 4,218 ha; 0 % went past 10,000 ha. In none of them did 1 mm fall in the ten days after the end: they all went out without rain.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

History of this page · 2 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Last day with fire: 7 August 2016 → 14 August 2016.
  2. Start date: 30 July 2016 → 23 July 2016.

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 30 July 2016 to 7 August 2016. 137 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2015, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.